Searched full:asserting (Results 1 – 25 of 130) sorted by relevance
123456
42 Delay in ms after powering the card and de-asserting the47 Delay in us after asserting the reset-gpios (if any)
27 * Enabling/disabling an interrupt line involves asserting/clearing29 * asserting the corresponding bit in ICR.
13 - resets: Should contain a reference to the reset controller asserting
31 * @hardware_clear_to_midscale: Whether asserting the hardware CLR pin sets the
30 system can rely on asserting the line to enable the GNSS device.
38 ensure the timing required between asserting ENABLE
123 dev_err(ps->dev, "PS 0x%x: asserting RESET while powered down\n", ps->offset); in apple_pmgr_reset_assert()126 /* Quiesce device before asserting reset */ in apple_pmgr_reset_assert()
47 * de-asserting the reset. Delay 10us just to be safe. in clk_pll_enable()281 * de-asserting the reset. Delay 10us just to be safe. in clk_pll_sr2_enable()
68 Delay after asserting reset to the PCIe device.
30 * done by asserting the remfreqmsk bit (XSPAREREG<7>) in mgag200_bmc_disable_vidrst()
19 * Suspend Modulation works by asserting and de-asserting the SUSP# pin20 * to CPU(GX1/GXLV) for configurable durations. When asserting SUSP#
38 * The hardware is asserting attn and the state machine is
367 * "This register decides the asserting duration of wdt_ext and in aspeed_wdt_probe()369 * default asserting duration of wdt_ext and wdt_rstarm is in aspeed_wdt_probe()
170 dev_err(dev, "error asserting ssc_bcr: %d\n", ret); in qcom_ssc_block_bus_deinit()179 dev_err(dev, "error asserting ssc_reset: %d\n", ret); in qcom_ssc_block_bus_deinit()
16 response mechanism where masters have to claim the bus by asserting
58 /* Maximum reset delay after de-asserting a line and seeing block in brcmstb_reset_deassert()
224 /* wait after asserting subsystem restart from AOSS */ in qcom_wpss_shutdown()296 /* wait after asserting subsystem restart from AOSS */ in qcom_adsp_shutdown()306 /* wait after de-asserting subsystem restart from AOSS */ in qcom_adsp_shutdown()
64 * pcie_pme_walk_bus - Scan a PCI bus for devices asserting PME#.67 * Scan given PCI bus and all buses under it for devices asserting PME#.
266 /* Wait for a short time before de-asserting in hdmi_pll_enable()282 * Wait for a short time before de-asserting to allow the hardware to in hdmi_pll_enable()
91 /* Enable the MDIO bus by asserting the enable bit and writing in temac_mdio_setup()
76 * case of suspend for instance. Theoretically, asserting individual in stih407_usb2_exit_port()
76 * @start_conv_msg: SPI message to start a conversion by briefly asserting CS422 /* conversions are started by asserting CS pin for 8 usec */ in mcp320x_probe()
159 /* Check the current status to avoid de-asserting the line twice */ in omap4_prminst_deassert_hardreset()
87 /* Asserting PLL Reset */ in bcm_ns_usb3_phy_init_ns_bx()
38 * or switching between two parents by asserting or deasserting the gpio.
