| /Linux-v6.6/arch/arm/boot/dts/samsung/ |
| D | exynos4412-itop-scp-core.dtsi | 179 op_mode = <1>; /* Normal Mode */
189 op_mode = <1>; /* Normal Mode */
197 op_mode = <1>; /* Normal Mode */
205 op_mode = <1>; /* Normal Mode */
210 op_mode = <0>; /* Always off Mode */
218 op_mode = <1>; /* Normal Mode */
226 op_mode = <1>; /* Normal Mode */
233 op_mode = <1>; /* Normal Mode */
240 op_mode = <1>; /* Normal Mode */
247 op_mode = <1>; /* Normal Mode */
[all …]
|
| D | exynos4412-origen.dts | 168 op_mode = <1>; /* Normal Mode */
176 op_mode = <1>; /* Normal Mode */
184 op_mode = <1>; /* Normal Mode */
192 op_mode = <1>; /* Normal Mode */
200 op_mode = <1>; /* Normal Mode */
208 op_mode = <1>; /* Normal Mode */
216 op_mode = <1>; /* Normal Mode */
224 op_mode = <1>; /* Normal Mode */
232 op_mode = <1>; /* Normal Mode */
240 op_mode = <1>; /* Normal Mode */
[all …]
|
| /Linux-v6.6/drivers/scsi/aic94xx/ |
| D | aic94xx_reg_def.h | 502 #define CSEQm_CIO_REG(Mode, Reg) \ argument
504 ((u32) (Mode) * CSEQ_MODE_PAGE_SIZE) + (u32) (Reg))
552 #define CMnSCBPTR(Mode) CSEQm_CIO_REG(Mode, MnSCBPTR) argument
554 #define CMnDDBPTR(Mode) CSEQm_CIO_REG(Mode, MnDDBPTR) argument
556 #define CMnSCRATCHPAGE(Mode) CSEQm_CIO_REG(Mode, MnSCRATCHPAGE) argument
564 #define CMnREQMBX(Mode) CSEQm_CIO_REG(Mode, 0x30) argument
571 #define CMnRSPMBX(Mode) CSEQm_CIO_REG(Mode, 0x34) argument
593 #define CMnINT(Mode) CSEQm_CIO_REG(Mode, 0x38) argument
604 #define CMnINTEN(Mode) CSEQm_CIO_REG(Mode, 0x3C) argument
663 #define CMnSCRATCH(Mode) CSEQm_CIO_REG(Mode, 0x1E0) argument
[all …]
|
| /Linux-v6.6/arch/mips/sgi-ip27/ |
| D | Kconfig | 8 bool "IP27 M-Mode"
11 in either N-Modes which allows for more nodes or M-Mode which allows
13 M-Mode, so choose M-mode here.
16 bool "IP27 N-Mode"
19 in either N-Modes which allows for more nodes or M-Mode which allows
21 M-Mode, so choose M-mode here.
|
| /Linux-v6.6/include/uapi/linux/ |
| D | cciss_defs.h | 61 BYTE Mode:2; /* b00 */ member
66 BYTE Mode:2; /* b01 */ member
72 BYTE Mode:2; /* b10 */ member
79 DWORD Mode:2; member
85 DWORD Mode:2; member
|
| /Linux-v6.6/Documentation/ABI/testing/ |
| D | sysfs-driver-typec-displayport | 18 Note. USB configuration does not equal to Exit Mode. It is
19 separate configuration defined in VESA DisplayPort Alt Mode on
29 VESA DisplayPort Alt Mode on USB Type-C Standard defines six
44 Note. As of VESA DisplayPort Alt Mode on USB Type-C Standard
55 VESA DisplayPort Alt Mode on USB Type-C Standard defines how
57 operating in DisplayPort Alt Mode. This is a read only node which
62 by VESA DisplayPort Alt Mode on USB Type-C Standard.
64 VESA DisplayPort Alt Mode on USB Type-C Standard.
|
| D | sysfs-driver-bd9571mwv-regulator | 5 Description: Read/write the current state of DDR Backup Mode, which controls
11 Backup Mode is enabled by default when available, as the
26 DDR Backup Mode must be explicitly enabled by the user,
|
| D | sysfs-platform-eeepc-laptop | 36 * 0 -> Super Performance Mode
37 * 1 -> High Performance Mode
38 * 2 -> Power Saving Mode
|
| D | sysfs-platform-ideapad-laptop | 16 * 0 -> Super Silent Mode
17 * 1 -> Standard Mode
19 * 4 -> Efficient Thermal Dissipation Mode
|
| /Linux-v6.6/drivers/usb/typec/altmodes/ |
| D | Kconfig | 3 menu "USB Type-C Alternate Mode drivers"
6 tristate "DisplayPort Alternate Mode driver"
9 DisplayPort USB Type-C Alternate Mode allows DisplayPort
17 tristate "NVIDIA Alternate Mode driver"
|
| /Linux-v6.6/Documentation/devicetree/bindings/hwmon/ |
| D | adc128d818.txt | 6 - Mode 0: 7 single-ended voltage readings (IN0-IN6),
8 - Mode 1: 8 single-ended voltage readings (IN0-IN7),
10 - Mode 2: 4 pseudo-differential voltage readings
13 - Mode 3: 4 single-ended voltage readings (IN0-IN3),
|
| /Linux-v6.6/Documentation/leds/ |
| D | leds-lm3556.rst | 18 Flash Mode
21 In Flash Mode, the LED current source(LED) provides 16 target current levels
47 Torch Mode
50 In Torch Mode, the current source(LED) is programmed via the CURRENT CONTROL
51 REGISTER(0x09).Torch Mode is activated by the ENABLE REGISTER(0x0A) or by the
74 Indicator Mode
|
| /Linux-v6.6/drivers/target/iscsi/ |
| D | Kconfig | 3 tristate "Linux-iSCSI.org iSCSI Target Mode Stack"
