| /Linux-v6.6/arch/x86/um/os-Linux/ |
| D | mcontext.c | 18 COPY(EIP); COPY_SEG_CPL3(CS); COPY(EFL); COPY_SEG_CPL3(SS); in get_regs_from_mc()
28 COPY2(CS, CSGSFS); in get_regs_from_mc()
29 regs->gp[CS / sizeof(unsigned long)] &= 0xffff; in get_regs_from_mc()
30 regs->gp[CS / sizeof(unsigned long)] |= 3; in get_regs_from_mc()
|
| /Linux-v6.6/tools/perf/arch/x86/tests/ |
| D | regs_load.S | 14 #define CS 10 * 8 macro
47 movq $0, CS(%rdi)
84 movl $0, CS(%edi)
|
| /Linux-v6.6/arch/x86/include/uapi/asm/ |
| D | ptrace-abi.h | 20 #define CS 13 macro
56 #define CS 136 macro
|
| /Linux-v6.6/arch/x86/entry/ |
| D | entry_64.S | 161 cmpq $__USER_CS, CS(%rsp) /* CS must match SYSRET */
406 testb $3, CS-ORIG_RAX(%rsp)
472 testb $3, CS-ORIG_RAX(%rsp)
527 testb $3, CS-ORIG_RAX(%rsp)
626 testb $3, CS(%rsp)
672 testb $3, CS(%rsp)
1058 testb $3, CS+8(%rsp)
1139 testb $3, CS(%rsp)
1200 testb $3, CS-RIP+8(%rsp)
|
| D | entry_32.S | 312 movl PT_EFLAGS(%esp), %eax # mix EFLAGS, SS and CS
397 movl PT_EFLAGS(%esp), %ecx # mix EFLAGS and CS
1049 movl PT_EFLAGS(%esp), %eax # mix EFLAGS and CS
|
| /Linux-v6.6/Documentation/devicetree/bindings/spi/ |
| D | spi-davinci.txt | 40 For example to have 3 internal CS and 2 GPIO CS, user could define
42 where first three are internal CS and last two are GPIO CS.
|
| /Linux-v6.6/drivers/net/wireless/realtek/rtw88/ |
| D | Kconfig | 82 tristate "Realtek 8822CS SDIO wireless network adapter"
88 Select this option will enable support for 8822CS chipset
148 tristate "Realtek 8821CS SDIO wireless network adapter"
154 Select this option will enable support for 8821CS chipset
|
| /Linux-v6.6/arch/x86/um/ |
| D | ptrace_64.c | 42 [CS >> 3] = HOST_CS,
86 case CS: in putreg()
162 case CS: in getreg()
|
| D | user-offsets.c | 33 DEFINE(HOST_CS, CS); in foo()
62 DEFINE_LONGS(HOST_CS, CS); in foo()
|
| D | ptrace_32.c | 69 [CS] = HOST_CS,
109 case CS: in putreg()
155 case CS: in getreg()
|
| /Linux-v6.6/Documentation/devicetree/bindings/bus/ |
| D | imx-weim.txt | 21 - #size-cells: Must be set to 1 to allow CS address passing
31 Purpose Register controller that contains WEIM CS GPR
34 values depending on the CS space configuration.
59 child node. We get the CS indexes from the address
|
| D | qcom,ebi2.txt | 79 the data bus. They are inserted when reading one CS and switching to another
80 CS or read followed by write on the same CS. Valid values 0 thru 15. Minimum
84 WE is asserted until CS is asserted. With a hold of 1 (value = 0), the CS
103 read transfer. For a single read transfer this will be the time from CS
|
| /Linux-v6.6/Documentation/devicetree/bindings/memory-controllers/ |
| D | atmel,ebi.txt | 25 The first cell encodes the CS.
26 The second cell encode the offset into the CS memory
31 - ranges: Encodes CS to memory region association.
|
| D | ti-aemif.txt | 34 - CS-specific partition/range. If continuous, must be
38 - control partition which is common for all CS
152 * Partition0: CS-specific memory range which is
|
| /Linux-v6.6/Documentation/input/devices/ |
| D | iforce-protocol.rst | 40 2B OP LEN DATA CS
43 CS is the checksum. It is equal to the exclusive or of all bytes.
51 The 2B, LEN and CS fields have disappeared, probably because USB handles
234 ff 03 42 03 e8 CS would mean that the device has 1000 bytes of ram available.
245 ff 02 4e 14 CS would stand for 20 effects.
|
| /Linux-v6.6/Documentation/devicetree/bindings/net/ |
| D | maxim,ds26522.txt | 5 - reg: SPI CS.
|
| /Linux-v6.6/Documentation/arch/x86/ |
| D | entry_64.rst | 68 stack, from the CS of the ptregs area of the kernel stack::
71 testl $3,CS+8(%rsp)
95 which might have triggered right after a normal entry wrote CS to the
|
| /Linux-v6.6/Documentation/devicetree/bindings/mtd/ |
| D | atmel-nand.txt | 33 - reg: describes the CS lines assigned to the NAND device. If the NAND device
34 exposes multiple CS lines (multi-dies chips), your reg property will
36 1st entry: the CS line this NAND chip is connected to
43 - cs-gpios: the GPIO(s) used to control the CS line.
|
| /Linux-v6.6/arch/x86/kernel/ |
| D | ftrace_64.S | 173 movq $0, CS(%rsp)
229 movq %rcx, CS(%rsp)
|
| /Linux-v6.6/arch/arm/boot/dts/intel/pxa/ |
| D | pxa300-raumfeld-common.dtsi | 334 MFP_PIN_PXA300(34) MFP_AF0 /* CS#0 */
335 MFP_PIN_PXA300(125) MFP_AF0 /* CS#1 */
336 MFP_PIN_PXA300(96) MFP_AF0 /* CS#2 */
|
| /Linux-v6.6/arch/arm/boot/dts/nxp/imx/ |
| D | imx6qdl-rex.dtsi | 179 /* CS */
189 /* CS */
|
| /Linux-v6.6/Documentation/devicetree/bindings/input/touchscreen/ |
| D | bu21013.txt | 6 - reset-gpios : GPIO pin enabling (selecting) chip (CS)
|
| /Linux-v6.6/Documentation/devicetree/bindings/misc/ |
| D | ifm-csi.txt | 24 reg = <3 0 0x00100000>; /* CS 3, 1 MiB range */
|
| /Linux-v6.6/drivers/gpu/drm/i915/gt/ |
| D | gen7_renderclear.c | 12 #define batch_advance(Y, CS) GEM_BUG_ON((Y)->end != (CS)) argument
|
| /Linux-v6.6/Documentation/ABI/stable/ |
| D | vdso | 14 if you set CS on x86 to something strange, the vDSO functions are
|
