Searched refs:logic (Results 1 – 25 of 246) sorted by relevance
12345678910
/Linux-v6.6/arch/arm/boot/dts/arm/ |
D | vexpress-v2p-ca9.dts | 216 /* Test Chip internal logic voltage */ 225 /* PL310, L2 cache, RAM cell supply (not PL310 logic) */ 234 /* Cortex-A9 system supply, Cores, MPEs, SCU and PL310 logic */ 261 /* Local board supply for miscellaneous logic external to the Test Chip */ 270 /* PL310, L2 cache, RAM cell supply (not PL310 logic) */ 277 /* Cortex-A9 system supply, Cores, MPEs, SCU and PL310 logic */ 284 /* PL310, L2 cache, RAM cell supply (not PL310 logic) */ 291 /* Cortex-A9 system supply, Cores, MPEs, SCU and PL310 logic */
|
/Linux-v6.6/Documentation/driver-api/media/ |
D | dtv-core.rst | 10 implement the digital demux logic (either in software or in hardware); 14 - A tuner driver that implements the logic which commands the part of 19 - A demodulator driver (a.k.a "demod") that implements the logic which
|
/Linux-v6.6/Documentation/misc-devices/ |
D | bh1770glc.rst | 22 interface and interrupt logic. In principle they can run on their own, 25 ALS produces 16 bit lux values. The chip contains interrupt logic to produce 57 Uses counting logic 110 Uses counting logic
|
D | apds990x.rst | 55 RW - enable / disable chip. Uses counting logic 109 RW - enable / disable proximity - uses counting logic
|
/Linux-v6.6/Documentation/devicetree/bindings/usb/ |
D | dwc3-st.txt | 1 ST DWC3 glue logic 4 This driver controls the glue logic used to configure the dwc3 core on 9 - reg : glue logic base address and USB syscfg ctrl register offset
|
/Linux-v6.6/Documentation/driver-api/media/drivers/ |
D | pvrusb2.rst | 76 pvrusb2-audio.[ch] - This is glue logic that resides between this 101 pvrusb2-eeprom.[ch] - This is glue logic that resides between this 107 device. It is a crude echo of corresponding logic in ivtv, 125 pvrusb2-hdw.c - This module implements all the various bits of logic 130 pvrusb2-i2c-chips-\*.c - These modules implement the glue logic to 134 implement just the logic that makes sense for a pure V4L 156 glue logic which is coordinated by pvrusb2-hdw, doled out by 180 pvrusb2-tuner.[ch] - This is glue logic that resides between this 194 pvrusb2-video-\*.[ch] - This is glue logic that resides between this
|
/Linux-v6.6/Documentation/watchdog/ |
D | mlx-wdt.rst | 11 Mellanox watchdog device is implemented in a programmable logic device. 36 with new programmer logic device. 66 Programmable logic device registers have little-endian order.
|
/Linux-v6.6/Documentation/devicetree/bindings/media/i2c/ |
D | tvp7002.txt | 25 Under normal operation, the field ID output is set to logic 1 for an odd field 26 (field 1) and set to logic 0 for an even field (field 0).
|
/Linux-v6.6/Documentation/networking/dsa/ |
D | bcm_sf2.rst | 84 hardware contains logic which will assert/de-assert link states accordingly for 101 - disabling packet processing logic 105 - turning off RGMII data processing logic when the link goes down 111 MAC controller wake-on logic. Whenever Wake-on-LAN is requested, an intersection
|
/Linux-v6.6/Documentation/peci/ |
D | peci.rst | 32 value is logic '0' or logic '1'. PECI Wire also includes variable data
|
/Linux-v6.6/drivers/gpu/drm/logicvc/ |
D | Kconfig | 11 DRM display driver for the logiCVC programmable logic block from Xylon
|
/Linux-v6.6/drivers/net/ethernet/mellanox/mlxfw/ |
D | Kconfig | 10 flashing common logic.
|
/Linux-v6.6/Documentation/mm/ |
D | page_table_check.rst | 25 Double mapping detection logic 73 won't break the logic used in the page table check.
|
/Linux-v6.6/Documentation/driver-api/gpio/ |
D | intro.rst | 39 several dozen of them. Programmable logic devices (like FPGAs) can easily 56 input de-glitch/debounce logic, sometimes with software controls. 99 logic (low=true) perspective this is a "wire-OR". 115 The same logic can be applied to emulate open source signaling, by driving the
|
/Linux-v6.6/Documentation/networking/device_drivers/ethernet/altera/ |
D | altera_tse.rst | 39 developer wishes to support their own soft DMA logic and driver support. Any 85 interrupt is driven by the transmit DMA logic. The driver handles the transmit 91 The driver will post receive buffers to the receive DMA logic during driver 93 underlying DMA logic (MSGDMA is able queue receive buffers, SGDMA is not able 94 to queue receive buffers to the SGDMA receive logic). When a packet is 95 received, the DMA logic generates an interrupt. The driver handles a receive 96 interrupt by obtaining the DMA receive logic status, reaping receive
|
/Linux-v6.6/drivers/dma/dw-edma/ |
D | Kconfig | 18 Provides a glue-logic between the Synopsys DesignWare
|
/Linux-v6.6/drivers/nfc/st21nfca/ |
D | Kconfig | 7 HCI logic and hooks into the NFC kernel APIs. Physical layers will
|
/Linux-v6.6/Documentation/ABI/testing/ |
D | sysfs-devices-system-xen_cpu | 20 logic restrictions and assumptions.
|
/Linux-v6.6/Documentation/devicetree/bindings/clock/ |
D | nvidia,tegra124-dfll.txt | 17 - registers for the DFLL control logic. 18 - registers for the I2C output logic. 25 - soc: Clock source for the DFLL control logic.
|
D | marvell,pxa168.txt | 12 region. There are 3 places in SOC has clock control logic:
|
D | marvell,pxa910.txt | 12 region. There are 4 places in SOC has clock control logic:
|
/Linux-v6.6/Documentation/target/ |
D | tcm_mod_builder.rst | 17 1) Generate new API callers for drivers/target/target_core_fabric_configs.c logic 25 using drivers/target/target_core_fabric_lib.c logic. 26 4) NOP API calls for all other Data I/O path and fabric dependent attribute logic
|
/Linux-v6.6/Documentation/power/ |
D | suspend-and-interrupts.rst | 65 That may involve turning on a special signal handling logic within the platform 76 those purposes. Namely, enable_irq_wake() turns on the platform's logic for 78 turns that logic off. 111 any special interrupt handling logic for it to work.
|
/Linux-v6.6/Documentation/devicetree/bindings/pwm/ |
D | nxp,pca9685-pwm.txt | 12 - invert (bool): boolean to enable inverted logic
|
/Linux-v6.6/Documentation/devicetree/bindings/soc/xilinx/ |
D | xlnx,vcu.txt | 8 and programmable logic. Also provides the list of register set to configure
|
12345678910