Searched refs:decrease (Results 1 – 25 of 63) sorted by relevance
123
| /Linux-v6.6/drivers/gpu/drm/amd/display/modules/inc/ |
| D | mod_info_packet.h | 68 struct frame_duration_op decrease; member
|
| /Linux-v6.6/drivers/gpu/drm/amd/display/modules/info_packet/ |
| D | info_packet.c | 577 info_packet->sb[4] = (param->increase.support << 6 | param->decrease.support << 7); in mod_build_adaptive_sync_infopacket_v2()
579 info_packet->sb[6] = param->decrease.frame_duration_hex; in mod_build_adaptive_sync_infopacket_v2()
|
| /Linux-v6.6/drivers/ras/ |
| D | Kconfig | 22 a failed system increases, then availability will decrease.
|
| /Linux-v6.6/arch/arm/boot/dts/st/ |
| D | stm32mp135f-dk.dts | 339 st,decrease-hs-slew-rate;
353 st,decrease-hs-slew-rate;
|
| /Linux-v6.6/arch/arm/boot/dts/intel/socfpga/ |
| D | socfpga_cyclone5_socdk.dts | 96 * adjust the falling times to decrease the i2c frequency to 50Khz
|
| D | socfpga_arria5_socdk.dts | 92 * adjust the falling times to decrease the i2c frequency to 50Khz
|
| D | socfpga_arria10_socdk.dtsi | 131 * adjust the falling times to decrease the i2c frequency to 50Khz
|
| /Linux-v6.6/Documentation/hwmon/ |
| D | sht15.rst | 51 measurement and decrease power consumption, while losing on precision.
|
| D | w83793.rst | 91 if tempX_input < thermal_cruiseX - toleranceX, the chip will decrease
|
| D | w83792d.rst | 159 (3) If the temperature goes below the low limit, PWM duty cycle will decrease
|
| /Linux-v6.6/Documentation/leds/ |
| D | leds-mt6370-rgb.rst | 16 can increase or decrease the brightness of the RGB LED via an I2C interface.
|
| /Linux-v6.6/Documentation/sound/soc/ |
| D | pops-clicks.rst | 52 is heard when the gain increase or decrease changes the mean audio signal
|
| /Linux-v6.6/Documentation/scheduler/ |
| D | schedutil.rst | 39 will decrease to reflect the fraction of time each task spends on the CPU
103 filter to instantly increase and only decay on decrease.
|
| /Linux-v6.6/fs/ocfs2/ |
| D | Kconfig | 78 this option for debugging only as it is likely to decrease
|
| /Linux-v6.6/arch/mips/cavium-octeon/ |
| D | Kconfig | 10 workarounds will cause a slight decrease in performance on
|
| /Linux-v6.6/drivers/net/ethernet/wiznet/ |
| D | Kconfig | 70 Performance may decrease compared to explicitly selected bus mode.
|
| /Linux-v6.6/arch/sparc/lib/ |
| D | M7memcpy.S | 278 sub %o2, 16, %o2 ! decrease count by 16
291 subcc %o2, 8, %o2 ! decrease count by 8
372 subcc %o2, 8, %o2 ! decrease count by 8
386 subcc %o2, 4, %o2 ! decrease count by 4
618 subcc %o3, 8, %o3 ! decrease count by 8
|
| /Linux-v6.6/Documentation/networking/ |
| D | net_dim.rst | 52 compared in a similar fashion - increase == "better" and decrease == "worse".
55 increase in the interrupt rate is considered "worse" and a decrease is
|
| D | xfrm_device.rst | 19 can radically increase throughput and decrease CPU utilization. The XFRM
|
| /Linux-v6.6/Documentation/driver-api/media/ |
| D | v4l2-device.rst | 128 decrease the refcount manually as well by calling:
|
| /Linux-v6.6/Documentation/PCI/ |
| D | sysfs-pci.rst | 79 echoed into it, it will then return '5'. Echoing a '0' into it will decrease
|
| /Linux-v6.6/Documentation/ABI/testing/ |
| D | sysfs-fs-f2fs | 183 needs to decrease this value to reduce the space overhead.
520 decrease. If you write "0" here, you can initialize
528 decrease. If you write "0" here, you can initialize
536 doesn't decrease. If you write "0" here, you can initialize
|
| /Linux-v6.6/Documentation/RCU/ |
| D | UP.rst | 27 element B. This situation can greatly decrease the life expectancy of
|
| /Linux-v6.6/Documentation/driver-api/thermal/ |
| D | cpu-idle-cooling.rst | 37 decrease. Acting on the idle state duration or the idle cycle
|
| /Linux-v6.6/Documentation/mm/ |
| D | zsmalloc.rst | 263 objects and release zspages. In these cases, it is recommended to decrease
|
123
