| /Linux-v5.15/drivers/phy/amlogic/ |
| D | Kconfig | 42 tristate "Meson G12A USB3+PCIE Combo PHY driver" 48 Enable this to support the Meson USB3 + PCIE Combo PHY found 53 tristate "Meson AXG PCIE PHY driver" 59 Enable this to support the Meson MIPI + PCIE PHY found 64 tristate "Meson AXG MIPI + PCIE analog PHY driver" 71 Enable this to support the Meson MIPI + PCIE analog PHY
|
| /Linux-v5.15/drivers/net/wireless/broadcom/brcm80211/brcmfmac/ |
| D | pcie.c | 610 brcmf_dbg(PCIE, "config offset 0x%04x, value 0x%04x\n", in brcmf_pcie_reset_device() 681 brcmf_dbg(PCIE, "MB transaction is already pending 0x%04x\n", in brcmf_pcie_send_mb_data() 720 brcmf_dbg(PCIE, "D2H_MB_DATA: 0x%04x\n", dtoh_mb_data); in brcmf_pcie_handle_mb_data() 722 brcmf_dbg(PCIE, "D2H_MB_DATA: DEEP SLEEP REQ\n"); in brcmf_pcie_handle_mb_data() 724 brcmf_dbg(PCIE, "D2H_MB_DATA: sent DEEP SLEEP ACK\n"); in brcmf_pcie_handle_mb_data() 727 brcmf_dbg(PCIE, "D2H_MB_DATA: DEEP SLEEP EXIT\n"); in brcmf_pcie_handle_mb_data() 729 brcmf_dbg(PCIE, "D2H_MB_DATA: D3 ACK\n"); in brcmf_pcie_handle_mb_data() 734 brcmf_dbg(PCIE, "D2H_MB_DATA: FW HALT\n"); in brcmf_pcie_handle_mb_data() 838 brcmf_dbg(PCIE, "Enter\n"); in brcmf_pcie_quick_check_isr() 852 brcmf_dbg(PCIE, "Enter %x\n", status); in brcmf_pcie_isr_thread() [all …]
|
| D | Kconfig | 41 bool "PCIE bus interface support for FullMAC driver" 47 This option enables the PCIE bus interface support for Broadcom 49 use the driver for an PCIE wireless card.
|
| /Linux-v5.15/drivers/infiniband/hw/hfi1/ |
| D | chip_registers.h | 20 #define PCIE 0 macro 584 #define PCI_CFG_MSIX0 (PCIE + 0x0000000000B0) 585 #define PCI_CFG_REG1 (PCIE + 0x000000000004) 586 #define PCI_CFG_REG11 (PCIE + 0x00000000002C) 587 #define PCIE_CFG_SPCIE1 (PCIE + 0x00000000014C) 588 #define PCIE_CFG_SPCIE2 (PCIE + 0x000000000150) 589 #define PCIE_CFG_TPH2 (PCIE + 0x000000000180) 1269 #define PCIE_CFG_REG_PL2 (PCIE + 0x000000000708) 1270 #define PCIE_CFG_REG_PL3 (PCIE + 0x00000000070C) 1273 #define PCIE_CFG_REG_PL102 (PCIE + 0x000000000898) [all …]
|
| /Linux-v5.15/drivers/net/ethernet/huawei/hinic/ |
| D | Kconfig | 7 tristate "Huawei Intelligent PCIE Network Interface Card" 11 This driver supports HiNIC PCIE Ethernet cards.
