Home
last modified time | relevance | path

Searched refs:FLASH (Results 1 – 25 of 31) sorted by relevance

12

/Linux-v6.6/arch/arm/mm/
Dproc-arm740.S83 ldr r0, =(CONFIG_FLASH_MEM_BASE & 0xFFFFF000) @ base[31:12] of FLASH
84 ldr r3, =(CONFIG_FLASH_SIZE >> 12) @ size of FLASH (must be >= 4KB)
94 2: mcr p15, 0, r0, c6, c2 @ set area 2, ROM/FLASH
Dproc-arm940.S301 ldr r0, =(CONFIG_FLASH_MEM_BASE & 0xFFFFF000) @ base[31:12] of FLASH
302 ldr r7, =CONFIG_FLASH_SIZE @ size of FLASH (must be >= 4KB)
304 mcr p15, 0, r3, c6, c2, 0 @ set area 2, ROM/FLASH
Dproc-arm946.S346 ldr r0, =(CONFIG_FLASH_MEM_BASE & 0xFFFFF000) @ base[31:12] of FLASH
347 ldr r7, =CONFIG_FLASH_SIZE @ size of FLASH (must be >= 4KB)
/Linux-v6.6/Documentation/ABI/testing/
Dsysfs-driver-intel-m10-bmc24 FLASH storage and is mirrored in the MAX10 BMC register
34 MAX10 BMC. This value is stored in FLASH and is mirrored
Dsysfs-class-firmware20 the update cannot be canceled (e.g. a FLASH write is in
/Linux-v6.6/arch/arm/
DKconfig-nommu22 hex 'FLASH Base Address' if SET_MEM_PARAM
27 hex 'FLASH Size' if SET_MEM_PARAM
/Linux-v6.6/Documentation/core-api/
Dlibrs.rst62 e.g. for FLASH ECC, where the all 0xFF is inverted to an all 0x00. The
64 storing to FLASH so it is 0xFF too. This prevents that reading from an
65 erased FLASH results in ECC errors.
/Linux-v6.6/arch/powerpc/platforms/ps3/
DKconfig136 tristate "PS3 FLASH ROM Storage Driver"
140 Include support for the PS3 FLASH ROM Storage.
142 This support is required to access the PS3 FLASH ROM, which
/Linux-v6.6/Documentation/devicetree/bindings/ata/
Dpata-arasan.txt1 * ARASAN PATA COMPACT FLASH CONTROLLER
/Linux-v6.6/arch/powerpc/boot/dts/
Dtqm8548.dts344 0 0x0 0xfc000000 0x04000000 // NOR FLASH bank 1
345 1 0x0 0xf8000000 0x08000000 // NOR FLASH bank 0
347 3 0x0 0xe3010000 0x00008000 // NAND FLASH
Dtqm8548-bigflash.dts344 0 0x0 0xfc000000 0x04000000 // NOR FLASH bank 1
345 1 0x0 0xf8000000 0x08000000 // NOR FLASH bank 0
347 3 0x0 0xa3010000 0x00008000 // NAND FLASH
Dtqm8560.dts314 0 0x0 0xfc000000 0x04000000 // NOR FLASH bank 1
315 1 0x0 0xf8000000 0x08000000 // NOR FLASH bank 0
/Linux-v6.6/Documentation/devicetree/bindings/spi/
Dnuvoton,npcm-fiu.txt1 * Nuvoton FLASH Interface Unit (FIU) SPI Controller
/Linux-v6.6/drivers/leds/flash/
Dleds-max77693.c41 FLASH, enumerator
235 if (mode == FLASH) in max77693_add_allowed_modes()
255 if (mode == FLASH) in max77693_distribute_currents()
301 max77693_distribute_currents(led, fled_id, FLASH, micro_amp, in max77693_set_flash_current()
/Linux-v6.6/Documentation/devicetree/bindings/net/dsa/
Dmarvell.txt5 FLASH never to be changed again. Once this binding is stable, this
/Linux-v6.6/Documentation/driver-api/
Dmtdnand.rst424 use bad block tables on FLASH, because the ECC layout is interfering
477 It may be desired or necessary to keep a bad block table in FLASH. For
491 The simplest way to activate the FLASH based bad block table support is
494 this done by default. This activates the default FLASH based bad block
566 If the write support is enabled then the table is updated on FLASH.
826 - flasherase, flasheraseall: Erase and format FLASH partitions
828 - nandwrite: write filesystem images to NAND FLASH
830 - nanddump: dump the contents of a NAND FLASH partitions
/Linux-v6.6/Documentation/misc-devices/
Dc2port.rst38 - AN127: FLASH Programming via the C2 Interface at
/Linux-v6.6/arch/sh/
DKconfig.debug8 in FLASH or EPROM. The kernel will use standard BIOS calls during
/Linux-v6.6/drivers/base/firmware_loader/
DKconfig227 images from local FLASH when the card boots. The images in FLASH may
/Linux-v6.6/Documentation/userspace-api/media/v4l/
Dext-ctrls-flash.rst58 The FLASH class descriptor.
/Linux-v6.6/arch/m68k/
DKconfig.machine473 The kernel will be resident in FLASH/ROM when running. This is
475 code executes from the position it is stored in the FLASH/ROM.
/Linux-v6.6/drivers/net/ethernet/broadcom/
Dtg3.c3248 tg3_flag(tp, FLASH) && in tg3_nvram_phys_addr()
3263 tg3_flag(tp, FLASH) && in tg3_nvram_logical_addr()
3498 !tg3_flag(tp, FLASH) || in tg3_nvram_write_block_buffered()
3513 if (!tg3_flag(tp, FLASH)) { in tg3_nvram_write_block_buffered()
3552 if (tg3_flag(tp, NVRAM_BUFFERED) || !tg3_flag(tp, FLASH)) { in tg3_nvram_write_block()
14343 tg3_flag_set(tp, FLASH); in tg3_get_nvram_info()
14434 tg3_flag_set(tp, FLASH); in tg3_get_5752_nvram_info()
14441 tg3_flag_set(tp, FLASH); in tg3_get_5752_nvram_info()
14445 if (tg3_flag(tp, FLASH)) { in tg3_get_5752_nvram_info()
14476 tg3_flag_set(tp, FLASH); in tg3_get_5755_nvram_info()
[all …]
/Linux-v6.6/arch/microblaze/boot/dts/
Dsystem.dts123 FLASH: flash@a0000000 { label
/Linux-v6.6/Documentation/arch/arm/sa1100/
Dassabet.rst178 Name FLASH addr Mem addr Length Entry point
/Linux-v6.6/arch/xtensa/
DKconfig218 literals in FLASH memory attached to the instruction bus.
705 Use it to put vectors into IRAM or out of FLASH on kernels with

12