| /Linux-v6.1/Documentation/misc-devices/ |
| D | eeprom.rst | 11 Addresses scanned: I2C 0x50 - 0x57
28 24C01 1K 0x50 (shadows at 0x51 - 0x57)
29 24C01A 1K 0x50 - 0x57 (Typical device on DIMMs)
30 24C02 2K 0x50 - 0x57
31 24C04 4K 0x50, 0x52, 0x54, 0x56
33 24C08 8K 0x50, 0x54 (additional data at 0x51, 0x52,
35 24C16 16K 0x50 (additional data at 0x51 - 0x57)
38 Atmel 34C02B 2K 0x50 - 0x57, SW write protect at 0x30-37
39 Catalyst 34FC02 2K 0x50 - 0x57, SW write protect at 0x30-37
40 Catalyst 34RC02 2K 0x50 - 0x57, SW write protect at 0x30-37
[all …]
|
| D | max6875.rst | 51 Valid addresses for the MAX6875 are 0x50 and 0x52.
53 Valid addresses for the MAX6874 are 0x50, 0x52, 0x54 and 0x56.
61 $ echo max6875 0x50 > /sys/bus/i2c/devices/i2c-0/new_device
64 addresses. For example, for address 0x50, it also reserves 0x51.
|
| /Linux-v6.1/Documentation/firmware-guide/acpi/ |
| D | i2c-muxes.rst | 13 | SMB1 |-->| MUX0 |--CH00--> i2c client A (0x50)
14 | | | 0x70 |--CH01--> i2c client B (0x50)
39 I2cSerialBus (0x50, ControllerInitiated, I2C_SPEED,
54 I2cSerialBus (0x50, ControllerInitiated, I2C_SPEED,
|
| /Linux-v6.1/arch/mips/boot/dts/pic32/ |
| D | pic32mzda.dtsi | 241 reg = <0x1f822000 0x50>;
251 reg = <0x1f822200 0x50>;
261 reg = <0x1f822400 0x50>;
271 reg = <0x1f822600 0x50>;
281 reg = <0x1f822800 0x50>;
291 reg = <0x1f822A00 0x50>;
|
| /Linux-v6.1/Documentation/devicetree/bindings/misc/ |
| D | idt_89hpesx.txt | 27 address - 0x50)
40 reg = <0x50>;
|
| /Linux-v6.1/arch/arm/boot/dts/ |
| D | vf610-zii-dev-rev-b.dts | 364 reg = <0x50>;
375 reg = <0x50>;
386 reg = <0x50>;
397 reg = <0x50>;
|
| D | r8a7792.dtsi | 124 reg = <0 0xe6050000 0 0x50>;
139 reg = <0 0xe6051000 0 0x50>;
154 reg = <0 0xe6052000 0 0x50>;
169 reg = <0 0xe6053000 0 0x50>;
184 reg = <0 0xe6054000 0 0x50>;
199 reg = <0 0xe6055000 0 0x50>;
214 reg = <0 0xe6055100 0 0x50>;
229 reg = <0 0xe6055200 0 0x50>;
244 reg = <0 0xe6055300 0 0x50>;
259 reg = <0 0xe6055400 0 0x50>;
[all …]
|
| D | aspeed-bmc-arm-stardragon4800-rep2.dts | 151 reg = <0x50>;
171 reg = <0x50>;
|
| D | uniphier-ref-daughter.dtsi | 11 reg = <0x50>;
|
| D | aspeed-bmc-opp-vesnin.dts | 141 reg = <0x50>;
168 reg = <0x50>;
|
| D | aspeed-bmc-facebook-tiogapass.dts | 242 reg = <0x50>;
302 reg = <0x50>;
362 reg = <0x50>;
458 reg = <0x50>;
|
| D | aspeed-bmc-vegman-rx20.dts | 159 reg = <0x50>;
201 reg = <0x50>;
210 reg = <0x50>;
|
| D | imx6qdl-pico-hobbit.dtsi | 26 reg = <0x50>;
|
| D | aspeed-bmc-quanta-q71l.dts | 392 reg = <0x50>;
