Searched refs:driven (Results 1 – 25 of 151) sorted by relevance
1234567
| /Linux-v6.6/Documentation/devicetree/bindings/display/ |
| D | truly,nt35597.txt | 20 - ports: This device has two video ports driven by two DSIs. Their connections
23 - port@0: DSI input port driven by master DSI
24 - port@1: DSI input port driven by secondary DSI
|
| /Linux-v6.6/drivers/leds/rgb/ |
| D | Kconfig | 12 and driven by a controller that doesn't have multi-color support.
18 tristate "PWM driven multi-color LED Support"
21 This option enables support for PWM driven monochrome LEDs that are
|
| /Linux-v6.6/arch/arm64/boot/dts/freescale/ |
| D | imx8mm-venice-gw72xx-0x-rs422.dtso | 7 * - GPIO4_0 rs485_en needs to be driven high (active)
8 * - GPIO4_2 rs485_hd needs to be driven low (in-active)
|
| D | imx8mm-venice-gw72xx-0x-rs485.dtso | 7 * - GPIO4_0 rs485_en needs to be driven high (active)
8 * - GPIO4_2 rs485_hd needs to be driven high (active)
|
| D | imx8mm-venice-gw73xx-0x-rs422.dtso | 7 * - GPIO4_0 rs485_en needs to be driven high (active)
8 * - GPIO4_2 rs485_hd needs to be driven low (in-active)
|
| D | imx8mm-venice-gw73xx-0x-rs485.dtso | 7 * - GPIO4_0 rs485_en needs to be driven high (active)
8 * - GPIO4_2 rs485_hd needs to be driven high (active)
|
| D | imx8mm-venice-gw72xx-0x-rs232-rts.dtso | 6 * - GPIO4_0 rs485_en needs to be driven low (in-active)
|
| D | imx8mm-venice-gw73xx-0x-rs232-rts.dtso | 6 * - GPIO4_0 rs485_en needs to be driven low (in-active)
|
| /Linux-v6.6/Documentation/hwmon/ |
| D | tc654.rst | 32 Setting pwm1_mode to 1 will cause the pwm output to be driven based on
34 driven based on the Vin input.
|
| /Linux-v6.6/Documentation/devicetree/bindings/soc/fsl/cpm_qe/qe/ |
| D | pincfg.txt | 18 0 = The pin is actively driven as an output
20 driven active-low, otherwise it is three-stated.
|
| /Linux-v6.6/Documentation/driver-api/thermal/ |
| D | nouveau_thermal.rst | 75 Your fan can be driven in different modes:
78 * 1: The fan can be driven in manual (use pwm1 to change the speed);
79 * 2; The fan is driven automatically depending on the temperature.
|
| /Linux-v6.6/Documentation/devicetree/bindings/input/ |
| D | gpio-matrix-keypad.txt | 1 * GPIO driven matrix keypad device tree bindings
3 GPIO driven matrix keypad is used to interface a SoC with a matrix keypad.
|
| /Linux-v6.6/Documentation/sound/soc/ |
| D | clocking.rst | 12 Every audio subsystem is driven by a master clock (sometimes referred to as MCLK
24 The Digital Audio Interface is usually driven by a Bit Clock (often referred to
|
| D | dai.rst | 15 The bit clock (BCLK) is always driven by the CODEC (usually 12.288MHz) and the
16 frame (FRAME) (usually 48kHz) is always driven by the controller. Each AC97
|
| /Linux-v6.6/Documentation/peci/ |
| D | peci.rst | 30 bit with a driven, rising edge from an idle near zero volts. The
31 duration of the signal driven high allows to determine whether the bit
|
| /Linux-v6.6/Documentation/networking/ |
| D | team.rst | 7 Team devices are driven from userspace via libteam library which is here:
|
| /Linux-v6.6/Documentation/devicetree/bindings/pinctrl/ |
| D | marvell,dove-pinctrl.txt | 64 pmu-nc Pin not driven by any PM function
65 pmu-low Pin driven low (0)
66 pmu-high Pin driven high (1)
|
| /Linux-v6.6/drivers/parport/ |
| D | BUGS-parport | 7 software-driven mode in ieee1284_ops.c
|
| /Linux-v6.6/Documentation/features/debug/stackprotector/ |
| D | arch-support.txt | 4 # description: arch supports compiler driven stack overflow protection
|
| /Linux-v6.6/Documentation/ABI/testing/ |
| D | sysfs-driver-fsi-master-gpio | 9 where the FSI bus is driven externally (for example, by
|
| /Linux-v6.6/Documentation/driver-api/gpio/ |
| D | intro.rst | 49 options about how that value is driven, so that for example only one
50 value might be driven, supporting "wire-OR" and similar schemes for the
95 level is actually driven), or "open source" (where only the high signal level is
96 driven) signaling. That term applies to CMOS transistors; "open collector" is
|
| /Linux-v6.6/fs/configfs/ |
| D | Kconfig | 3 tristate "Userspace-driven configuration filesystem"
|
| /Linux-v6.6/Documentation/devicetree/bindings/misc/ |
| D | xlnx,sd-fec.txt | 28 driven with a fixed value and is not present on the device, a value of 1
35 driven with a fixed value and is not present on the device, a value of 1
|
| /Linux-v6.6/arch/sh/drivers/ |
| D | Kconfig | 18 framework that allows for sysfs driven switch status reporting.
|
| /Linux-v6.6/Documentation/devicetree/bindings/input/touchscreen/ |
| D | ektf2127.txt | 8 ektf2127's wake input. This needs to be driven high
|
1234567
