Searched refs:creates (Results 1 – 25 of 301) sorted by relevance
12345678910>>...13
5 The zram module creates RAM based block devices named /dev/zram<id>26 zram01.sh: creates general purpose ram disks with ext4 filesystems27 zram02.sh: creates block device for swap
35 the driver creates an out-fence to be able to notify, through37 Out-fences are fences that the driver creates.47 When a driver needs to send an out-fence userspace it creates a sync_file.
32 The driver creates the following sysfs entries for systems management59 The driver creates the following sysfs entries for systems management software
27 The line above creates three chips. The first one will expose 8 lines,42 Each mockup chip creates its own subdirectory in /sys/kernel/debug/gpio-mockup/.
7 The pktcdvd module (packet writing driver) creates
29 creates a request for setting a new-powercap. The
17 Description: Writing a number 'N' to this file creates the number of46 Description: Writing a number 'N' to this file creates the number of108 Description: Writing a number 'N' to this file creates the number of122 Description: Writing a number 'N' to this file creates the number of144 Description: Writing a number 'N' to this file creates the number of266 Description: Writing a number 'N' to this file creates the number of
59 HTE subsystem creates debugfs attributes at ``/sys/kernel/debug/hte/``.60 It also creates line/signal-related debugfs attributes at
22 This driver creates a new I2C bus for any DS28E17 device detected. I2C buses65 The driver creates sysfs files /sys/bus/w1/devices/19-<id>/speed and
7 The sample driver creates an mdev device that simulates a serial port over a PCI12 This step creates a dummy device, /sys/devices/virtual/mtty/mtty/
327 * The PMIC on V1.0A HW generates 1.6V instead of 1.8V which creates336 * The PMIC on V1.0A HW generates 1.6V instead of 1.8V which creates
10 * conditional of P0()'s if-statement creates a control dependency
28 The network device creates two net-device interfaces.
26 Device driver creates a "health reporter" per each error/health type.58 To handle devlink health diagnose and health dump requests, devlink creates a
6 is a fixed divider that creates a 1 kHz clock from the 32 kHz osc.
15 NILFS2 creates a number of checkpoints every few seconds or per
17 its capabilities, and creates device files accordingly.
13 Creating a net_cls cgroups instance creates a net_cls.classid file.
30 magic value. This driver does that and creates subpartitions for108 header and creates up to two partitions, kernel and rootfs.138 This driver reads partitions table, parses it and creates MTD
59 The driver creates two debugfs entries per device.
59 The "mkdir func1" above creates the pci-epf-ntb function device that will91 The PCI endpoint framework also automatically creates a sub-directory in the
55 The "mkdir func1" above creates the pci-epf-ntb function device that will87 The PCI endpoint framework also automatically creates a sub-directory in the
23 This misc driver creates /dev/pci-endpoint-test.<num> for every
69 basically creates the pipes that enable virtualization management117 is loaded. It first creates and initializes the CRQ. Next, an exchange of149 state, EIO will be returned for the ioctl(). The device driver creates a
17 The new jack code creates embedded jack kcontrols for each jack that
