| /Linux-v6.6/drivers/gpu/drm/bridge/ |
| D | ti-tfp410.c | 52 struct tfp410 *dvi = drm_connector_to_tfp410(connector); in tfp410_get_modes() local
56 if (dvi->next_bridge->ops & DRM_BRIDGE_OP_EDID) { in tfp410_get_modes()
57 edid = drm_bridge_get_edid(dvi->next_bridge, connector); in tfp410_get_modes()
90 struct tfp410 *dvi = drm_connector_to_tfp410(connector); in tfp410_connector_detect() local
92 return drm_bridge_detect(dvi->next_bridge); in tfp410_connector_detect()
106 struct tfp410 *dvi; in tfp410_hpd_work_func() local
108 dvi = container_of(work, struct tfp410, hpd_work.work); in tfp410_hpd_work_func()
110 if (dvi->bridge.dev) in tfp410_hpd_work_func()
111 drm_helper_hpd_irq_event(dvi->bridge.dev); in tfp410_hpd_work_func()
116 struct tfp410 *dvi = arg; in tfp410_hpd_callback() local
[all …]
|
| /Linux-v6.6/drivers/video/fbdev/omap2/omapfb/displays/ |
| D | connector-dvi.c | 58 return in->ops.dvi->connect(in, dssdev); in dvic_connect()
69 in->ops.dvi->disconnect(in, dssdev); in dvic_disconnect()
84 in->ops.dvi->set_timings(in, &ddata->timings); in dvic_enable()
86 r = in->ops.dvi->enable(in); in dvic_enable()
103 in->ops.dvi->disable(in); in dvic_disable()
117 in->ops.dvi->set_timings(in, timings); in dvic_set_timings()
134 return in->ops.dvi->check_timings(in, timings); in dvic_check_timings()
|
| D | Makefile | 5 obj-$(CONFIG_FB_OMAP2_CONNECTOR_DVI) += connector-dvi.o
|
| D | encoder-tfp410.c | 200 dssdev->ops.dvi = &tfp410_dvi_ops; in tfp410_probe()
|
| /Linux-v6.6/arch/arm/boot/dts/ti/omap/ |
| D | omap3-sb-t35.dtsi | 37 dvi0: dvi-connector {
38 compatible = "dvi-connector";
39 label = "dvi";
|
| D | am335x-sbc-t335.dts | 48 timing1: dvi { /* 1024x768p60 */
158 dvi-ena-hog {
162 line-name = "dvi-enable";
|
| D | omap3-overo-common-dvi.dtsi | 95 compatible = "dvi-connector";
96 label = "dvi";
|
| D | omap3-overo-summit-common.dtsi | 11 #include "omap3-overo-common-dvi.dtsi"
|
| D | omap3-overo-tobi-common.dtsi | 11 #include "omap3-overo-common-dvi.dtsi"
|
| D | omap3-igep0020-common.dtsi | 88 compatible = "dvi-connector";
89 label = "dvi";
|
| D | omap3-beagle-xm.dts | 129 compatible = "dvi-connector";
130 label = "dvi";
|
| D | omap3-devkit8000-common.dtsi | 95 compatible = "dvi-connector";
96 label = "dvi";
|
| D | omap3-beagle.dts | 116 compatible = "dvi-connector";
117 label = "dvi";
|
| /Linux-v6.6/arch/arm/boot/dts/nxp/imx/ |
| D | imx53-cx9020.dts | 49 dvi-connector {
50 compatible = "dvi-connector";
61 dvi-converter {
|
| D | imx25-eukrea-mbimxsd25-baseboard-dvi-svga.dts | 10 …compatible = "eukrea,mbimxsd25-baseboard-dvi-svga", "eukrea,mbimxsd25-baseboard", "eukrea,cpuimx25…
|
| D | imx25-eukrea-mbimxsd25-baseboard-dvi-vga.dts | 10 …compatible = "eukrea,mbimxsd25-baseboard-dvi-vga", "eukrea,mbimxsd25-baseboard", "eukrea,cpuimx25"…
|
| D | imx51-babbage.dts | 116 dvi-connector {
117 compatible = "dvi-connector";
127 dvi-encoder {
|
| /Linux-v6.6/drivers/video/fbdev/via/ |
| D | Makefile | 8 viafb-y :=viafbdev.o hw.o via_i2c.o dvi.o lcd.o ioctl.o accel.o \
|
| D | ioctl.h | 71 unsigned short dvi:1; member
|
| /Linux-v6.6/Documentation/arch/arm/omap/ |
| D | dss.rst | 226 dvi=/sys/devices/platform/omapdss/display1
250 w=`cat $dvi/timings | cut -d "," -f 2 | cut -d "/" -f 1`
251 h=`cat $dvi/timings | cut -d "," -f 3 | cut -d "/" -f 1`
256 # at this point you have to switch the dvi/lcd dip-switch from the omap board
257 echo "dvi" > $mgr0/display
258 echo "1" > $dvi/enabled
317 "dvi:800x400MR-24@60". See drivers/video/modedb.c.
|
| /Linux-v6.6/drivers/gpu/drm/tegra/ |
| D | hdmi.c | 84 bool dvi; member
1183 if (!hdmi->dvi) { in tegra_hdmi_encoder_disable()
1296 hdmi->dvi = !tegra_output_is_hdmi(output); in tegra_hdmi_encoder_enable()
1297 if (!hdmi->dvi) { in tegra_hdmi_encoder_enable()
1305 hdmi->dvi = true; in tegra_hdmi_encoder_enable()
1317 if (!hdmi->dvi) in tegra_hdmi_encoder_enable()
1322 if (!hdmi->dvi) { in tegra_hdmi_encoder_enable()
1419 if (!hdmi->dvi) { in tegra_hdmi_encoder_enable()
1472 if (hdmi->pixel_clock && !hdmi->dvi) in tegra_hdmi_hw_params()
1806 hdmi->dvi = false; in tegra_hdmi_probe()
|
| /Linux-v6.6/Documentation/devicetree/bindings/display/ti/ |
| D | ti,omap-dss.txt | 129 compatible = "dvi-connector";
130 label = "dvi";
|
| /Linux-v6.6/Documentation/ |
| D | dontdiff | 11 *.dvi
|
| /Linux-v6.6/arch/arm/boot/dts/arm/ |
| D | vexpress-v2m-rs1.dtsi | 362 dvi-transmitter@39 {
379 dvi-transmitter@60 {
|
| D | vexpress-v2m.dtsi | 282 dvi-transmitter@39 {
312 dvi-transmitter@60 {
|
