Searched refs:SDRAM (Results 1 – 25 of 52) sorted by relevance
123
/Linux-v6.6/arch/arm/mach-pxa/ |
D | sleep.S | 55 @ prepare SDRAM refresh settings 59 @ enable SDRAM self-refresh mode 96 @ prepare SDRAM refresh settings 100 @ enable SDRAM self-refresh mode 107 @ We keep the change-down close to the actual suspend on SDRAM 160 @ external accesses after SDRAM is put in self-refresh mode 166 @ put SDRAM into self-refresh
|
/Linux-v6.6/Documentation/devicetree/bindings/arm/altera/ |
D | socfpga-sdram-edac.txt | 1 Altera SOCFPGA SDRAM Error Detection & Correction [EDAC] 2 The EDAC accesses a range of registers in the SDRAM controller. 7 - interrupts : Should contain the SDRAM ECC IRQ in the
|
D | socfpga-sdram-controller.txt | 1 Altera SOCFPGA SDRAM Controller 5 syscon is required by the Altera SOCFPGA SDRAM EDAC.
|
/Linux-v6.6/Documentation/driver-api/memory-devices/ |
D | ti-emif.rst | 4 TI EMIF SDRAM Controller Driver 29 SoCs. EMIF is an SDRAM controller that, based on its revision, 30 supports one or more of DDR2, DDR3, and LPDDR2 SDRAM protocols.
|
/Linux-v6.6/Documentation/devicetree/bindings/arm/omap/ |
D | dmm.txt | 4 SDRAM controllers (called EMIFs on OMAP). DMM manages various aspects of memory 5 accesses such as priority generation amongst initiators, configuration of SDRAM
|
/Linux-v6.6/Documentation/devicetree/bindings/memory-controllers/ti/ |
D | emif.txt | 1 * EMIF family of TI SDRAM controllers 3 EMIF - External Memory Interface - is an SDRAM controller used in 57 has capability for generating SDRAM temperature alerts
|
/Linux-v6.6/drivers/video/fbdev/omap/ |
D | Kconfig | 42 bool "Set DMA SDRAM access priority high" 46 (SDRAM) this will speed up graphics DMA operations.
|
/Linux-v6.6/arch/arm/boot/dts/renesas/ |
D | r7s9210-rza2mevb.dts | 8 * Hence the 64 MiB of SDRAM on the sub-board needs to be enabled, which has 22 * SW6 SW6-1 set to SDRAM 84 reg = <0x0c000000 0x04000000>; /* SDRAM */
|
/Linux-v6.6/Documentation/devicetree/bindings/fpga/ |
D | altera-fpga2sdram-bridge.txt | 1 Altera FPGA To SDRAM Bridge Driver
|
/Linux-v6.6/arch/arm/mach-lpc32xx/ |
D | suspend.S | 50 @ Wait for SDRAM busy status to go busy and then idle
|
/Linux-v6.6/Documentation/arch/arm/stm32/ |
D | stm32f429-overview.rst | 13 - External memory support through FMC controller (PSRAM, SDRAM, NOR, NAND)
|
D | stm32mp151-overview.rst | 19 - FMC controller to connect SDRAM, NOR and NAND memories
|
D | stm32h750-overview.rst | 13 - FMC controller to connect SDRAM, NOR and NAND memories
|
D | stm32mp13-overview.rst | 19 - FMC controller to connect SDRAM, NOR and NAND memories
|
D | stm32h743-overview.rst | 13 - FMC controller to connect SDRAM, NOR and NAND memories
|
D | stm32f746-overview.rst | 13 - FMC controller to connect SDRAM, NOR and NAND memories
|
D | stm32f769-overview.rst | 13 - FMC controller to connect SDRAM, NOR and NAND memories
|
/Linux-v6.6/arch/arm/mach-omap1/ |
D | sleep.S | 86 @ prepare to put SDRAM into self-refresh manually 156 @ Prepare to put SDRAM into self-refresh manually
|
/Linux-v6.6/Documentation/devicetree/bindings/clock/ |
D | mvebu-core-clock.txt | 30 3 = hclk (SDRAM Controller Internal Clock) 31 4 = dclk (SDRAM Interface Clock)
|
/Linux-v6.6/drivers/memory/ |
D | Kconfig | 20 Data from JEDEC specs for DDR SDRAM memories, 23 DDR SDRAM controllers. 96 SoCs. EMIF is an SDRAM controller that, based on its revision, 97 supports one or more of DDR2, DDR3, and LPDDR2 SDRAM protocols.
|
/Linux-v6.6/arch/arm/boot/dts/intel/ixp/ |
D | intel-ixp42x-welltech-epbx100.dts | 17 /* 64 MB SDRAM */
|
D | intel-ixp42x-gateway-7001.dts | 19 /* 32 MB SDRAM */
|
/Linux-v6.6/Documentation/admin-guide/perf/ |
D | alibaba_pmu.rst | 47 satisfying the SDRAM protocol timing requirements, transaction priorities, and 50 to and from the SDRAM. The driveway PMUs have hardware logic to gather
|
/Linux-v6.6/arch/arm/boot/dts/arm/ |
D | vexpress-v2p-ca9.dts | 243 /* DDR2 SDRAM and Test Chip DDR2 I/O supply */ 252 /* DDR2 SDRAM VTT termination voltage */
|
/Linux-v6.6/drivers/video/fbdev/aty/ |
D | mach64_ct.c | 354 else if (par->ram_type >= SDRAM) in aty_set_pll_ct() 469 case SDRAM: in aty_init_pll_ct() 557 if (M64_HAS(SDRAM_MAGIC_PLL) && (par->ram_type >= SDRAM)) in aty_init_pll_ct()
|
123