Home
last modified time | relevance | path

Searched refs:multiplexing (Results 1 – 25 of 60) sorted by relevance

123

/Linux-v4.19/Documentation/devicetree/bindings/pinctrl/
Dcortina,gemini-pinctrl.txt4 see further arm/gemini.txt. It is a purely group-based multiplexing pin
12 Subnodes of the pin controller contain pin control multiplexing set-up
15 Please refer to pinctrl-bindings.txt for generic pin multiplexing nodes
Drenesas,rza1-pinctrl.txt5 Pin multiplexing and GPIO configuration is performed on a per-pin basis
36 The child nodes of the pin controller node describe a pin multiplexing
39 - Pin multiplexing sub-nodes:
40 A pin multiplexing sub-node describes how to configure a set of
53 The allowed generic formats for a pin multiplexing sub-node are the
83 Client sub-nodes shall refer to pin multiplexing sub-nodes using the phandle
102 integer array representing pin number and pin multiplexing configuration.
Dbrcm,bcm2835-gpio.txt39 The BCM2835 pin configuration and multiplexing supports the generic bindings.
53 Legacy pin configuration and multiplexing binding:
54 *** (Its use is deprecated, use generic multiplexing and configuration
Dste,nomadik.txt22 pin multiplexing node layout from the standard pin control bindings
25 Required pin multiplexing subnode properties:
29 group that will be combined with the function to form a multiplexing
Dpinctrl-zx.txt6 controllers work together to control pin multiplexing and configuration in
39 TOP_PMM and AON_IOCFG blocks, as the available multiplexing functions for
Dallwinner,sunxi-pinctrl.txt4 each bank has 32 pins. Each pin has 7 multiplexing functions, with
60 Allwinner A1X Pin Controller supports the generic pin multiplexing and
74 *** Deprecated pin configuration and multiplexing binding
Dpinctrl-bindings.txt3 Hardware modules that control pin multiplexing or configuration parameters
142 == Generic pin multiplexing node content ==
144 pin multiplexing nodes:
207 For hardware where pin multiplexing configurations have to be specified for
218 a single pin multiplexing configuration.
227 how pin IDs and pin multiplexing configuration are defined and assembled
Dmscc,ocelot-pinctrl.txt15 The ocelot-pinctrl driver uses the generic pin multiplexing and generic pin
Dnxp,lpc1850-scu.txt9 The lpc1850-scu driver uses the generic pin multiplexing and generic pin
Dpinctrl-st.txt4 PIO multiplexing block. Each pin supports GPIO functionality (ALT0)
11 ST pinctrl driver controls PIO multiplexing block and also interacts with
/Linux-v4.19/arch/arm/mach-omap1/
DKconfig36 bool "OMAP multiplexing support"
40 Pin multiplexing support for OMAP boards. If your bootloader
41 sets the multiplexing correctly, say N. Otherwise, or if unsure,
48 Makes the multiplexing functions print out a lot of debug info.
50 multiplexing registers.
58 to change the pin multiplexing setup. When there are no warnings
/Linux-v4.19/arch/arm/mach-davinci/
DKconfig211 bool "DAVINCI multiplexing support"
215 Pin multiplexing support for DAVINCI boards. If your bootloader
216 sets the multiplexing correctly, say N. Otherwise, or if unsure,
223 Makes the multiplexing functions print out a lot of debug info.
225 multiplexing registers.
232 to change the pin multiplexing setup. When there are no warnings
/Linux-v4.19/Documentation/serial/
Dn_gsm.txt4 This line discipline implements the GSM 07.10 multiplexing protocol
80 Note that after closing the physical port the modem is still in multiplexing
83 a disconnect command frame manually before initializing the multiplexing mode
/Linux-v4.19/net/kcm/
DKconfig9 for multiplexing messages of a message based application
/Linux-v4.19/Documentation/devicetree/bindings/i2c/
Di2c-mux-pinctrl.txt3 This binding describes an I2C bus multiplexer that uses pin multiplexing to
4 route the I2C signals, and represents the pin multiplexing configuration
Di2c-demux-pinctrl.txt3 This binding describes an I2C bus demultiplexer that uses pin multiplexing to
4 route the I2C signals, and represents the pin multiplexing configuration using
/Linux-v4.19/drivers/net/ethernet/qualcomm/rmnet/
DKconfig11 for handling data in the multiplexing and aggregation protocol (MAP)
/Linux-v4.19/Documentation/devicetree/bindings/misc/
Deeprom-93xx46.txt12 each access to the EEPROM (e.g. for SPI bus multiplexing)
/Linux-v4.19/Documentation/devicetree/bindings/fsi/
Dfsi-master-gpio.txt12 - mux-gpios = <gpio-descriptor>; : GPIO for pin multiplexing with other
Dfsi-master-ast-cf.txt14 - mux-gpios = <gpio-descriptor>; : GPIO for pin multiplexing with other
/Linux-v4.19/Documentation/devicetree/bindings/memory-controllers/
Domap-gpmc.txt124 - gpmc,mux-add-data Address and data multiplexing configuration.
126 multiplexing mode and 2 for address-data
127 multiplexing mode.
/Linux-v4.19/drivers/video/fbdev/
Dcirrusfb.c361 int multiplexing; member
487 cinfo->multiplexing = 0; in cirrusfb_check_pixclock()
507 cinfo->multiplexing = 1; in cirrusfb_check_pixclock()
511 cinfo->multiplexing = 1; in cirrusfb_check_pixclock()
735 if (cinfo->multiplexing) { in cirrusfb_set_par_foo()
840 if (cinfo->multiplexing) in cirrusfb_set_par_foo()
954 cinfo->multiplexing ? in cirrusfb_set_par_foo()
999 if (cinfo->multiplexing) in cirrusfb_set_par_foo()
1028 cinfo->multiplexing ? in cirrusfb_set_par_foo()
1072 if (cinfo->multiplexing) in cirrusfb_set_par_foo()
/Linux-v4.19/Documentation/media/kapi/
Ddtv-core.rst25 .. [#f1] Some standards use TCP/IP for multiplexing data, like DVB-H (an
/Linux-v4.19/Documentation/devicetree/bindings/ata/
Dcortina,gemini-sata-bridge.txt16 - cortina,gemini-ata-muxmode: tell the desired multiplexing mode for
/Linux-v4.19/Documentation/devicetree/bindings/dma/
Dfsl-edma.txt14 The 2nd and the 3rd regions are programmable channel multiplexing

123