| /Linux-v6.6/drivers/ata/ |
| D | pata_artop.c | 130 u8 ultra; in artop6210_set_piomode() local
135 pci_read_config_byte(pdev, 0x54, &ultra); in artop6210_set_piomode()
136 ultra &= ~(3 << (2 * dn)); in artop6210_set_piomode()
137 pci_write_config_byte(pdev, 0x54, ultra); in artop6210_set_piomode()
183 u8 ultra; in artop6260_set_piomode() local
188 pci_read_config_byte(pdev, 0x44 + ap->port_no, &ultra); in artop6260_set_piomode()
189 ultra &= ~(7 << (4 * adev->devno)); /* One nibble per drive */ in artop6260_set_piomode()
190 pci_write_config_byte(pdev, 0x44 + ap->port_no, ultra); in artop6260_set_piomode()
209 u8 ultra; in artop6210_set_dmamode() local
219 pci_read_config_byte(pdev, 0x54, &ultra); in artop6210_set_dmamode()
[all …]
|
| D | pata_serverworks.c | 232 u8 ultra; in serverworks_set_dmamode() local
237 pci_read_config_byte(pdev, 0x56 + ap->port_no, &ultra); in serverworks_set_dmamode()
238 ultra &= ~(0x0F << (adev->devno * 4)); in serverworks_set_dmamode()
243 ultra |= (adev->dma_mode - XFER_UDMA_0) in serverworks_set_dmamode()
251 pci_write_config_byte(pdev, 0x56 + ap->port_no, ultra); in serverworks_set_dmamode()
|
| D | pata_sil680.c | 169 u16 multi, ultra; in sil680_set_dmamode() local
174 pci_read_config_word(pdev, ua, &ultra); in sil680_set_dmamode()
177 ultra &= ~0x3F; in sil680_set_dmamode()
185 ultra |= ultra_table[scsc][adev->dma_mode - XFER_UDMA_0]; in sil680_set_dmamode()
193 pci_write_config_word(pdev, ua, ultra); in sil680_set_dmamode()
|
| D | pata_ali.c | 170 …oid ali_program_modes(struct ata_port *ap, struct ata_device *adev, struct ata_timing *t, u8 ultra) in ali_program_modes() argument
195 udma |= ultra << shift; in ali_program_modes()
|
| /Linux-v6.6/arch/arm64/boot/dts/marvell/ |
| D | armada-3720-espressobin-ultra.dts | 15 compatible = "globalscale,espressobin-ultra", "globalscale,espressobin",
48 label = "ebin-ultra:blue:led1";
52 label = "ebin-ultra:green:led2";
56 label = "ebin-ultra:red:led3";
60 label = "ebin-ultra:yellow:led4";
|
| D | Makefile | 7 dtb-$(CONFIG_ARCH_MVEBU) += armada-3720-espressobin-ultra.dtb
|
| /Linux-v6.6/arch/arm64/boot/dts/freescale/ |
| D | imx8mq-zii-ultra-zest.dts | 8 #include "imx8mq-zii-ultra.dtsi"
12 compatible = "zii,imx8mq-ultra-zest", "zii,imx8mq-ultra", "fsl,imx8mq";
|
| D | imx8mq-zii-ultra-rmb3.dts | 8 #include "imx8mq-zii-ultra.dtsi"
12 compatible = "zii,imx8mq-ultra-rmb3", "zii,imx8mq-ultra", "fsl,imx8mq";
|
| D | Makefile | 134 dtb-$(CONFIG_ARCH_MXC) += imx8mq-zii-ultra-rmb3.dtb
135 dtb-$(CONFIG_ARCH_MXC) += imx8mq-zii-ultra-zest.dtb
|
| /Linux-v6.6/drivers/gpu/drm/bridge/analogix/ |
| D | Kconfig | 11 ANX6345 is an ultra-low power Full-HD DisplayPort/eDP
24 ANX78XX is an ultra-low power Full-HD SlimPort transmitter
43 ANX7625 is an ultra-low power 4K mobile HD transmitter
|
| /Linux-v6.6/arch/sparc/mm/ |
| D | Makefile | 8 obj-$(CONFIG_SPARC64) += ultra.o tlb.o tsb.o
|
| /Linux-v6.6/drivers/net/ethernet/8390/ |
| D | Makefile | 17 obj-$(CONFIG_ULTRA) += smc-ultra.o 8390.o
|
| D | Kconfig | 181 operating systems. The Linux smc-ultra driver has a work-around for
186 will be called smc-ultra.
