Lines Matching +full:push +full:- +full:pull

2 # SPDX-License-Identifier: Apache-2.0
7     use this node to route USART0 RX to pin PA10 and enable the pull-up resistor
20       /* You can put this in places like a board-pinctrl.dtsi file in
24       /* include pre-defined combinations for the SoC variant used by the board */
25       #include <dt-bindings/pinctrl/gd32f450i(g-i-k)xx-pinctrl.h>
39             /* both PA10 and PA12 have pull-up enabled */
40             bias-pull-up;
56     is used for low power states because it disconnects the pin pull-up/down
64     pins, such as the 'bias-pull-up' property in group 2. Here is a list of
67     - drive-push-pull: Push-pull drive mode (default, not required).
68     - drive-open-drain: Open-drain drive mode.
69     - bias-disable: Disable pull-up/down (default, not required).
70     - bias-pull-up: Enable pull-up resistor.
71     - bias-pull-down: Enable pull-down resistor.
72     - slew-rate: Set the maximum speed (and so the slew-rate) of the output
77     To link pin configurations with a device, use a pinctrl-N property for some
80        #include "board-pinctrl.dtsi"
83              pinctrl-0 = <&usart0_default>;
84              pinctrl-1 = <&usart0_sleep>;
85              pinctrl-names = "default", "sleep";
88 compatible: "gd,gd32-pinctrl-af"
90 include: gd,gd32-pinctrl-common.yaml
92 child-binding:
95   child-binding:
99       slew-rate:
101         default: "max-speed-2mhz"
103           - "max-speed-2mhz"
104           - "max-speed-25mhz"
105           - "max-speed-50mhz"
106           - "max-speed-200mhz"
109           slew rate of the output signal. Defaults to "max-speed-2mhz", the SoC