Searched refs:I2S (Results 1 – 25 of 124) sorted by relevance
12345
| /Linux-v6.6/sound/soc/intel/avs/boards/ |
| D | Kconfig | 8 tristate "da7219 I2S board"
13 This adds support for AVS with DA7219 I2S codec configuration.
26 tristate "es8336 I2S board"
31 This adds support for AVS with ES8336 I2S codec configuration.
44 tristate "I2S test board"
46 This adds support for I2S test-board which can be used to verify
47 transfer over I2S interface with SSP loopback scenarios.
50 tristate "max98927 I2S board"
55 This adds support for AVS with MAX98927 I2S codec configuration.
60 tristate "max98357A I2S board"
[all …]
|
| /Linux-v6.6/sound/soc/cirrus/ |
| D | Kconfig | 8 the EP93xx I2S or AC97 interfaces.
11 tristate "I2S controller support for the Cirrus Logic EP93xx series"
15 the EP93xx I2S interface.
23 I2S controller on EP93xx seems to have undocumented HW issue.
24 Underflow of internal I2S controller FIFO could confuse the
26 until I2S is disabled. This option enables IRQ based watchdog
27 which disables and re-enables I2S in case of underflow and
41 Say Y or M here if you want to add support for I2S audio on the
|
| /Linux-v6.6/Documentation/devicetree/bindings/sound/ |
| D | img,i2s-in.txt | 1 Imagination Technologies I2S Input Controller
19 "rx" Single DMA channel used by all active I2S channels
21 - img,i2s-channels : Number of I2S channels instantiated in the I2S in block
25 - interrupts : Contains the I2S in interrupts. Depending on
27 or an interrupt per I2S channel. For the case where there is
31 - resets: Contains a phandle to the I2S in reset signal
|
| D | img,i2s-out.txt | 1 Imagination Technologies I2S Output Controller
20 "tx" Single DMA channel used by all active I2S channels
22 - img,i2s-channels : Number of I2S channels instantiated in the I2S out block
24 - resets: Contains a phandle to the I2S out reset signal
30 - interrupts : Contains the I2S out interrupts. Depending on
32 or an interrupt per I2S channel. For the case where there is
|
| D | ics43432.txt | 1 Invensense ICS-43432-compatible MEMS microphone with I2S output.
4 host connection is the I2S interface. Apart from requirements on clock
8 on the left or right channel of the I2S frame.
13 "cui,cmm-4030d-261": For the CUI CMM-4030D-261-I2S-TR
|
| D | xlnx,i2s.txt | 1 Device-Tree bindings for Xilinx I2S PL block
3 The IP supports I2S based playback/capture audio
9 Required property common to both I2S playback and capture:
12 - xlnx,num-channels: Number of I2S streams. Can be any of 1, 2, 3, 4.
|
| D | rockchip-max98090.txt | 6 - rockchip,i2s-controller: The phandle of the Rockchip I2S controller that's
20 rockchip,model = "ROCKCHIP-I2S";
29 rockchip,model = "ROCKCHIP-I2S";
37 rockchip,model = "ROCKCHIP-I2S";
|
| D | cdns,xtfpga-i2s.txt | 1 Bindings for I2S controller built into xtfpga Xtensa bitstreams.
7 - clocks: phandle to the clk used as master clock. I2S bus clock
|
| D | rockchip-rt5645.txt | 6 - rockchip,i2s-controller: The phandle of the Rockchip I2S controller that's
14 rockchip,model = "ROCKCHIP-I2S";
|
| /Linux-v6.6/sound/soc/intel/boards/ |
| D | Kconfig | 7 has an audio controller with a DSP and I2S or DMIC port, then
44 tristate "Haswell with RT5640 I2S codec"
88 tristate "Broadwell with RT286 I2S codec"
239 Up boards and provides access to I2S signals on the Low-Speed
251 tristate "SKL with RT286 I2S mode"
259 with RT286 I2S audio codec.
264 tristate "SKL with NAU88L25 and SSM4567 in I2S Mode"
272 This adds support for ASoC Onboard Codec I2S machine driver. This will
278 tristate "SKL with NAU88L25 and MAX98357A in I2S Mode"
286 This adds support for ASoC Onboard Codec I2S machine driver. This will
[all …]
|
| /Linux-v6.6/sound/soc/dwc/ |
| D | Kconfig | 3 tristate "Synopsys I2S Device Driver"
7 Say Y or M if you want to add support for I2S driver for
8 Synopsys designware I2S device. The device supports up to
12 bool "PCM PIO extension for I2S driver"
18 This functionality is specially suited for I2S devices that don't have
|
| /Linux-v6.6/sound/soc/loongson/ |
| D | Kconfig | 6 tristate "Loongson I2S-PCI Device Driver"
10 Say Y or M if you want to add support for I2S driver for
11 Loongson I2S controller.
22 loongson I2S controller.