|
| /Linux-v6.6/Documentation/devicetree/bindings/rtc/ |
| D | abracon,abx80x.txt | 1 Abracon ABX80X I2C ultra low power RTC/Alarm chip
|
| /Linux-v6.6/Documentation/devicetree/bindings/leds/ |
| D | leds-lm3601x.txt | 3 The LM3601X are ultra-small LED flash drivers that
|
| D | leds-lm3692x.txt | 3 The LM3692x is an ultra-compact, highly efficient,
|
| /Linux-v6.6/drivers/power/reset/ |
| D | Makefile | 19 obj-$(CONFIG_POWER_RESET_ODROID_GO_ULTRA_POWEROFF) += odroid-go-ultra-poweroff.o
|
| /Linux-v6.6/drivers/scsi/ |
| D | qlogicpti.c | 315 if (qpti->ultra) { in qlogicpti_set_hostdev_defaults()
363 qpti->ultra = 1; in qlogicpti_reset_hardware()
367 qpti->ultra = 0; in qlogicpti_reset_hardware()
537 qpti->ultra = 1; in qlogicpti_load_firmware()
541 qpti->ultra = 0; in qlogicpti_load_firmware()
1369 (qpti->ultra ? "Ultra" : "Fast"), in qpti_sbus_probe()
|
| D | BusLogic.h | 508 bool ultra:1; /* Byte 13 Bit 3 */ member
1001 bool ultra:1; member
|
| D | qlogicpti.h | 368 char differential, ultra, clock; member
|
| /Linux-v6.6/arch/arm/boot/dts/allwinner/ |
| D | sun8i-r40-feta40i.dtsi | 3 // Based on the sun8i-r40-bananapi-m2-ultra.dts, which is:
|
| D | sun8i-r40-oka40i-c.dts | 3 // Based on the sun8i-r40-bananapi-m2-ultra.dts, which is:
|
| /Linux-v6.6/Documentation/driver-api/ |
| D | scsi.rst | 19 Although the old parallel (fast/wide/ultra) SCSI bus has largely fallen
291 attributes for traditional (fast/wide/ultra) SCSI busses.
336 Parallel (fast/wide/ultra) SCSI, USB, SATA, SAS, Fibre Channel,
|
| /Linux-v6.6/drivers/scsi/aic7xxx/ |
| D | aic7xxx_osm.c | 585 int ultra = 0; in ahc_linux_target_alloc() local
590 ultra = 1; in ahc_linux_target_alloc()
592 ultra = 1; in ahc_linux_target_alloc()
595 if(ultra && (flags & CFXFER) == 0x04) { in ahc_linux_target_alloc()
596 ultra = 0; in ahc_linux_target_alloc()
601 scsirate = (flags & CFXFER) | (ultra ? 0x8 : 0); in ahc_linux_target_alloc()
604 maxsync = ultra ? AHC_SYNCRATE_ULTRA : in ahc_linux_target_alloc()
|
| /Linux-v6.6/scripts/ |
| D | Makefile.lib | 546 cmd_zstd22 = cat $(real-prereqs) | $(ZSTD) -22 --ultra > $@
549 cmd_zstd22_with_size = { cat $(real-prereqs) | $(ZSTD) -22 --ultra; $(size_append); } > $@
|
