Searched refs:reception (Results 1 – 25 of 60) sorted by relevance
123
| /Linux-v6.6/Documentation/ABI/stable/ |
| D | firewire-cdev | 28 - Isochronous stream transmission and reception 29 - Asynchronous stream transmission and reception 31 - PHY packet transmission and reception 37 - Bus reset initiation, bus reset event reception 42 link layers, reception of inbound requests to such 55 - PHY packet transmission and reception 80 request reception, or PHY packet reception. Always use a read 83 of all event types and for which ioctls affect reception of 87 Allocate a DMA buffer for isochronous reception or transmission 91 prot = at least PROT_READ for reception and at least PROT_WRITE [all …]
|
| /Linux-v6.6/Documentation/networking/device_drivers/can/freescale/ |
| D | flexcan.rst | 10 On/off RTR frames reception 27 As reception of RTR frames is part of the CAN standard, all flexcan 28 cores come up in a mode where RTR reception is possible.
|
| /Linux-v6.6/drivers/staging/pi433/Documentation/ |
| D | pi433.txt | 9 (www.pi433.de). It supports transmission and reception. It can be opened 10 by multiple applications for transmission and reception. While transmit 12 application asking for reception will block out all other applications 40 b) reception 43 reception there is only one configuration set. 44 As soon as an application sets a request for receiving a telegram, the reception 47 receiver) is reached. Until this hasn't happened, the reception can be 52 read. So also for reception it is possible to receive more data than the hardware 181 If this value is exceeded, a reception cycle starts
|
| /Linux-v6.6/net/rxrpc/ |
| D | Kconfig | 40 bool "Inject delay into packet reception" 43 Say Y here to inject a delay into packet reception, allowing an
|
| /Linux-v6.6/Documentation/ABI/testing/ |
| D | sysfs-class-led-trigger-netdev | 55 Signal reception of data on the named network device. 57 If set to 0 (default), the LED will not blink on reception. 60 in interval to signal reception.
|
| /Linux-v6.6/Documentation/devicetree/bindings/sound/ |
| D | sirf-audio-port.txt | 11 named "tx") and one for reception (should be named "rx").
|
| D | brcm,bcm2835-i2s.txt | 12 named "tx") and one for reception (should be named "rx").
|
| /Linux-v6.6/Documentation/userspace-api/media/v4l/ |
| D | ext-ctrls-fm-rx.rst | 24 Enables/disables RDS reception by the radio tuner 71 Configures the de-emphasis value for reception. A de-emphasis filter
|
| D | vidioc-g-tuner.rst | 246 - Stereo audio reception is supported. 361 stereo reception the driver shall fall back to ``MODE_MONO``. 369 bilingual audio or SAP, or their reception is not supported the 375 bilingual audio or SAP, or their reception is not supported the
|
| D | metafmt-uvc.rst | 40 reception of the payload
|
| D | dev-rds.rst | 129 reception of this block.
|
| /Linux-v6.6/Documentation/userspace-api/media/rc/ |
| D | lirc-set-wideband-receiver.rst | 42 reduced range of reception.
|
| /Linux-v6.6/Documentation/userspace-api/media/ |
| D | intro.rst | 29 Internet reception via one of the several digital tv standards. While it is
|
| /Linux-v6.6/Documentation/networking/ |
| D | bareudp.rst | 56 sending packet buffer to the bareudp device for transmission. On reception the
|
| D | can.rst | 164 transmission and reception of media dependent frames. Due to the 166 may be delayed by the reception of a high prio CAN frame. To 201 errors may be selected. The reception of error messages is disabled 395 at the reception of a CAN frame. 472 The reception of CAN frames using CAN_RAW sockets can be controlled 507 To disable the reception of CAN frames on the selected CAN_RAW socket: 522 reception time. To reduce the number of checks that need to be performed 599 needs. The reception of the CAN frames on the same socket that was 611 Note that reception of a socket's own CAN frames are subject to the same 929 is activated directly - even without a former CAN frame reception. [all …]
|
| D | ieee802154.rst | 82 code via plain sk_buffs. On skb reception skb->cb must contain additional
|
| /Linux-v6.6/drivers/usb/atm/ |
| D | Kconfig | 62 and reception as module parameters. You may need to initialize
|
| /Linux-v6.6/arch/sh/include/mach-kfr2r09/mach/ |
| D | partner-jet-setup.txt | 32 LIST "RF frequency and improved reception sensitivity."
|
| /Linux-v6.6/Documentation/admin-guide/media/ |
| D | remote-controller.rst | 27 switch the protocol and to test the reception of scan codes;
|
| /Linux-v6.6/tools/bpf/bpftool/Documentation/ |
| D | bpftool-net.rst | 73 **xdpoffload** - Offload XDP. runs directly on NIC on each packet reception;
|
| /Linux-v6.6/Documentation/networking/device_drivers/can/ |
| D | can327.rst | 214 reception mode on its own and can327 will fall back to "``AT MA``" 232 we don't poll it as it would force us to interrupt reception mode.
|
| /Linux-v6.6/Documentation/userspace-api/media/dvb/ |
| D | fe_property_parameters.rst | 284 whether the channel is in partial reception mode or not. 407 Hierarchical reception in ISDB-T is achieved by enabling or disabling 412 If the channel is in the partial reception mode
|
| /Linux-v6.6/drivers/net/wireless/legacy/ |
| D | wl3501.h | 481 u8 reception; member
|
| /Linux-v6.6/drivers/media/ |
| D | Kconfig | 113 support radio reception. Disabling this option will
|
| /Linux-v6.6/Documentation/userspace-api/media/drivers/ |
| D | omap3isp-uapi.rst | 25 triggered exactly when the reception of the first line of the frame starts
|
123