| /Linux-v6.1/Documentation/devicetree/bindings/ |
| D | index.rst | 7 writing-bindings
8 writing-schema
|
| /Linux-v6.1/Documentation/virt/kvm/x86/ |
| D | cpuid.rst | 56 writing to msr 0x4b564d02
59 writing to msr 0x4b564d03
63 writing to msr 0x4b564d04
75 when writing to msr 0x4b564d02
82 be disabled by writing
|
| /Linux-v6.1/drivers/mtd/lpddr/ |
| D | lpddr_cmds.c | 78 shared[i].writing = shared[i].erasing = NULL; in lpddr_cmdset()
227 contender = shared->writing; in get_chip()
281 shared->writing = chip; in get_chip()
353 if (shared->writing == chip && chip->oldstate == FL_READY) { in put_chip()
355 shared->writing = shared->erasing; in put_chip()
356 if (shared->writing && shared->writing != chip) { in put_chip()
358 struct flchip *loaner = shared->writing; in put_chip()
369 shared->writing = NULL; in put_chip()
370 } else if (shared->erasing == chip && shared->writing != chip) { in put_chip()
|
| /Linux-v6.1/Documentation/cdrom/ |
| D | packet-writing.rst | 2 Packet writing
30 Packet writing for DVD-RW media
45 Packet writing for DVD+RW media
72 Packet writing for DVD-RAM media
139 about DVD writing.
|
| D | index.rst | 11 packet-writing
|
| /Linux-v6.1/Documentation/admin-guide/gpio/ |
| D | gpio-aggregator.rst | 25 Aggregated GPIO controllers are instantiated and destroyed by writing to
32 controller by writing a string describing the GPIOs to
61 controller after use by writing its device name to the
81 gpio-aggregator driver, or by writing to the "driver_override" file in Sysfs.
|
| /Linux-v6.1/Documentation/admin-guide/mm/damon/ |
| D | usage.rst | 20 features by reading from and writing to special sysfs files. Therefore,
35 writing kernel space DAMON application programs for you. You can even extend
46 ``<sysfs>/kernel/mm/damon/``. You can control DAMON by writing to and reading
166 context by writing one of the keywords listed in ``avail_operations`` file and
180 writing to and reading from the files.
185 writing to and rading from the files.
204 be a process. You can specify the process to DAMON by writing the pid of the
225 as they want, by writing proper values to the files under this directory.
236 region by writing to and reading from the files, respectively.
245 can get and set the schemes by reading from and writing to files under this
[all …]
|
| /Linux-v6.1/sound/usb/line6/ |
| D | Kconfig | 14 * Reading/writing individual parameters
15 * Reading/writing complete channel, effects setup, and amp
|
| /Linux-v6.1/Documentation/admin-guide/perf/ |
| D | hisi-pcie-pmu.rst | 83 than trigger condition. You can set the trigger condition by writing "trig_len",
84 and set the trigger mode by writing "trig_mode". This filter can only be used
97 threshold by writing "thr_len", and set the threshold mode by writing
|
| /Linux-v6.1/Documentation/ABI/testing/ |
| D | sysfs-platform-usbip-vudc | 33 connection peer. It is done by writing to this
37 close the connection by writing -1 instead of
|
| D | debugfs-wilco-ec | 24 For writing, bytes 0-1 indicate the message type, one of enum
27 for writing, two for the type and at least a single byte of
|
| D | sysfs-block-device | 45 to enable it by writing -1. It can be disabled again by
46 writing -2.
61 priority feature, writing "1" to this file results in an error
|
| D | sysfs-driver-typec-displayport | 16 The configuration can be changed by writing to the file
39 Pin assignment can be changed by writing to the file. It is
|
| D | sysfs-driver-ucsi-ccg | 6 firmware upgrade by writing [Yy1] to the file.
|
| D | debugfs-pktcdvd | 7 The pktcdvd module (packet writing driver) creates
|
| D | sysfs-timecard | 76 the PHC. May be changed by writing one of the listed
152 The signal generator may be started by writing the signal
219 The output signal may be changed by writing one of the listed
222 The input destinations may be changed by writing multiple
259 value may be changed by writing an unsigned integer.
288 The offset may be changed by writing an unsigned integer.
|
| D | sysfs-platform-chipidea-usb2 | 9 Only controller at dual-role configuration supports writing.
|
| D | sysfs-power | 32 to suspend the system (by writing "mem" to the /sys/power/state
68 'testproc' mode, writing 'disk' to /sys/power/state will cause
71 the 'test' mode, writing 'disk' to /sys/power/state will cause
78 The suspend-to-disk method may be chosen by writing to this
117 it contains '0' which may be changed to '1' by writing a
167 disabled by writing "0" to this file, in which case all devices
268 Writing a "1" enables this printing while writing a "0"
293 writing a "0" (default) to it disables them. Reads from
424 Writing a "1" to this file enables the sync() and writing a "0"
|
| /Linux-v6.1/arch/powerpc/kvm/ |
| D | book3s_64_mmu_radix.c | 787 bool kvmppc_hv_handle_set_rc(struct kvm *kvm, bool nested, bool writing, in kvmppc_hv_handle_set_rc() argument
800 if (writing) in kvmppc_hv_handle_set_rc()
808 if (ptep && pte_present(*ptep) && (!writing || pte_write(*ptep))) { in kvmppc_hv_handle_set_rc()
818 bool writing, bool kvm_ro, in kvmppc_book3s_instantiate_page() argument
850 writing, upgrade_p, NULL); in kvmppc_book3s_instantiate_page()
907 if (writing || upgrade_write) { in kvmppc_book3s_instantiate_page()
946 bool writing = !!(dsisr & DSISR_ISSTORE); in kvmppc_book3s_radix_page_fault() local
985 return kvmppc_hv_emulate_mmio(vcpu, gpa, ea, writing); in kvmppc_book3s_radix_page_fault()
989 if (writing) { in kvmppc_book3s_radix_page_fault()
1001 if (kvmppc_hv_handle_set_rc(kvm, false, writing, in kvmppc_book3s_radix_page_fault()
[all …]
|
| /Linux-v6.1/Documentation/hwmon/ |
| D | amc6821.rst | 71 4 degree C. Read it out after writing to get
78 writing to get the actual value.
94 writing to get actual value.
|
| /Linux-v6.1/Documentation/devicetree/bindings/mtd/ |
| D | fsl-upm-nand.txt | 18 UPM pattern (0x1), after writing a data byte (0x2) or after
19 writing out a buffer (0x4).
|
| /Linux-v6.1/Documentation/sound/kernel-api/ |
| D | index.rst | 8 writing-an-alsa-driver
|
| /Linux-v6.1/drivers/firmware/google/ |
| D | Kconfig | 17 platforms. This provides an interface for writing to and
19 driver provides an interface for reading and writing NVRAM
|
| /Linux-v6.1/net/sunrpc/xprtrdma/ |
| D | xprt_rdma.h | 526 rpcrdma_data_dir(bool writing) in rpcrdma_data_dir() argument
528 return writing ? DMA_FROM_DEVICE : DMA_TO_DEVICE; in rpcrdma_data_dir()
539 int nsegs, bool writing, __be32 xid,
|
| /Linux-v6.1/Documentation/input/devices/ |
| D | edt-ft5x06.rst | 41 mode" by writing "1" or "0" to it. In factory mode (1) it is
53 mode. The same happens when reading/writing to the parameter files when the
|
