Lines Matching +full:push +full:- +full:pull

2 # SPDX-License-Identifier: Apache-2.0
12       compatible = "infineon,xmc4xxx-uart";
13       pinctrl-0 = <&uart_tx_p0_1_u1c1 &uart_rx_p0_0_u1c1>;
14       pinctrl-names = "default";
15       input-src = "DX0D";
19   pinctrl-0 is the phandle that stores the pin settings for two pins: &uart_tx_p0_1_u1c1
20   and &uart_rx_p0_0_u1c1. These nodes are pre-defined and their naming convention is designed
24   The pre-defined nodes only set the alternate function of the output pin. The
27   to the inherited property-allowlist list from pincfg-node.yaml).
31   #include <zephyr/dt-bindings/pinctrl/xmc4xxx-pinctrl.h>
35       drive-push-pull;
43   handled by the peripheral drivers. For example the &usic1ch1 node has input-src property for
44   this purpose. There are no pre-defined nodes for the input mux and this must be properly set
45   by the user. Refer to the peripheral .yaml file (i.e. infineon,xmc4xxx-uart.yaml) and
48 compatible: "infineon,xmc4xxx-pinctrl"
53   "#address-cells":
56   "#size-cells":
60 child-binding:
64     - name: pincfg-node.yaml
65       property-allowlist:
66         - bias-pull-down
67         - bias-pull-up
68         - drive-push-pull
69         - drive-open-drain
70         - output-high
71         - output-low
77         Alternate function is only set for output pins; It selects  ALT1-ALT4
80         input pin to use (For example see parameter input-src in infineon,xmc4xxx-uart.yaml).
84     drive-strength:
87         See xmc4_gpio.h. This only has an effect if the pin is in drive-push-pull mode.
91         - "strong-sharp-edge"
92         - "strong-medium-edge"
93         - "strong-soft-edge"
94         - "strong-slow-edge"
95         - "medium"
96         - "medium-unknown1-edge"
97         - "medium-unknown2-edge"
98         - "weak"
100     invert-input:
105       description: Pre-assigns hardware control of the pin to a certain peripheral.
109         - "disabled"
110         - "periph1"
111         - "periph2"