Home
last modified time | relevance | path

Searched refs:multiplexing (Results 1 – 25 of 47) sorted by relevance

12

/Linux-v6.6/arch/arm/mach-davinci/
DKconfig34 bool "DAVINCI multiplexing support"
38 Pin multiplexing support for DAVINCI boards. If your bootloader
39 sets the multiplexing correctly, say N. Otherwise, or if unsure,
46 Makes the multiplexing functions print out a lot of debug info.
48 multiplexing registers.
55 to change the pin multiplexing setup. When there are no warnings
/Linux-v6.6/Documentation/devicetree/bindings/pinctrl/
Dcortina,gemini-pinctrl.txt4 see further arm/gemini.txt. It is a purely group-based multiplexing pin
12 Subnodes of the pin controller contain pin control multiplexing set-up
15 Please refer to pinctrl-bindings.txt for generic pin multiplexing nodes
Dbrcm,bcm2835-gpio.txt46 The BCM2835 pin configuration and multiplexing supports the generic bindings.
60 Legacy pin configuration and multiplexing binding:
61 *** (Its use is deprecated, use generic multiplexing and configuration
Dste,nomadik.txt22 pin multiplexing node layout from the standard pin control bindings
25 Required pin multiplexing subnode properties:
29 group that will be combined with the function to form a multiplexing
Dnxp,lpc1850-scu.txt9 The lpc1850-scu driver uses the generic pin multiplexing and generic pin
Dpinctrl-bindings.txt3 Hardware modules that control pin multiplexing or configuration parameters
103 == Generic pin multiplexing node content ==
Dpinctrl-st.txt4 PIO multiplexing block. Each pin supports GPIO functionality (ALT0)
11 ST pinctrl driver controls PIO multiplexing block and also interacts with
Dste,abx500.txt11 ST Ericsson's pin configuration nodes use the generic pin multiplexing
Dfsl,imx-pinctrl.txt5 multiplexing the PAD input/output signals. For each PAD there are up to
Dfsl,mxs-pinctrl.txt4 has 32 pins. Each pin has 4 multiplexing functions, and generally, the 4th
/Linux-v6.6/arch/arm/mach-omap1/
DKconfig42 bool "OMAP multiplexing support"
45 Pin multiplexing support for OMAP boards. If your bootloader
46 sets the multiplexing correctly, say N. Otherwise, or if unsure,
53 Makes the multiplexing functions print out a lot of debug info.
55 multiplexing registers.
63 to change the pin multiplexing setup. When there are no warnings
/Linux-v6.6/net/kcm/
DKconfig10 for multiplexing messages of a message based application
/Linux-v6.6/drivers/net/ethernet/qualcomm/rmnet/
DKconfig12 for handling data in the multiplexing and aggregation protocol (MAP)
/Linux-v6.6/Documentation/devicetree/bindings/i2c/
Di2c-demux-pinctrl.txt3 This binding describes an I2C bus demultiplexer that uses pin multiplexing to
4 route the I2C signals, and represents the pin multiplexing configuration using
/Linux-v6.6/Documentation/driver-api/tty/
Dn_gsm.rst7 This line discipline implements the GSM 07.10 multiplexing protocol
111 Note that after closing the physical port the modem is still in multiplexing
114 a disconnect command frame manually before initializing the multiplexing mode
/Linux-v6.6/Documentation/devicetree/bindings/fsi/
Dfsi-master-gpio.txt12 - mux-gpios = <gpio-descriptor>; : GPIO for pin multiplexing with other
Dfsi-master-ast-cf.txt14 - mux-gpios = <gpio-descriptor>; : GPIO for pin multiplexing with other
/Linux-v6.6/drivers/video/fbdev/
Dcirrusfb.c361 int multiplexing; member
485 cinfo->multiplexing = 0; in cirrusfb_check_pixclock()
507 cinfo->multiplexing = 1; in cirrusfb_check_pixclock()
511 cinfo->multiplexing = 1; in cirrusfb_check_pixclock()
736 if (cinfo->multiplexing) { in cirrusfb_set_par_foo()
841 if (cinfo->multiplexing) in cirrusfb_set_par_foo()
955 cinfo->multiplexing ? in cirrusfb_set_par_foo()
1000 if (cinfo->multiplexing) in cirrusfb_set_par_foo()
1029 cinfo->multiplexing ? in cirrusfb_set_par_foo()
1073 if (cinfo->multiplexing) in cirrusfb_set_par_foo()
/Linux-v6.6/Documentation/driver-api/media/
Ddtv-core.rst27 .. [#f1] Some standards use TCP/IP for multiplexing data, like DVB-H (an
/Linux-v6.6/Documentation/driver-api/80211/
Dmac80211-advanced.rst154 :doc: Spatial multiplexing power save
/Linux-v6.6/drivers/pinctrl/
DKconfig15 bool "Support pin multiplexing controllers" if COMPILE_TEST
75 supports pin function multiplexing as well as pin bias and drive
268 provides pin config functions multiplexing. GPIO pin pull-up,
/Linux-v6.6/Documentation/userspace-api/media/v4l/
Dfunc-select.rst13 v4l2-select - Synchronous I/O multiplexing
/Linux-v6.6/drivers/i2c/muxes/
DKconfig83 multiplexer that uses the pinctrl subsystem, i.e. pin multiplexing.
/Linux-v6.6/tools/perf/Documentation/
Dperf-stat.txt357 group will be eliminated reducing event multiplexing and making it so
359 group is that the group may require multiplexing and so accuracy for a
360 small group that need not have multiplexing is lowered. This option
368 multiplexing. This option disables the adding of threshold expression
/Linux-v6.6/Documentation/networking/caif/
Dlinux_caif.rst117 - CFMUX CAIF Mux layer. Handles multiplexing between multiple

12