Searched refs:DSL (Results 1 – 18 of 18) sorted by relevance
| /Linux-v5.4/drivers/usb/atm/ |
| D | Kconfig | 3 # USB/ATM DSL configuration
7 tristate "USB DSL modem support"
11 Say Y here if you want to connect a USB Digital Subscriber Line (DSL)
45 tristate "ADI 930 and eagle USB DSL modem"
57 tristate "Other USB DSL modem support"
59 Say Y here if you have a DSL USB modem not explicitly supported by
60 another USB DSL drivers. In order to use your modem you will need to
|
| /Linux-v5.4/Documentation/devicetree/bindings/arm/bcm/ |
| D | brcm,bcm63138.txt | 1 Broadcom BCM63138 DSL System-on-a-Chip device tree bindings
4 Boards compatible with the BCM63138 DSL System-on-a-Chip should have the
|
| /Linux-v5.4/drivers/clk/bcm/ |
| D | Kconfig | 17 Enable common clock framework support for Broadcom BCM63xx DSL SoCs
25 Enable common clock framework support for Broadcom BCM63xx DSL SoCs
|
| /Linux-v5.4/drivers/isdn/ |
| D | Kconfig | 16 (though still much slower than with DSL) or to make and accept
|
| /Linux-v5.4/arch/arm/boot/dts/ |
| D | bcm63138.dtsi | 3 * Broadcom BCM63138 DSL SoCs Device Tree
13 model = "Broadcom BCM63138 DSL SoC";
|
| /Linux-v5.4/Documentation/devicetree/bindings/gpio/ |
| D | gpio-stp-xway.txt | 5 3 groups of 8 bits can be driven. The hardware is able to allow the DSL modem
|
| /Linux-v5.4/arch/arm/mach-bcm/ |
| D | Kconfig | 190 bool "Broadcom BCM63xx DSL SoC"
204 This enables support for systems based on Broadcom DSL SoCs.
|
| /Linux-v5.4/net/atm/ |
| D | Kconfig | 66 This is sometimes used over DSL lines. If in doubt, say N.
|
| /Linux-v5.4/Documentation/devicetree/bindings/mips/brcm/ |
| D | soc.txt | 1 * Broadcom cable/DSL/settop platforms
|
| /Linux-v5.4/drivers/net/ethernet/dec/tulip/ |
| D | de2104x.c | 89 #define DSL 0 macro
91 #define DSL CONFIG_DE2104X_DSL macro
165 DescSkipLen = (DSL << 2),
280 #if DSL
281 __le32 skip[DSL];
|
| /Linux-v5.4/sound/pci/emu10k1/ |
| D | emu10k1_callback.c | 398 snd_emu10k1_ptr_write(hw, DSL, ch, temp); in start_voice()
|
| D | emu10k1_main.c | 69 snd_emu10k1_ptr_write(emu, DSL, ch, 0x10); in snd_emu10k1_voice_init()
2053 CPF, PTRX, CVCF, VTFT, Z1, Z2, PSST, DSL, CCCA, CCR, CLP,
|
| D | emupcm.c | 348 snd_emu10k1_ptr_write(emu, DSL, voice, end_addr | (send_amount[3] << 24)); in snd_emu10k1_pcm_init_voice()
|
| /Linux-v5.4/include/sound/ |
| D | emu10k1.h | 396 #define DSL 0x07 /* Send D amount and loop start address register */ macro
|
| /Linux-v5.4/drivers/atm/ |
| D | Kconfig | 38 have the code to drive the on-board Alcatel DSL chipset (yet).
|
| /Linux-v5.4/drivers/i2c/busses/ |
| D | Kconfig | 474 tristate "BRCM Settop/DSL I2C controller"
480 I2C interface on the Broadcom Settop/DSL SoCs.
|
| /Linux-v5.4/drivers/tty/serial/ |
| D | Kconfig | 1133 BCM63xx/BCM63xxx (DSL)
|
| /Linux-v5.4/arch/mips/ |
| D | Kconfig | 257 BCM33xx cable modem chips, BCM63xx DSL chips, and BCM7xxx set-top
|
