| /Linux-v6.6/drivers/pinctrl/ |
| D | pinctrl-ocelot.c | 370 LUTON_P(14, SI, PHY_LED);
371 LUTON_P(15, SI, PHY_LED);
372 LUTON_P(16, SI, PHY_LED);
446 SERVAL_P(8, SI, NONE, NONE);
447 SERVAL_P(9, SI, MD, NONE);
448 SERVAL_P(10, SI, MD, NONE);
528 OCELOT_P(8, SI, TWI_SCL_M, IRQ0_OUT);
529 OCELOT_P(9, SI, TWI_SCL_M, IRQ1_OUT);
536 OCELOT_P(16, TWI, NONE, SI);
537 OCELOT_P(17, TWI, TWI_SCL_M, SI);
[all …]
|
| /Linux-v6.6/Documentation/spi/ |
| D | spi-lm70llp.rst | 46 D7 9 --> SI/O 5
48 Select 13 <-- SI/O 1
51 Note that since the LM70 uses a "3-wire" variant of SPI, the SI/SO pin
55 devices might share the same SI/SO pin.
64 shows that the SI/O line from the LM70 chip is connected to the base of a
68 Interpreting this circuit, when the LM70 SI/O line is High (or tristate
71 connector. When SI/O is Low (driven by the LM70 or the host) on the other
|
| /Linux-v6.6/drivers/ata/ |
| D | sata_sis.c | 54 { PCI_VDEVICE(SI, 0x0180), sis_180 }, /* SiS 964/180 */
55 { PCI_VDEVICE(SI, 0x0181), sis_180 }, /* SiS 964/180 */
56 { PCI_VDEVICE(SI, 0x0182), sis_180 }, /* SiS 965/965L */
57 { PCI_VDEVICE(SI, 0x0183), sis_180 }, /* SiS 965/965L */
58 { PCI_VDEVICE(SI, 0x1182), sis_180 }, /* SiS 966/680 */
59 { PCI_VDEVICE(SI, 0x1183), sis_180 }, /* SiS 966/966L/968/680 */
|
| D | pata_sis.c | 891 { PCI_VDEVICE(SI, 0x5513), }, /* SiS 5513 */
892 { PCI_VDEVICE(SI, 0x5518), }, /* SiS 5518 */
893 { PCI_VDEVICE(SI, 0x1180), }, /* SiS 1180 */
|
| D | ahci.c | 553 { PCI_VDEVICE(SI, 0x1184), board_ahci }, /* SiS 966 */
554 { PCI_VDEVICE(SI, 0x1185), board_ahci }, /* SiS 968 */
555 { PCI_VDEVICE(SI, 0x0186), board_ahci }, /* SiS 968 */
|
| /Linux-v6.6/tools/perf/arch/x86/tests/ |
| D | regs_load.S | 8 #define SI 4 * 8 macro
36 movq %rsi, SI(%rdi)
72 movl %esi, SI(%edi)
|
| /Linux-v6.6/drivers/gpu/drm/amd/amdgpu/ |
| D | Kconfig | 38 bool "Enable amdgpu support for SI parts"
42 for SI (Southern Islands) asics.
44 SI is already supported in radeon. Experimental support for SI
|
| /Linux-v6.6/arch/m68k/lib/ |
| D | ashldi3.c | 21 typedef int SItype __mode(SI);
22 typedef unsigned int USItype __mode(SI);
|
| D | lshrdi3.c | 21 typedef int SItype __mode(SI);
22 typedef unsigned int USItype __mode(SI);
|
| D | ashrdi3.c | 21 typedef int SItype __mode(SI);
22 typedef unsigned int USItype __mode(SI);
|
| D | muldi3.c | 68 typedef int SItype __mode(SI);
69 typedef unsigned int USItype __mode(SI);