25 loongson I2S controller.
|
| /Linux-v6.6/sound/soc/img/ |
| D | Kconfig | 8 tristate "Imagination I2S Input Device Driver"
12 Say Y or M if you want to add support for I2S in driver for
13 Imagination Technologies I2S in device.
16 tristate "Imagination I2S Output Device Driver"
20 Say Y or M if you want to add support for I2S out driver for
21 Imagination Technologies I2S out device.
|
| /Linux-v6.6/Documentation/sound/soc/ |
| D | dai.rst | 6 SoC controllers and portable audio CODECs today, namely AC97, I2S and PCM.
23 I2S chapter
26 I2S is a common 4 wire DAI used in HiFi, STB and portable devices. The Tx and
28 left/right clock (LRC) synchronise the link. I2S is flexible in that either the
35 I2S has several different operating modes:-
37 I2S
50 PCM is another 4 wire interface, very similar to I2S, which can support a more
|
| /Linux-v6.6/sound/soc/jz4740/ |
| D | Kconfig | 3 tristate "SoC Audio (I2S protocol) for Ingenic JZ4740 SoC"
9 Say Y if you want to use I2S protocol and I2S codec on Ingenic JZ4740
|
| /Linux-v6.6/sound/soc/rockchip/ |
| D | Kconfig | 11 tristate "Rockchip I2S Device Driver"
15 Say Y or M if you want to add support for I2S driver for
16 Rockchip I2S device. The device supports up to maximum of
20 tristate "Rockchip I2S/TDM Device Driver"
24 Say Y or M if you want to add support for the I2S/TDM driver for
25 Rockchip I2S/TDM devices, found in Rockchip SoCs. These devices
26 interface between the AHB bus and the I2S bus, and support up to a
|
| /Linux-v6.6/sound/soc/xilinx/ |
| D | Kconfig | 3 tristate "Audio support for the Xilinx I2S"
5 Select this option to enable Xilinx I2S Audio. This enables
6 I2S playback and capture using xilinx soft IP. In transmitter
|
| /Linux-v6.6/sound/soc/hisilicon/ |
| D | Kconfig | 3 tristate "Hisilicon I2S controller"
6 Hisilicon I2S
|
| /Linux-v6.6/sound/soc/bcm/ |
| D | Kconfig | 3 tristate "SoC Audio support for the Broadcom BCM2835 I2S module"
9 the BCM2835 I2S interface. You will also need
22 tristate "SoC Audio support for the Broadcom BCM63XX I2S module"
|
| /Linux-v6.6/sound/soc/google/ |
| D | Kconfig | 4 tristate "Google Chameleon v3 I2S device"
6 Enable support for the Google Chameleon v3 I2S device.
|
| /Linux-v6.6/sound/soc/samsung/ |
| D | Kconfig | 22 tristate "Samsung I2S interface support"
25 tristate "SoC I2S Audio support for WM8994 on SMDK"
119 tristate "SoC I2S Audio support for WM5110 on TM2 board"
129 tristate "SoC I2S Audio support for WM8994 on Aries"
137 modem, and the Samsung I2S controller. Jack detection is done
142 tristate "SoC I2S Audio support for Midas boards"
|
| /Linux-v6.6/sound/soc/stm/ |
| D | Kconfig | 16 tristate "STM32 I2S interface (SPI/I2S block) support"
23 Say Y if you want to enable I2S for STM32
|
| /Linux-v6.6/sound/soc/xtensa/ |
| D | Kconfig | 3 tristate "XTFPGA I2S master"
7 I2S interface on XTFPGA daughter board. You will also need to select
|
| /Linux-v6.6/sound/aoa/soundbus/ |
| D | Kconfig | 12 tristate "I2S bus support"
15 This option enables support for Apple I2S busses.
|
| /Linux-v6.6/sound/soc/adi/ |
| D | Kconfig | 8 tristate "AXI-I2S support"
13 ASoC driver for the Analog Devices AXI-I2S softcore peripheral.
|
12345
