| /Linux-v6.6/Documentation/fb/ |
| D | viafb.modes | 14 # Scan Frequency 31.469 kHz 59.94 Hz
39 # Scan Frequency 37.500 kHz 75.00 Hz
60 # Scan Frequency 43.269 kHz 85.00 Hz
81 # Scan Frequency 50.900 kHz 100.00 Hz
102 # Scan Frequency 61.800 kHz 120.00 Hz
123 # Scan Frequency 30.000 kHz 60.241 Hz
144 # Scan Frequency 29.892 kHz 60.00 Hz
165 # Scan Frequency 35.820 kHz 60.00 Hz
186 # Scan Frequency 37.879 kHz 60.32 Hz
208 # Scan Frequency 46.875 kHz 75.00 Hz
[all …]
|
| /Linux-v6.6/Documentation/sound/cards/ |
| D | img-spdif-in.rst | 19 * name='SPDIF In Multi Frequency Acquire',index=0
20 * name='SPDIF In Multi Frequency Acquire',index=1
21 * name='SPDIF In Multi Frequency Acquire',index=2
22 * name='SPDIF In Multi Frequency Acquire',index=3
25 rates. The active rate can be obtained by reading the 'SPDIF In Lock Frequency'
36 * name='SPDIF In Lock Frequency',index=0
|
| /Linux-v6.6/Documentation/translations/zh_TW/cpu-freq/ |
| D | cpufreq-stats.rst | 121 CPU Frequency scaling --->
122 [*] CPU Frequency scaling
126 "CPU Frequency scaling" (CONFIG_CPU_FREQ) 應該被啓用以配置cpufreq-stats。
|
| /Linux-v6.6/Documentation/translations/zh_CN/cpu-freq/ |
| D | cpufreq-stats.rst | 123 CPU Frequency scaling --->
124 [*] CPU Frequency scaling
128 "CPU Frequency scaling" (CONFIG_CPU_FREQ) 应该被启用，以支持配置cpufreq-stats。
|
| /Linux-v6.6/drivers/media/dvb-frontends/ |
| D | tda18271c2dd.c | 908 u32 Frequency) in RFTrackingFiltersCorrection() argument
915 if (!SearchMap2(m_RF_Cal_Map, Frequency, &Cprog_table) || in RFTrackingFiltersCorrection()
916 !SearchMap4(m_RF_Band_Map, Frequency, &RFBand) || in RFTrackingFiltersCorrection()
917 !SearchMap1(m_RF_Cal_DC_Over_DT_Map, Frequency, &dCoverdT)) in RFTrackingFiltersCorrection()
942 if (RF3 == 0 || Frequency < RF2) in RFTrackingFiltersCorrection()
943 Capprox = RF_A1 * ((s32)(Frequency) - (s32)(RF1)) + RF_B1 + Cprog_table; in RFTrackingFiltersCorrection()
945 Capprox = RF_A2 * ((s32)(Frequency) - (s32)(RF2)) + RF_B2 + Cprog_table; in RFTrackingFiltersCorrection()
970 u32 Frequency, int Standard) in ChannelConfiguration() argument
985 if (!(SearchMap1(m_BP_Filter_Map, Frequency, &BP_Filter) && in ChannelConfiguration()
986 SearchMap1(m_GainTaper_Map, Frequency, &GainTaper) && in ChannelConfiguration()
[all …]
|
| /Linux-v6.6/Documentation/driver-api/ |
| D | devfreq.rst | 4 Device Frequency Scaling
11 Frequency Switching on arbitrary devices.
|
| /Linux-v6.6/Documentation/ABI/testing/ |
| D | sysfs-bus-iio-impedance-analyzer-ad5933 | 6 Frequency sweep start frequency in Hz.
13 Frequency increment in Hz (step size) between consecutive
|
| /Linux-v6.6/Documentation/admin-guide/pm/ |
| D | cpufreq_drivers.rst | 34 Frequency transitions will be unavailable if the BIOS does
101 1.1.1 Get Average Frequency
102 1.1.2 Set Desired Frequency
142 * Get Average Frequency
143 * Set Desired Frequency
165 1.1.1 Get Average Frequency:
173 1.1.2 Set Desired Frequency:
177 ignored by OSPM. The next invocation of "Get Average Frequency" will inform
|
| /Linux-v6.6/Documentation/devicetree/bindings/sound/ |
| D | cs42l52.txt | 14 - cirrus,chgfreq-divisor : Values used to set the Charge Pump Frequency.