|
| /Linux-v6.6/Documentation/devicetree/bindings/powerpc/nintendo/ |
| D | gamecube.txt | 88 1.f) The Serial Interface (SI) node
91 The SI is a proprietary serial interface used normally to control gamepads.
97 - reg : should contain the SI registers location and length
98 - interrupts : should contain the SI interrupt
|
| D | wii.txt | 67 1.d) The Serial Interface (SI) node
70 The SI is a proprietary serial interface used normally to control gamepads.
76 - reg : should contain the SI registers location and length
77 - interrupts : should contain the SI interrupt
|
| /Linux-v6.6/tools/perf/arch/x86/util/ |
| D | unwind-libdw.c | 28 dwarf_regs[6] = REG(SI); in libdw__arch_set_initial_registers()
37 dwarf_regs[4] = REG(SI); in libdw__arch_set_initial_registers()
|
| D | perf_regs.c | 21 SMPL_REG(SI, PERF_REG_X86_SI),
|
| /Linux-v6.6/Documentation/devicetree/bindings/soc/fsl/cpm_qe/ |
| D | qe.txt | 102 * Serial Interface Block (SI)
104 The SI manages the routing of eight TDM lines to the QE block serial drivers
110 - reg : Address range of SI register set.
121 store the routing entries of SI
126 - reg : Address range of SI RAM.
|
| /Linux-v6.6/include/math-emu/ |
| D | soft-fp.h | 193 typedef int SItype __attribute__((mode(SI)));
195 typedef unsigned int USItype __attribute__((mode(SI)));
|
| /Linux-v6.6/lib/ |
| D | locking-selftest-spin.h | 12 #define INIT SI
|
| /Linux-v6.6/lib/crypto/mpi/ |
| D | mpi-internal.h | 218 typedef int SItype __attribute__ ((mode(SI)));
219 typedef unsigned int USItype __attribute__ ((mode(SI)));
|
| /Linux-v6.6/arch/powerpc/xmon/ |
| D | ppc-opc.c | 644 #define SI SHO + 1 macro
649 #define SISIGNOPT SI + 1
3038 {"tdlgti", OPTO(2,TOLGT), OPTO_MASK, PPC64, PPCVLE, {RA, SI}},
3039 {"tdllti", OPTO(2,TOLLT), OPTO_MASK, PPC64, PPCVLE, {RA, SI}},
3040 {"tdeqi", OPTO(2,TOEQ), OPTO_MASK, PPC64, PPCVLE, {RA, SI}},
3041 {"tdlgei", OPTO(2,TOLGE), OPTO_MASK, PPC64, PPCVLE, {RA, SI}},
3042 {"tdlnli", OPTO(2,TOLNL), OPTO_MASK, PPC64, PPCVLE, {RA, SI}},
3043 {"tdllei", OPTO(2,TOLLE), OPTO_MASK, PPC64, PPCVLE, {RA, SI}},
3044 {"tdlngi", OPTO(2,TOLNG), OPTO_MASK, PPC64, PPCVLE, {RA, SI}},
3045 {"tdgti", OPTO(2,TOGT), OPTO_MASK, PPC64, PPCVLE, {RA, SI}},
[all …]
|
| /Linux-v6.6/drivers/gpu/drm/amd/display/ |
| D | Kconfig | 33 Choose this option to enable new AMD DC support for SI asics
|
| /Linux-v6.6/arch/um/os-Linux/skas/ |
| D | process.c | 41 R(SI); in ptrace_reg_name()
65 R(SI); in ptrace_reg_name()
|
| /Linux-v6.6/arch/x86/um/ |
| D | signal.c | 176 GETREG(SI, si); in copy_sc_from_user()
255 PUTREG(SI, si); in copy_sc_to_user()
|
| /Linux-v6.6/Documentation/driver-api/media/drivers/ |
| D | vidtv.rst | 109 How often to send SI packets. Default: 40ms.
157 EN 300 468: Specification for Service Information (SI) in DVB
|
| /Linux-v6.6/Documentation/driver-api/ |
| D | ipmi.rst | 44 manual), choose the 'IPMI SI handler' option. A driver also exists
60 situation, you need to read the section below named 'The SI Driver' or
388 The SI Driver
391 The SI driver allows KCS, BT, and SMIC interfaces to be configured
|
