Home
last modified time | relevance | path

Searched full:absent (Results 1 – 25 of 243) sorted by relevance

12345678910

/Linux-v6.1/Documentation/devicetree/bindings/net/
Dibm,emac.txt65 - phy-address : 1 cell, optional, MDIO address of the PHY. If absent,
68 for, used if phy-address is absent. bit 0x00000001 is
70 For Axon it can be absent, though my current driver
77 operations (if absent the value is the same as
78 rx-fifo-size). For Axon, either absent or 2048.
80 operations (if absent the value is the same as
81 tx-fifo-size). For Axon, either absent or 2048.
Dlpc-eth.txt10 absent, "rmii" is assumed.
Ddavinci_emac.txt22 If absent, davinci_emac driver defaults to 100/FULL.
/Linux-v6.1/Documentation/devicetree/bindings/powerpc/opal/
Dpower-mgt.txt69 property. If the property is absent, the target residency for
76 This property is required on POWER9 and absent on POWER8.
82 required on POWER9 and absent on POWER8.
111 is an optional property on POWER8 and is absent on
118 property on POWER8 and is absent on POWER9.
/Linux-v6.1/Documentation/devicetree/bindings/sound/
Dalc5623.txt11 Register. If absent or has the value of 0, the
15 Control Register. If absent or has value 0, the
Dwlf,wm8962.yaml62 If absent, the default should be the register default.
69 A list of GPIO configuration register values. If absent, no
Dwm8994.txt44 - wlf,gpio-cfg : A list of GPIO configuration register values. If absent,
50 WM8958. If absent the register defaults will be used.
Dfsl,sai.yaml83 first for the fifo data. If this property is absent,
105 If both fsl,sai-asynchronous and fsl,sai-synchronous-rx are absent, the
Dwm8741.txt16 DIFF in register R8 (MODE_CONTROL_2). If absent, the default is 0, shall be:
Dtdm-slot.txt18 to specify an explicit mapping of the channels and the slots. If it's absent
Dpcm512x.txt20 is absent the device will be configured to clock from BCLK. If pll-in
/Linux-v6.1/arch/arc/include/asm/
Dasserts.h17 * - panic in case of OPT enabled but corresponding HW absent.
27 * - panic in case of OPT enabled but corresponding HW absent.
/Linux-v6.1/Documentation/devicetree/bindings/arm/
Dl2c2x0.yaml186 (forcibly enable), property absent (retain settings set by firmware)
193 <1> (forcibly enable), property absent (retain settings set by
201 disable), <1> (forcibly enable), property absent (OS specific behavior,
208 <1> (forcibly enable), property absent (OS specific behavior,
/Linux-v6.1/Documentation/ABI/testing/
Dsysfs-class-mtd107 absent, ram, rom, nor, nand, mlc-nand, dataflash, ubi, unknown
145 or exceeds this value, -EUCLEAN is returned. Otherwise, absent
170 returned, absent a hard error.
233 This attribute is absent on flash devices, so it can be used
/Linux-v6.1/Documentation/devicetree/bindings/bus/
Dsimple-pm-bus.yaml46 # Required if power-domains is absent, optional otherwise
49 # Required if clocks is absent, optional otherwise
/Linux-v6.1/drivers/mtd/chips/
Dmap_absent.c3 * Common code to handle absent "placeholder" devices
113 MODULE_DESCRIPTION("Placeholder MTD chip driver for 'absent' chips");
/Linux-v6.1/Documentation/driver-api/
Dslimbus.rst84 Similarly, SLIMbus devices 'report absent' when they go down. A 'device_down'
85 callback notifies the driver when the device reports absent and its logical
/Linux-v6.1/include/uapi/linux/
Datmsap.h109 /* absent */
118 /* absent */
/Linux-v6.1/include/linux/
Dslimbus.h31 * @SLIM_DEVICE_STATUS_DOWN: Slim device is absent or not reported yet.
79 * - The device reports absent, or the bus goes down.
/Linux-v6.1/Documentation/devicetree/bindings/spi/
Dspi-bcm63xx-hsspi.txt14 if absent.
Dspi-bcm63xx.txt14 if absent.
/Linux-v6.1/Documentation/devicetree/bindings/display/
Dmulti-inno,mi0283qt.txt13 - absent: IM=x101 3-wire 9-bit data serial interface
/Linux-v6.1/Documentation/devicetree/bindings/gpio/
Dgpio_atmel.txt17 - #gpio-lines: Number of gpio if absent 32.
/Linux-v6.1/Documentation/devicetree/bindings/display/panel/
Dpanel-edp.yaml99 hpd-absent-delay-ms:
106 and hpd-absent-delay was 200 ms then we'd do a fixed 80 ms delay and
/Linux-v6.1/drivers/media/usb/pwc/
Dpwc-timon.h26 will be chosen (unless the decompressor is absent). Sometimes there are only

12345678910