10 Target Mode Stack.
|
| /Linux-v6.6/Documentation/devicetree/bindings/spi/ |
| D | ti_qspi.txt | 23 parameters for Mode-0 and Mode-3 operations, which needs to be set up by
24 the bootloader (U-Boot). Default configuration only supports Mode-0
|
| /Linux-v6.6/Documentation/devicetree/bindings/sound/ |
| D | rt5645.txt | 41 1 : Mode-0 (VDD=3.3V), two port jack detection
42 2 : Mode-1 (VDD=3.3V), one port jack detection
43 3 : Mode-2 (VDD=1.8V), one port jack detection
|
| /Linux-v6.6/Documentation/sound/hd-audio/ |
| D | controls.rst | 11 Channel Mode
18 Auto-Mute Mode
55 Mic Jack Mode, Line Jack Mode, etc
104 Auto-Mute Mode
111 Channel Mode
|
| /Linux-v6.6/Documentation/devicetree/bindings/leds/ |
| D | leds-netxbig.txt | 10 Mode (gpio-ext bus), delay_on and delay_off.
15 - mode-addr: Mode register address on gpio-ext bus.
16 - mode-val: Mode to value mapping. Each entry is represented by two integers:
|
| /Linux-v6.6/sound/soc/intel/boards/ |
| D | Kconfig | 264 tristate "SKL with NAU88L25 and SSM4567 in I2S Mode"
278 tristate "SKL with NAU88L25 and MAX98357A in I2S Mode"
309 tristate "Broxton with DA7219 and MAX98357A/MAX98390 in I2S Mode"
355 tristate "KBL with RT5663 and MAX98927 in I2S Mode"
370 tristate "KBL with RT5663, RT5514 and MAX98927 in I2S Mode"
387 tristate "KBL with DA7219 and MAX98357A in I2S Mode"
397 tristate "KBL with DA7219 and MAX98927 in I2S Mode"
412 tristate "KBL with RT5660 in I2S Mode"
428 tristate "GLK with DA7219 and MAX98357A in I2S Mode"
440 tristate "GLK with RT5682 and MAX98357A in I2S Mode"
[all …]
|
| /Linux-v6.6/Documentation/userspace-api/media/v4l/ |
| D | metafmt-vsp1-hgo.rst | 44 .. flat-table:: VSP1 HGO Data - 64 Bins, Normal Mode (792 bytes)
95 .. flat-table:: VSP1 HGO Data - 64 Bins, Max Mode (264 bytes)
120 .. flat-table:: VSP1 HGO Data - 256 Bins, Normal Mode (1032 bytes)
145 .. flat-table:: VSP1 HGO Data - 256 Bins, Max Mode (1032 bytes)
|
| /Linux-v6.6/Documentation/networking/devlink/ |
| D | octeontx2.rst | 20 - Mode
36 - Mode
|
| D | mlx4.rst | 16 - Mode
32 - Mode
|
| /Linux-v6.6/Documentation/virt/kvm/devices/ |
| D | s390_flic.rst | 128 - KVM_S390_AIS_MODE_ALL: ALL-Interruptions Mode, i.e. airq injection
130 - KVM_S390_AIS_MODE_SINGLE: SINGLE-Interruption Mode, i.e. airq
148 __u8 simm; /* Single-Interruption-Mode mask */
149 __u8 nimm; /* No-Interruption-Mode mask *
152 simm contains Single-Interruption-Mode mask for all ISCs, nimm contains
153 No-Interruption-Mode mask for all ISCs. Each bit in simm and nimm corresponds
|
| /Linux-v6.6/Documentation/input/devices/ |
| D | cma3000_d0x.rst | 20 Motion Detect Mode:
24 Measurement Mode:
28 Free fall Mode:
|
| D | alps.rst | 42 versions, the response from the "Enter Command Mode" sequence must be
46 seem to be better differentiated by the EC Command Mode response.
48 Command Mode
104 ALPS Absolute Mode - Protocol Version 1
116 ALPS Absolute Mode - Protocol Version 2
150 packets for the DualPoint Stick + ALPS Absolute Mode packets for the
154 ALPS Absolute Mode - Protocol Version 3
202 ALPS Absolute Mode - Protocol Version 4
246 ALPS Absolute Mode - Protocol Version 5
271 ALPS Absolute Mode - Protocol Version 6
[all …]
|
| /Linux-v6.6/Documentation/hwmon/ |
| D | smsc47b397.rst | 108 1. Enter Configuration Mode
110 3. Exit Configuration Mode.
112 Enter Configuration Mode
118 Configuration Mode
137 Exit Configuration Mode
|
