Lines Matching +full:disable +full:- +full:rx
3 # SPDX-License-Identifier: Apache-2.0
10 include: ethernet-controller.yaml
19 clock-frequency:
27 which it will be adjusted at run-time. Therefore, the value of this
29 respective GEM's TX clock - by default, this is the IO PLL.
31 mdc-divider:
42 init-mdio-phy:
45 Activates the management of a PHY associated with the controller in-
46 stance. If this parameter is activated at the board level, the de-
47 fault values of the associated parameters mdio-phy-address, phy-poll-
48 interval, link-speed and advertise-lower-link-speeds should be checked
51 mdio-phy-address:
56 instance. Set the address to 0 for auto-detection (first responding
60 phy-poll-interval:
67 link-speed:
74 the link speed specified here will be requested. If the optional pro-
75 perty advertise-lower-link-speeds is set, advertisement of the link
79 - 1
80 - 2
81 - 3
83 advertise-lower-link-speeds:
88 set in the link-speed property in the advertisement when requesting
89 link speed auto-negotiation with a peer system.
91 handle-rx-in-isr:
99 handling of the RX interrupt is normally deferred to the context
102 handle-tx-in-workq:
106 context of the system work queue. By default, TX done handling is per-
108 of memory accesses. This option CAN NOT be used if any component ex-
112 amba-ahb-dbus-width:
117 - 0
118 - 1
119 - 2
121 amba-ahb-burst-length:
126 - 1
127 - 4
128 - 8
129 - 16
131 hw-rx-buffer-size:
135 Hardware RX buffer size, scalable between 1 kB and 8 kB, where the full
138 - 0
139 - 1
140 - 2
141 - 3
143 hw-rx-buffer-offset:
147 Data offset in the hardware RX packet buffer (in bytes). Valid range is
148 0-3 bytes.
150 hw-tx-buffer-size-full:
157 rx-buffer-descriptors:
161 The number of descriptors to be allocated in the RX buffer descriptor
164 rx-buffer-size:
171 tx-buffer-descriptors:
178 tx-buffer-size:
185 ignore-ipg-rxer:
188 Optional feature flag - Ignore IPG rx_er. When set, rx_er has no
190 the RGMII wrapper in half-duplex mode.
192 disable-reject-nsp:
195 Optional feature flag - Receive bad preamble. When set, frames with
196 non-standard preamble will not be rejected.
198 ipg-stretch:
201 Optional feature flag - Enable IPG stretch. When set, the transmit
205 sgmii-mode:
208 Optional feature flag - Enable SGMII mode. Changes the behaviour of
209 the auto-negotiation advertisement and link partner ability registers
213 disable-reject-fcs-crc-errors:
216 Optional feature flag - Disable rejection of FCS/CRC errors.
222 rx-halfdup-while-tx:
225 Optional feature flag - Enable frames to be received in half-duplex
228 rx-checksum-offload:
231 Optional feature flag - Enable RX IP/TCP/UDP checksum offload to
235 tx-checksum-offload:
238 Optional feature flag - Enable TX IP/TCP/UDP checksum offload to
242 disable-pause-copy:
245 Optional feature flag - Do not copy received pause frames to memory.
249 match is found or whether a type ID match is identified. If a desti-
254 discard-rx-fcs:
257 Optional feature flag - Remove FCS of received frames.
262 discard-rx-length-errors:
265 Optional feature flag - Discard frames with length field errors.
267 length field (as indicated by bytes 13 and 14 in a non-VLAN tagged
271 pause-frame:
274 Optional feature flag - Enable pause. When set, transmission will
281 Optional feature flag - Enable TBI. When set, the TBI interface is en-
284 ext-address-match:
287 Optional feature flag - Enable external address match. When set, the
290 long-frame-rx-support:
293 Optional feature flag - Enable reception of 1536 byte frames.
296 unicast-hash:
299 Optional feature flag - Enable unicast hash. When set, unicast frames
303 multicast-hash:
306 Optional feature flag - Enable multicast hash. When set, mutlicast
307 frames will be accepted when the 6 bit hash function of the desti-
310 reject-broadcast:
313 Optional feature flag - Reject broadcast frames. When set, frames
314 addressed to the all-ones broadcast address will be rejected.
316 promiscuous-mode:
319 Optional feature flag - Enable promiscuous mode. When set, all valid
322 discard-non-vlan:
324 description: Optional feature flag - Discard non-VLAN frames. When set,
327 full-duplex:
330 Optional feature flag - Enables full duplex reception and transmission.
332 discard-rx-frame-ahb-unavail:
335 Optional feature flag - Discard received packets when no AHB resource
338 ahb-packet-endian-swap:
341 Optional feature flag - Enable AHB packet data endianness swap to big
344 ahb-md-endian-swap:
347 Optional feature flag - Enable AHB management descriptor data endian-