1 /* SPDX-License-Identifier: GPL-2.0+ */ 2 /* 3 * Copyright (c) 2011 Samsung Electronics Co., Ltd 4 * http://www.samsung.com 5 */ 6 7 #ifndef __LINUX_MFD_SEC_CORE_H 8 #define __LINUX_MFD_SEC_CORE_H 9 10 /* Macros to represent minimum voltages for LDO/BUCK */ 11 #define MIN_3000_MV 3000000 12 #define MIN_2500_MV 2500000 13 #define MIN_2000_MV 2000000 14 #define MIN_1800_MV 1800000 15 #define MIN_1500_MV 1500000 16 #define MIN_1400_MV 1400000 17 #define MIN_1000_MV 1000000 18 19 #define MIN_900_MV 900000 20 #define MIN_850_MV 850000 21 #define MIN_800_MV 800000 22 #define MIN_750_MV 750000 23 #define MIN_650_MV 650000 24 #define MIN_600_MV 600000 25 #define MIN_500_MV 500000 26 27 /* Ramp delay in uV/us */ 28 #define RAMP_DELAY_12_MVUS 12000 29 30 /* Macros to represent steps for LDO/BUCK */ 31 #define STEP_50_MV 50000 32 #define STEP_25_MV 25000 33 #define STEP_12_5_MV 12500 34 #define STEP_6_25_MV 6250 35 36 struct gpio_desc; 37 38 enum sec_device_type { 39 S5M8767X, 40 S2MPA01, 41 S2MPS11X, 42 S2MPS13X, 43 S2MPS14X, 44 S2MPS15X, 45 S2MPU02, 46 }; 47 48 /** 49 * struct sec_pmic_dev - s2m/s5m master device for sub-drivers 50 * @dev: Master device of the chip 51 * @pdata: Platform data populated with data from DTS 52 * or board files 53 * @regmap_pmic: Regmap associated with PMIC's I2C address 54 * @i2c: I2C client of the main driver 55 * @device_type: Type of device, matches enum sec_device_type 56 * @irq_base: Base IRQ number for device, required for IRQs 57 * @irq: Generic IRQ number for device 58 * @irq_data: Runtime data structure for IRQ controller 59 * @wakeup: Whether or not this is a wakeup device 60 */ 61 struct sec_pmic_dev { 62 struct device *dev; 63 struct sec_platform_data *pdata; 64 struct regmap *regmap_pmic; 65 struct i2c_client *i2c; 66 67 unsigned long device_type; 68 int irq; 69 struct regmap_irq_chip_data *irq_data; 70 }; 71 72 int sec_irq_init(struct sec_pmic_dev *sec_pmic); 73 void sec_irq_exit(struct sec_pmic_dev *sec_pmic); 74 int sec_irq_resume(struct sec_pmic_dev *sec_pmic); 75 76 struct sec_platform_data { 77 struct sec_regulator_data *regulators; 78 struct sec_opmode_data *opmode; 79 int num_regulators; 80 81 int buck_gpios[3]; 82 int buck_ds[3]; 83 unsigned int buck2_voltage[8]; 84 bool buck2_gpiodvs; 85 unsigned int buck3_voltage[8]; 86 bool buck3_gpiodvs; 87 unsigned int buck4_voltage[8]; 88 bool buck4_gpiodvs; 89 90 int buck_default_idx; 91 int buck_ramp_delay; 92 93 bool buck2_ramp_enable; 94 bool buck3_ramp_enable; 95 bool buck4_ramp_enable; 96 97 int buck2_init; 98 int buck3_init; 99 int buck4_init; 100 /* Whether or not manually set PWRHOLD to low during shutdown. */ 101 bool manual_poweroff; 102 /* Disable the WRSTBI (buck voltage warm reset) when probing? */ 103 bool disable_wrstbi; 104 }; 105 106 /** 107 * sec_regulator_data - regulator data 108 * @id: regulator id 109 * @initdata: regulator init data (contraints, supplies, ...) 110 */ 111 struct sec_regulator_data { 112 int id; 113 struct regulator_init_data *initdata; 114 struct device_node *reg_node; 115 struct gpio_desc *ext_control_gpiod; 116 }; 117 118 /* 119 * sec_opmode_data - regulator operation mode data 120 * @id: regulator id 121 * @mode: regulator operation mode 122 */ 123 struct sec_opmode_data { 124 int id; 125 unsigned int mode; 126 }; 127 128 /* 129 * samsung regulator operation mode 130 * SEC_OPMODE_OFF Regulator always OFF 131 * SEC_OPMODE_ON Regulator always ON 132 * SEC_OPMODE_LOWPOWER Regulator is on in low-power mode 133 * SEC_OPMODE_SUSPEND Regulator is changed by PWREN pin 134 * If PWREN is high, regulator is on 135 * If PWREN is low, regulator is off 136 */ 137 138 enum sec_opmode { 139 SEC_OPMODE_OFF, 140 SEC_OPMODE_ON, 141 SEC_OPMODE_LOWPOWER, 142 SEC_OPMODE_SUSPEND, 143 }; 144 145 #endif /* __LINUX_MFD_SEC_CORE_H */ 146