467 reg = <0x50>;
497 reg = <0x50>;
|
| D | imx6qdl-tqma6b.dtsi | 30 reg = <0x50>;
|
| D | sun7i-a20-linutronix-testbox-v2.dts | 33 reg = <0x50>;
|
| /Linux-v6.1/Documentation/devicetree/bindings/i2c/ |
| D | i2c-mux-ltc4306.txt | 47 reg = <0x50>;
58 reg = <0x50>;
|
| /Linux-v6.1/Documentation/devicetree/bindings/leds/ |
| D | leds-el15203000.txt | 15 Water Pipe LED encoded with symbol 'P' (hex code 0x50) and
51 reg = <0x50>;
|
| /Linux-v6.1/Documentation/devicetree/bindings/mux/ |
| D | adi,adg792a.txt | 34 reg = <0x50>;
60 reg = <0x50>;
|
| /Linux-v6.1/drivers/scsi/aic7xxx/ |
| D | aic79xx_seq.h_shipped | 25 0x50, 0x4b, 0x3a, 0x68,
46 0x30, 0xe0, 0x50, 0x60,
57 0x02, 0x58, 0x50, 0x31,
60 0x50, 0x4b, 0x6a, 0x68,
93 0x02, 0xa8, 0x50, 0x36,
107 0x00, 0xe2, 0xd6, 0x50,
112 0x02, 0x50, 0x1d, 0x30,
136 0x02, 0xec, 0x50, 0x31,
242 0x02, 0x5e, 0x50, 0x31,
244 0x02, 0x5c, 0x50, 0x31,
[all …]
|
| /Linux-v6.1/drivers/crypto/vmx/ |
| D | aesp8-ppc.pl | 701 my ($x00,$x10,$x20,$x30,$x40,$x50,$x60,$x70)=map("r$_",(0,8,26..31));
746 li $x50,0x50
786 lvx v30,$x50,$key
813 lvx_u $in5,$x50,$inp
953 lvx_u $in5,$x50,$inp
981 stvx_u $out5,$x50,$out
1117 stvx_u $out6,$x50,$out
1143 stvx_u $out7,$x50,$out
1422 my ($x00,$x10,$x20,$x30,$x40,$x50,$x60,$x70)=map("r$_",(0,8,26..31));
1468 li $x50,0x50
[all …]
|
| /Linux-v6.1/lib/crypto/ |
| D | curve25519-fiat32.c | 131 { u32 x50 = (x49 & 0x3ffffed); in fe_freeze() local
132 { u32 x52; u8/*bool*/ x53 = addcarryx_u26(0x0, x20, x50, &x52); in fe_freeze()
344 …{ u64 x50 = (((((0x2 * ((((((u64)x33 * x15) + ((u64)x29 * x19)) + ((u64)x37 * x11)) + ((u64)x25 * … in fe_mul_impl() local
377 { u64 x83 = (x40 + (x50 << 0x4)); in fe_mul_impl()
378 { u64 x84 = (x83 + (x50 << 0x1)); in fe_mul_impl()
379 { u64 x85 = (x84 + x50); in fe_mul_impl()
487 { u64 x50 = (x23 + (x33 << 0x4)); in fe_sqr_impl() local
488 { u64 x51 = (x50 + (x33 << 0x1)); in fe_sqr_impl()
667 …{ u64 x50 = (((((0x2 * ((((((u64)x33 * x15) + ((u64)x29 * x19)) + ((u64)x37 * x11)) + ((u64)x25 * … in fe_mul_121666_impl() local
700 { u64 x83 = (x40 + (x50 << 0x4)); in fe_mul_121666_impl()
[all …]
|
| /Linux-v6.1/Documentation/devicetree/bindings/hwmon/ |
| D | ibm,p8-occ-hwmon.txt | 18 reg = <0x50>;
|
| /Linux-v6.1/Documentation/devicetree/bindings/sound/ |
| D | amlogic,axg-spdifout.txt | 20 reg = <0x0 0x480 0x0 0x50>;
|
| /Linux-v6.1/Documentation/devicetree/bindings/input/touchscreen/ |
| D | zforce_ts.txt | 22 reg = <0x50>;
|
