| /Linux-v6.6/arch/mips/mm/ |
| D | tlb-r4k.c | 395 unsigned long wired; in add_wired_entry()
408 wired = num_wired_entries(); in add_wired_entry()
409 write_c0_wired(wired + 1); in add_wired_entry()
410 write_c0_index(wired); in add_wired_entry()
466 unsigned long wired; in add_temporary_entry() local
475 wired = num_wired_entries(); in add_temporary_entry()
476 if (--temp_tlb_entry < wired) { in add_temporary_entry()
559 int wired = current_cpu_data.tlbsize - ntlb; in tlb_init() local
560 write_c0_wired(wired); in tlb_init()
561 write_c0_index(wired-1); in tlb_init()
|
| D | tlb-r3k.c | 223 static unsigned long wired = 0; in add_wired_entry() local
225 if (wired < 8) { in add_wired_entry()
235 write_c0_index(wired); in add_wired_entry()
236 wired++; /* BARRIER */ in add_wired_entry()
|
| D | init.c | 149 unsigned int wired; in kunmap_coherent() local
154 wired = num_wired_entries() - 1; in kunmap_coherent()
155 write_c0_wired(wired); in kunmap_coherent()
156 write_c0_index(wired); in kunmap_coherent()
157 write_c0_entryhi(UNIQUE_ENTRYHI(wired)); in kunmap_coherent()
|
| /Linux-v6.6/arch/mips/include/asm/ |
| D | tlb.h | 16 unsigned int wired = read_c0_wired(); in num_wired_entries() local
19 wired &= MIPSR6_WIRED_WIRED; in num_wired_entries()
21 return wired; in num_wired_entries()
|
| /Linux-v6.6/Documentation/devicetree/bindings/interrupt-controller/ |
| D | img,pdc-intc.txt | 82 * An SoC peripheral that is wired through the PDC.
85 // The interrupt controller that this device is wired to.
96 * An interrupt generating device that is wired to a SysWake pin.
99 // The interrupt controller that this device is wired to.
|
| D | marvell,sei.txt | 10 AP and is wired while a second set comes from the CPs by the mean of
19 - #interrupt-cells: number of cells to define an SEI wired interrupt
|
| D | open-pic.txt | 81 * An interrupt generating device that is wired to an Open PIC.
89 // The interrupt controller that this device is wired to.
|
| D | openrisc,ompic.txt | 12 - interrupts : Specifies the interrupt line to which the ompic is wired.
|
| D | marvell,gicp.txt | 6 located in the Marvell CP110 to turn wired interrupts inside the CP
|
| D | atmel,aic.txt | 37 * An interrupt generating device that is wired to an AIC.
|
| /Linux-v6.6/Documentation/devicetree/bindings/media/ |
| D | st-rc.txt | 12 be present iff the rx pins are wired up.
15 be present iff the tx pins are wired up.
|
| /Linux-v6.6/arch/arm/boot/dts/st/ |
| D | ste-href-tvk1281618-r2.dtsi | 101 * the falling edge if they could be wired together.
122 * the falling edge if they could be wired together.
159 * the falling edge if they could be wired together.
|
| /Linux-v6.6/arch/arm/boot/dts/ti/omap/ |
| D | dra74x-p.dtsi | 24 /* MCAN interrupts are hard-wired to irqs 67, 68 */
|
| D | omap4-mcpdm.dtsi | 5 * Only include this file if your board has pdmclk wired from the
|
| /Linux-v6.6/arch/arm/boot/dts/socionext/ |
| D | uniphier-ld6b.dtsi | 19 /* UART3 unavailable: the pads are not wired to the package balls */
|
| /Linux-v6.6/arch/arm/boot/dts/marvell/ |
| D | armada-385-db-ap.dts | 43 * This bus is wired to two EEPROM
78 * wired to the mini-USB connector
|
| /Linux-v6.6/arch/arm/boot/dts/allwinner/ |
| D | sun8i-r16-nintendo-nes-classic.dts | 51 /* VBUS is always on because it is wired to the power supply */
|
| /Linux-v6.6/Documentation/ABI/testing/ |
| D | sysfs-bus-iio-adc-envelope-detector | 8 of a comparator wired to an interrupt pin. Like so::
|
| /Linux-v6.6/Documentation/hwmon/ |
| D | w83773g.rst | 27 The chip is wired over I2C/SMBus and specified over a temperature
|
| D | smsc47m192.rst | 57 the motherboard has this input wired to VID4.
87 would typically be wired to the diode inside the CPU)
|
| D | via686a.rst | 80 in which case the sensor inputs will not be wired. This is the case of
84 not wired for hardware monitoring.
|
| /Linux-v6.6/Documentation/devicetree/bindings/soc/fsl/ |
| D | guts.txt | 23 is wired to reset upon setting the HRESET_REQ bit in this register).
|
| /Linux-v6.6/arch/mips/kvm/ |
| D | vz.c | 2463 unsigned int wired = read_gc0_wired(); in kvm_vz_vcpu_save_wired() local
2468 wired &= MIPSR6_WIRED_WIRED; in kvm_vz_vcpu_save_wired()
2469 if (wired > vcpu->arch.wired_tlb_limit) { in kvm_vz_vcpu_save_wired()
2470 tlbs = krealloc(vcpu->arch.wired_tlb, wired * in kvm_vz_vcpu_save_wired()
2474 wired = vcpu->arch.wired_tlb_limit; in kvm_vz_vcpu_save_wired()
2477 vcpu->arch.wired_tlb_limit = wired; in kvm_vz_vcpu_save_wired()
2481 if (wired) in kvm_vz_vcpu_save_wired()
2483 kvm_vz_save_guesttlb(vcpu->arch.wired_tlb, 0, wired); in kvm_vz_vcpu_save_wired()
2485 for (i = wired; i < vcpu->arch.wired_tlb_used; ++i) { in kvm_vz_vcpu_save_wired()
2491 vcpu->arch.wired_tlb_used = wired; in kvm_vz_vcpu_save_wired()
|
| /Linux-v6.6/Documentation/devicetree/bindings/soc/fsl/cpm_qe/qe/ |
| D | pincfg.txt | 16 - open_drain : indicates the pin is normal or wired-OR:
|
| /Linux-v6.6/Documentation/devicetree/bindings/sound/ |
| D | adi,adau1701.txt | 7 and ADDR1, as wired in hardware.
|
