Lines Matching +full:push +full:- +full:pull

2 # SPDX-License-Identifier: Apache-2.0
7     use this node to route UART0 RX to pin 55 and enable the pull-up resistor
20       /* You can put this in places like a board-pinctrl.dtsi file in
24       /* include pre-defined combinations for the SoC variant used by the board */
25       #include <dt-bindings/pinctrl/gd32f450i(g-i-k)xx-pinctrl.h>
39             /* both pin 57 and 62 have pull-up enabled */
40             bias-pull-up;
53     pins, such as the 'bias-pull-up' property in group 2. Here is a list of
56     - drive-push-pull: Push-pull drive mode (default, not required).
57     - drive-open-drain: Open-drain drive mode.
58     - bias-disable: Disable pull-up/down (default, not required).
59     - bias-pull-up: Enable pull-up resistor.
60     - bias-pull-down: Enable pull-down resistor.
61     - drive-strength: Configure drive strength in mA (defaults to 6mA, IC default).
65     To link pin configurations with a device, use a pinctrl-N property for some
68        #include "board-pinctrl.dtsi"
71              pinctrl-0 = <&uart0_default>
72              pinctrl-names = "default";
75 compatible: "ti,cc32xx-pinctrl"
79 child-binding:
80   child-binding:
82       - name: pincfg-node.yaml
83         property-allowlist:
84           - drive-push-pull
85           - drive-open-drain
86           - bias-disable
87           - bias-pull-down
88           - bias-pull-up
89           - drive-strength
97           be defined using pre-defined macros or, alternatively, using the
100       drive-strength:
103           - 0
104           - 2
105           - 4
106           - 6
107           - 8
108           - 10
109           - 12
110           - 14