|
| /Linux-v5.15/drivers/phy/st/ |
| D | phy-spear1310-miphy.c | 97 PCIE, enumerator 155 if (priv->mode == PCIE) in spear1310_miphy_init() 166 if (priv->mode == PCIE) in spear1310_miphy_exit() 196 if (priv->mode != SATA && priv->mode != PCIE) { in spear1310_miphy_xlate()
|
| D | phy-spear1340-miphy.c | 76 PCIE, enumerator 163 else if (priv->mode == PCIE) in spear1340_miphy_init() 176 else if (priv->mode == PCIE) in spear1340_miphy_exit() 233 if (priv->mode != SATA && priv->mode != PCIE) { in spear1340_miphy_xlate()
|
| D | Kconfig | 10 Enable this to support the miphy transceiver (for SATA/PCIE/USB3)
|
| /Linux-v5.15/Documentation/devicetree/bindings/net/wireless/ |
| D | marvell-8xxx.txt | 1 Marvell 8787/8897/8997 (sd8787/sd8897/sd8997/pcie8997) SDIO/PCIE devices 4 This node provides properties for controlling the Marvell SDIO/PCIE wireless device. 5 The node is expected to be specified as a child node to the SDIO/PCIE controller that
|
| /Linux-v5.15/Documentation/devicetree/bindings/pci/ |
| D | amlogic,meson-pcie.txt | 1 Amlogic Meson AXG DWC PCIE SoC controller 32 - phys: should contain a phandle to the PCIE phy
|
| /Linux-v5.15/drivers/staging/gs_fpgaboot/ |
| D | README | 51 doesn't talk to any of Linux interfaces (such as PCIE). 58 any of linux interfaces (such as PCIE)
|
| /Linux-v5.15/arch/arm64/boot/dts/xilinx/ |
| D | zynqmp-zcu102-revA.dts | 223 output-low; /* PCIE = 0, DP = 1 */ 229 output-high; /* PCIE = 0, DP = 1 */ 235 output-high; /* PCIE = 0, USB0 = 1 */ 241 output-high; /* PCIE = 0, SATA = 1 */ 525 /* refclk4 for PS-GT, used for PCIE slot */ 530 /* refclk5 for PS-GT, used for PCIE */
|
| /Linux-v5.15/Documentation/devicetree/bindings/phy/ |
| D | rockchip-pcie-phy.txt | 1 Rockchip PCIE PHY
|
| D | phy-hi3798cv200-combphy.txt | 1 HiSilicon STB PCIE/SATA/USB3 PHY
|
| /Linux-v5.15/drivers/net/can/sja1000/ |
| D | Kconfig | 25 tristate "Fintek F81601 PCIE to 2 CAN Controller" 28 This driver adds support for Fintek F81601 PCIE to 2 CAN
|
| /Linux-v5.15/drivers/net/wireless/marvell/mwifiex/ |
| D | Kconfig | 25 tristate "Marvell WiFi-Ex Driver for PCIE 8766/8897/8997"
|
| /Linux-v5.15/drivers/net/wireless/ath/ath11k/ |
| D | Kconfig | 28 This module adds support for PCIE bus
|
| /Linux-v5.15/arch/arm64/boot/dts/renesas/ |
| D | salvator-xs.dtsi | 37 line-name = "PCIE/SATA switch";
|
| /Linux-v5.15/drivers/pinctrl/tegra/ |
| D | pinctrl-tegra30.c | 2404 …PINGROUP(pex_l2_rst_n_pcc6, PCIE, HDA, RSVD3, RSVD4, 0x33d8, N, … 2405 …PINGROUP(pex_l2_clkreq_n_pcc7, PCIE, HDA, RSVD3, RSVD4, 0x33dc, N, … 2406 …PINGROUP(pex_l0_prsnt_n_pdd0, PCIE, HDA, RSVD3, RSVD4, 0x33b8, N, … 2407 …PINGROUP(pex_l0_rst_n_pdd1, PCIE, HDA, RSVD3, RSVD4, 0x33bc, N, … 2408 …PINGROUP(pex_l0_clkreq_n_pdd2, PCIE, HDA, RSVD3, RSVD4, 0x33c0, N, … 2409 …PINGROUP(pex_wake_n_pdd3, PCIE, HDA, RSVD3, RSVD4, 0x33c4, N, … 2410 …PINGROUP(pex_l1_prsnt_n_pdd4, PCIE, HDA, RSVD3, RSVD4, 0x33c8, N, … 2411 …PINGROUP(pex_l1_rst_n_pdd5, PCIE, HDA, RSVD3, RSVD4, 0x33cc, N, … 2412 …PINGROUP(pex_l1_clkreq_n_pdd6, PCIE, HDA, RSVD3, RSVD4, 0x33d0, N, … 2413 …PINGROUP(pex_l2_prsnt_n_pdd7, PCIE, HDA, RSVD3, RSVD4, 0x33d4, N, …
|
| /Linux-v5.15/drivers/tty/serial/8250/ |
| D | 8250_exar.c | 859 EXAR_DEVICE(COMMTECH, 4222PCIE, pbn_fastcom35x_2), 860 EXAR_DEVICE(COMMTECH, 4224PCIE, pbn_fastcom35x_4), 861 EXAR_DEVICE(COMMTECH, 4228PCIE, pbn_fastcom35x_8),
|
| /Linux-v5.15/drivers/net/wireless/ath/ath10k/ |
| D | Kconfig | 22 This module adds support for PCIE bus
|
| /Linux-v5.15/arch/arm/boot/dts/ |
| D | imx6q-gw5400-a.dts | 461 MX6QDL_PAD_ENET_TX_EN__GPIO1_IO28 0x1b0b0 /* PCIE IRQ */ 462 MX6QDL_PAD_ENET_TXD1__GPIO1_IO29 0x1b0b0 /* PCIE RST */
|
| D | kirkwood-pogoplug-series-4.dts | 105 * This PCIE controller has a USB 3.0 XHCI controller at 1,0
|
| D | qcom-apq8064-cm-qs600.dts | 190 regulator-name = "PCIE V3P3";
|
| /Linux-v5.15/Documentation/devicetree/bindings/regulator/ |
| D | tps6586x.txt | 85 regulator-name = "PCIE CLK";
|