| /Linux-v5.4/drivers/leds/ |
| D | leds-lt3593.c | 26 int pulses; in lt3593_led_set() local
42 pulses = 32 - (value * 32) / 255; in lt3593_led_set()
44 if (pulses == 0) { in lt3593_led_set()
53 while (pulses--) { in lt3593_led_set()
|
| /Linux-v5.4/drivers/hwmon/ |
| D | pwm-fan.c | 31 atomic_t pulses; member
49 atomic_inc(&ctx->pulses); in pulse_handler()
57 int pulses; in sample_timer() local
60 pulses = atomic_read(&ctx->pulses); in sample_timer()
61 atomic_sub(pulses, &ctx->pulses); in sample_timer()
62 tmp = (u64)pulses * ktime_ms_delta(ktime_get(), ctx->sample_start) * 60; in sample_timer()
|
| /Linux-v5.4/Documentation/ABI/testing/ |
| D | sysfs-bus-iio-timer-stm32 | 23 OC4REF rising or falling edges generate pulses.
25 OC6REF rising or falling edges generate pulses.
27 OC4REF or OC6REF rising edges generate pulses.
29 OC4REF rising or OC6REF falling edges generate pulses.
31 OC5REF or OC6REF rising edges generate pulses.
33 OC5REF rising or OC6REF falling edges generate pulses.
|
| /Linux-v5.4/Documentation/input/devices/ |
| D | walkera0701.rst | 20 pulses from processor to HF part can be found at pin 2 of this connector,
22 modulation pulses to PC, signal pulses must be amplified.
62 Signal pulses
98 (Warning, pulses on ACK are inverted by transistor, irq is raised up on sync
105 values can be sampled between sync pulses.
|
| /Linux-v5.4/Documentation/devicetree/bindings/hwmon/ |
| D | pwm-fan.txt | 17 - pulses-per-revolution : define the tachometer pulses per fan revolution as
56 pulses-per-revolution = <2>;
|
| /Linux-v5.4/drivers/net/wireless/ath/ |
| D | dfs_pri_detector.c | 163 struct list_head *l = &pde->pulses; in pulse_queue_get_tail()
216 list_add(&p->head, &pde->pulses); in pulse_queue_enqueue()
229 list_for_each_entry(p, &pde->pulses, head) { in pseq_handler_create_sequences()
258 list_for_each_entry_continue(p2, &pde->pulses, head) { in pseq_handler_create_sequences()
367 list_for_each_entry_safe(p, p0, &pde->pulses, head) { in pri_detector_reset()
430 INIT_LIST_HEAD(&de->pulses); in pri_detector_init()
|
| D | dfs_pri_detector.h | 70 struct list_head pulses; member
|
| /Linux-v5.4/Documentation/hwmon/ |
| D | g762.rst | 18 hardware characteristics of the system (reference clock, pulses per
36 number of pulses per fan revolution. Supported values
71 system: a reference clock source frequency, a number of pulses per fan
|
| D | g760a.rst | 23 consecutive speed pulses. The period is defined in terms of clock
|
| D | nsa320.rst | 55 is reduced from 100 us to less than 15 us then data pulses are likely to be
|
| D | dme1737.rst | 163 to the number of pulses per fan revolution that the connected tachometer
165 that generate 2 pulses per revolution. Fan inputs 5-6 also provide a max
296 number of pulses per revolution that
|
| D | smsc47b397.rst | 90 The SIO counts the number of 90kHz (11.111us) pulses per revolution.
|
| D | sysfs-interface.rst | 285 Number of tachometer pulses per fan revolution.
296 the number of pulses. In the absence of such a register (and
297 thus attribute) the value assumed by all devices is 2 pulses
|
| D | lm85.rst | 276 The number of pulses-per-rev of the fans can be set, Tach monitoring
|
| /Linux-v5.4/arch/arm/boot/dts/ |
| D | aspeed-bmc-opp-swift.dts | 348 tach-pulses = <2>;
360 tach-pulses = <2>;
372 tach-pulses = <2>;
384 tach-pulses = <2>;
396 tach-pulses = <2>;
|
| /Linux-v5.4/Documentation/media/uapi/rc/ |
| D | lirc-set-send-carrier.rst | 40 Set send carrier used to modulate IR PWM pulses and spaces.
|
| D | lirc-set-rec-carrier.rst | 40 Set receive carrier used to modulate IR PWM pulses and spaces.
|
| D | rc-protos.rst | 11 IR is encoded as a series of pulses and spaces, using a protocol. These
|
| /Linux-v5.4/Documentation/devicetree/bindings/leds/ |
| D | leds-is31fl319x.txt | 37 by reducing the dury-cycle of pulses and not the current, which
|
| /Linux-v5.4/Documentation/i2c/ |
| D | gpio-fault-injection.rst | 81 register 0x00 (if it has registers) when further clock pulses happen on SCL.
82 This is why bus recovery (up to 9 clock pulses) must either check SDA or send
|
| /Linux-v5.4/drivers/leds/trigger/ |
| D | Kconfig | 25 This allows LEDs to blink in one-shot pulses with parameters
|
| /Linux-v5.4/Documentation/devicetree/bindings/memory-controllers/ |
| D | omap-gpmc.txt | 87 - gpmc,cycle2cycle-delay-ns: Delay between chip-select pulses
|
| /Linux-v5.4/drivers/media/rc/ |
| D | Kconfig | 358 Note that this device can only record bursts of 36 IR pulses and
402 wave and pulses.
|
| /Linux-v5.4/Documentation/fb/ |
| D | framebuffer.rst | 210 influenced by the moments at which the synchronization pulses occur.
|
| /Linux-v5.4/Documentation/media/uapi/v4l/ |
| D | dev-raw-vbi.rst | 20 oscilloscope you will find here the vertical synchronization pulses and
|
