Searched full:minimise (Results 1 – 25 of 60) sorted by relevance
123
61 * This is similar to s3c_pm_do_restore() except we try and minimise the
136 * we minimise the work between the two settings. in samsung_gpio_pm_2bit_resume()
230 * Minimise the overhead by omitting the checks for Linux SMP IPIs. in __ipi_send_single()273 * Minimise the overhead by omitting the checks for Linux SMP IPIs. in __ipi_send_mask()
20 * chosen to minimise the shift distances.
37 * We pick the reserved-ASID to minimise the impact. in __do_compat_cache_op()
52 priority to minimise the transfer latency on the bus (boolean)
48 * to eventually flush us, but to minimise latency just ask the in __busy_set_if_active()
73 not in use in order to minimise the need to use ifdefs.
171 minimise any system noise. The mute stops any digital data from
10 are very small and all blocks are packed to minimise data overhead.
233 * priority to minimise the transfer latency on the bus.
126 /* Minimise down-time: drop delay for up event. */ in linkwatch_schedule_work()
103 * the latest supported version and wish to minimise code size.
73 * Ramp OUT1 PGA volume to minimise pops at stream startup and shutdown.138 * Ramp OUT2 PGA volume to minimise pops at stream startup and shutdown.203 * minimise pop associated with DAPM power switching.204 * It's best to enable Zero Cross when ramping occurs to minimise any
69 * master to slave. We track the last DMA setup in order to minimise
86 * order to minimise this, a signal may be applied to the MASK pin to delay or
94 * order to minimise this, a signal may be applied to the MASK pin to delay or
260 /* pre and post sample - can be used to minimise any analog noise */
19 * equidistant from 0 and INT_MAX we minimise the scope for error:
85 * mobility are placed within the same pageblocks to minimise problems due
374 * minimise I/O.
11 minimise data overhead. Block sizes greater than 4K are supported up to a
848 /* Restore the default value to minimise disruption */ in test_ctl_write_valid()1066 /* Restore the default value to minimise disruption */ in test_ctl_write_invalid()
236 period is quite high to minimise overhead but the information collected can be