17 Frequency = (64xFs)/(N+2)
|
| D | cs42l56.txt | 17 - cirrus,chgfreq-divisor : Values used to set the Charge Pump Frequency.
20 Frequency = MCLK / 4 * (N+2)
|
| D | cs42l73.txt | 12 - chgfreq : Charge Pump Frequency values 0x00-0x0F
|
| /Linux-v6.6/Documentation/devicetree/bindings/cpufreq/ |
| D | cpufreq-st.txt | 9 Frequency Scaling only
31 Dynamic Voltage and Frequency Scaling (DVFS)
|
| /Linux-v6.6/Documentation/cpu-freq/ |
| D | cpufreq-stats.rst | 124 CPU Frequency scaling --->
125 [*] CPU Frequency scaling
129 "CPU Frequency scaling" (CONFIG_CPU_FREQ) should be enabled to configure
|
| /Linux-v6.6/drivers/cpufreq/ |
| D | Kconfig | 2 menu "CPU Frequency scaling"
5 bool "CPU Frequency scaling"
7 CPU Frequency scaling allows you to change the clock speed of
278 tristate "UltraSPARC-III CPU Frequency driver"
285 tristate "UltraSPARC-IIe CPU Frequency driver"
294 tristate "SuperH CPU Frequency driver"
|
| /Linux-v6.6/Documentation/translations/zh_CN/ |
| D | glossary.rst | 17 * DVFS: 动态电压频率升降。（Dynamic Voltage and Frequency Scaling）
|
| /Linux-v6.6/drivers/platform/x86/intel/uncore-frequency/ |
| D | Kconfig | 6 menu "Intel Uncore Frequency Control"
|
| /Linux-v6.6/drivers/iio/frequency/ |
| D | Kconfig | 3 # Frequency
10 menu "Frequency Synthesizers DDS/PLL"
|
| /Linux-v6.6/Documentation/userspace-api/media/rc/ |
| D | lirc-set-send-carrier.rst | 29 Frequency of the carrier to be modulated, in Hz.
|
| D | lirc-set-rec-carrier.rst | 29 Frequency of the carrier that modulates PWM data, in Hz.
|
| D | lirc-set-rec-carrier-range.rst | 30 Frequency of the carrier that modulates PWM data, in Hz.
|
| /Linux-v6.6/Documentation/devicetree/bindings/net/ieee802154/ |
| D | ca8210.txt | 14 - extclock-freq: Frequency in Hz of the external clock
|
| /Linux-v6.6/drivers/gpu/drm/amd/pm/powerplay/hwmgr/ |
| D | smu8_hwmgr.c | 481 clock_table->SclkBreakdownTable.ClkLevel[i].Frequency = in smu8_upload_pptable_to_smu()
485 clock_table->SclkBreakdownTable.ClkLevel[i].Frequency, in smu8_upload_pptable_to_smu()
498 clock_table->AclkBreakdownTable.ClkLevel[i].Frequency = in smu8_upload_pptable_to_smu()
502 clock_table->AclkBreakdownTable.ClkLevel[i].Frequency, in smu8_upload_pptable_to_smu()
512 clock_table->VclkBreakdownTable.ClkLevel[i].Frequency = in smu8_upload_pptable_to_smu()
516 clock_table->VclkBreakdownTable.ClkLevel[i].Frequency, in smu8_upload_pptable_to_smu()
524 clock_table->DclkBreakdownTable.ClkLevel[i].Frequency = in smu8_upload_pptable_to_smu()
528 clock_table->DclkBreakdownTable.ClkLevel[i].Frequency, in smu8_upload_pptable_to_smu()
537 clock_table->EclkBreakdownTable.ClkLevel[i].Frequency = in smu8_upload_pptable_to_smu()
542 clock_table->EclkBreakdownTable.ClkLevel[i].Frequency, in smu8_upload_pptable_to_smu()
|
| /Linux-v6.6/drivers/gpu/drm/amd/pm/powerplay/inc/ |
| D | smu8_fusion.h | 72 uint32_t Frequency; member
|
| /Linux-v6.6/Documentation/devicetree/bindings/net/can/ |
| D | grcan.txt | 16 - freq : Frequency of the external oscillator clock in Hz (the frequency of
|
| /Linux-v6.6/Documentation/driver-api/thermal/ |
| D | cpu-cooling-api.rst | 85 Pdyn = f(run) * Voltage^2 * Frequency * Utilisation
100 Pdyn = Capacitance * Voltage^2 * Frequency * Utilisation
|
