Lines Matching full:host
15 Maximum supported ACL size of data packets sent from the Host to the
17 The Host will segment the data transmitted to the Controller so that
19 In a combined build this value will be set in both the Host and the
21 In a Host-only build the Host will read the maximum ACL size supported
23 Host and the Controller.
24 The Host supports sending of larger L2CAP PDUs than the ACL size and
40 Number of outgoing ACL data buffers sent from the Host to the
42 Host can have queued in the Controller before waiting for the
43 to notify the Host that more packets can be queued with the Number of
45 The buffers are shared between all of the connections and the Host
62 the Host. This value does not include the HCI ACL header.
63 In a combined Host and Controller build the buffer sizes in both the
64 Host and the Controller will use this value for buffer sizes, and
65 therefore Controller to Host flow Controller is not needed.
66 In a Host only build with Controller to Host flow control enabled
67 the Host will inform the Controller about the maximum ACL data size it
68 can send by setting this value in the Host Buffer Size command.
69 If Controller to Host flow control is not enabled then the Controller
70 can assume the Host has infinite buffer size so this value should then
74 that the Controller will send to the Host.
75 The Host supports reassembling of L2CAP PDUs from ACL data packets,
103 Host.
104 In a combined Host and Controller build the buffers are shared and
105 therefore Controller to Host flow control is not needed.
106 In a Host only build with Controller to Host flow control enabled
107 the Host will inform the Controller about the maximum number of
108 buffers by setting this value in the Host Buffer Size command.
109 When Controller to Host flow control is not enabled the Controller
110 can assume that the Host has infinite amount of buffers.
121 This value is used by both the Host and the Controller for buffer
179 This value is used by both the Host and the Controller for buffer
190 Number of buffers available for outgoing HCI commands from the Host.
206 Host and/or Controller. This enables Set Version Information,
215 Host and/or Controller. This enables Write BD_ADDR, Read Build Info,
223 Host and/or Controller.
252 from the Host) for the NOP opcode to indicate that the Controller is
316 on the host side that can decode this protocol. Currently
335 on the host side that can decode this protocol. Currently