Lines Matching +full:full +full:- +full:duplex
3 # SPDX-License-Identifier: Apache-2.0
19 clock-frequency:
27 which it will be adjusted at run-time. Therefore, the value of this
29 respective GEM's TX clock - by default, this is the IO PLL.
31 mdc-divider:
42 init-mdio-phy:
46 Activates the management of a PHY associated with the controller in-
47 stance. If this parameter is activated at the board level, the de-
48 fault values of the associated parameters mdio-phy-address, phy-poll-
49 interval, link-speed and advertise-lower-link-speeds should be checked
52 mdio-phy-address:
57 instance. Set the address to 0 for auto-detection (first responding
61 phy-poll-interval:
68 link-speed:
75 the link speed specified here will be requested. If the optional pro-
76 perty advertise-lower-link-speeds is set, advertisement of the link
80 - 1
81 - 2
82 - 3
84 advertise-lower-link-speeds:
90 set in the link-speed property in the advertisement when requesting
91 link speed auto-negotiation with a peer system.
93 handle-rx-in-isr:
105 handle-tx-in-workq:
110 context of the system work queue. By default, TX done handling is per-
112 of memory accesses. This option CAN NOT be used if any component ex-
116 amba-ahb-dbus-width:
121 - 0
122 - 1
123 - 2
125 amba-ahb-burst-length:
130 - 1
131 - 4
132 - 8
133 - 16
135 hw-rx-buffer-size:
139 Hardware RX buffer size, scalable between 1 kB and 8 kB, where the full
142 - 0
143 - 1
144 - 2
145 - 3
147 hw-rx-buffer-offset:
152 0-3 bytes.
154 hw-tx-buffer-size-full:
158 When set, the hardware TX data buffer will make use of the full 4 kB
162 rx-buffer-descriptors:
169 rx-buffer-size:
176 tx-buffer-descriptors:
183 tx-buffer-size:
190 ignore-ipg-rxer:
194 Optional feature flag - Ignore IPG rx_er. When set, rx_er has no
196 the RGMII wrapper in half-duplex mode.
198 disable-reject-nsp:
202 Optional feature flag - Receive bad preamble. When set, frames with
203 non-standard preamble will not be rejected.
205 ipg-stretch:
209 Optional feature flag - Enable IPG stretch. When set, the transmit
213 sgmii-mode:
217 Optional feature flag - Enable SGMII mode. Changes the behaviour of
218 the auto-negotiation advertisement and link partner ability registers
222 disable-reject-fcs-crc-errors:
226 Optional feature flag - Disable rejection of FCS/CRC errors.
232 rx-halfdup-while-tx:
236 Optional feature flag - Enable frames to be received in half-duplex
239 rx-checksum-offload:
243 Optional feature flag - Enable RX IP/TCP/UDP checksum offload to
247 tx-checksum-offload:
251 Optional feature flag - Enable TX IP/TCP/UDP checksum offload to
255 disable-pause-copy:
259 Optional feature flag - Do not copy received pause frames to memory.
263 match is found or whether a type ID match is identified. If a desti-
268 discard-rx-fcs:
272 Optional feature flag - Remove FCS of received frames.
277 discard-rx-length-errors:
281 Optional feature flag - Discard frames with length field errors.
283 length field (as indicated by bytes 13 and 14 in a non-VLAN tagged
287 pause-frame:
291 Optional feature flag - Enable pause. When set, transmission will
299 Optional feature flag - Enable TBI. When set, the TBI interface is en-
302 ext-address-match:
306 Optional feature flag - Enable external address match. When set, the
309 long-frame-rx-support:
313 Optional feature flag - Enable reception of 1536 byte frames.
316 unicast-hash:
320 Optional feature flag - Enable unicast hash. When set, unicast frames
324 multicast-hash:
328 Optional feature flag - Enable multicast hash. When set, mutlicast
329 frames will be accepted when the 6 bit hash function of the desti-
332 reject-broadcast:
336 Optional feature flag - Reject broadcast frames. When set, frames
337 addressed to the all-ones broadcast address will be rejected.
339 promiscuous-mode:
343 Optional feature flag - Enable promiscuous mode. When set, all valid
346 discard-non-vlan:
349 description: Optional feature flag - Discard non-VLAN frames. When set,
352 full-duplex:
356 Optional feature flag - Enables full duplex reception and transmission.
358 discard-rx-frame-ahb-unavail:
362 Optional feature flag - Discard received packets when no AHB resource
365 ahb-packet-endian-swap:
369 Optional feature flag - Enable AHB packet data endianness swap to big
372 ahb-md-endian-swap:
376 Optional feature flag - Enable AHB management descriptor data endian-