| /Linux-v6.1/Documentation/userspace-api/media/rc/ |
| D | lirc-get-send-mode.rst | 34 The mode used for transmitting.
65 - Device does not support transmitting.
|
| D | lirc-get-features.rst | 52 :ref:`LIRC_MODE_PULSE <lirc-mode-pulse>` can only be used for transmitting.
|
| /Linux-v6.1/drivers/media/cec/core/ |
| D | cec-adap.c | 360 if (adap->transmitting == data) { in cec_data_cancel()
361 adap->transmitting = NULL; in cec_data_cancel()
412 if (adap->transmitting) in cec_flush()
503 if (adap->transmitting) { in cec_thread_func()
505 adap->transmitting->msg.len, in cec_thread_func()
506 adap->transmitting->msg.msg); in cec_thread_func()
508 cec_data_cancel(adap->transmitting, in cec_thread_func()
533 adap->transmitting = data; in cec_thread_func()
601 data = adap->transmitting; in cec_transmit_done_ts()
629 adap->transmitting = NULL; in cec_transmit_done_ts()
[all …]
|
| /Linux-v6.1/drivers/net/team/ |
| D | Kconfig | 33 Basic mode where port used for transmitting packets is selected in
45 Basic mode where port used for transmitting packets is selected
|
| /Linux-v6.1/drivers/staging/media/imx/ |
| D | TODO | 41 the size of the samples transferred by the transmitting IP block.
44 supported formats should be restricted to match the pixel source transmitting
|
| /Linux-v6.1/drivers/media/rc/ |
| D | redrat3.c | 224 bool transmitting; member
238 if (!rr3->transmitting && (code != 0x40)) in redrat3_dump_fw_error()
276 if (!rr3->transmitting) in redrat3_dump_fw_error()
760 if (rr3->transmitting) { in redrat3_transmit_ir()
769 rr3->transmitting = true; in redrat3_transmit_ir()
846 rr3->transmitting = false; in redrat3_transmit_ir()
|
| D | ite-cir.c | 181 bool for_tx = dev->transmitting; in ite_set_carrier_params()
348 dev->transmitting = true; in ite_tx_ir()
458 dev->transmitting = false; in ite_tx_ir()
1198 wait_event_interruptible(dev->tx_ended, !dev->transmitting); in ite_close()
1453 wait_event_interruptible(dev->tx_ended, !dev->transmitting); in ite_suspend()
|
| D | ite-cir.h | 84 bool transmitting; member
|
| /Linux-v6.1/drivers/usb/class/ |
| D | cdc-acm.h | 78 int transmitting; member
|
| /Linux-v6.1/Documentation/scsi/ |
| D | cxgb3i.rst | 18 On transmitting, Chelsio S3 h/w computes and inserts the Header and
32 On transmitting, S3 h/w accepts the complete PDU (header + data)
|
| /Linux-v6.1/Documentation/devicetree/bindings/sound/ |
| D | imx-audio-spdif.txt | 15 transmitting function of S/PDIF will be enabled,
|
| /Linux-v6.1/Documentation/devicetree/bindings/media/ |
| D | st-rc.txt | 14 protocol used for transmitting remote control signals. tx-mode should
|
| /Linux-v6.1/drivers/net/hippi/ |
| D | Kconfig | 36 transmitting and receiving. This memory cannot be used by any other
|
| /Linux-v6.1/Documentation/userspace-api/media/cec/ |
| D | cec-pin-error-inj.rst | 91 receiving CEC messages and those relating to transmitting CEC messages. In
156 keeps transmitting after the first byte was NACKed.
188 stop transmitting ('Arbitration Lost'). This is very hard to test,
198 This setting changes the behavior of transmitting CEC messages. Normally
291 Just stop transmitting after this bit. If <op> specifies a specific CEC
|
| D | cec-ioc-receive.rst | 148 transmitting the message. Ignored by :ref:`ioctl CEC_RECEIVE <CEC_RECEIVE>`.
176 transmitting the Poll message.
227 - Normally CEC messages are validated before transmitting them. If this
|
| /Linux-v6.1/Documentation/userspace-api/media/drivers/ |
| D | cx2341x-uapi.rst | 23 transmitting this block the first line of the block on the right to the
31 second line of 8 UV pairs of the top-left block, etc. After transmitting
|
| /Linux-v6.1/Documentation/devicetree/bindings/soc/fsl/cpm_qe/ |
| D | network.txt | 90 slots used for transmitting and receiving.
|
| /Linux-v6.1/Documentation/networking/mac80211_hwsim/ |
| D | mac80211_hwsim.rst | 44 currently enabled and on the same channel as the transmitting
|
| /Linux-v6.1/Documentation/input/ |
| D | userio.rst | 61 Registers the port with the serio driver and begins transmitting data back and
|
| /Linux-v6.1/include/media/ |
| D | cec.h | 228 struct cec_data *transmitting; member
|
| /Linux-v6.1/Documentation/networking/caif/ |
| D | caif.rst | 132 might be problems transmitting over UART.
|
| /Linux-v6.1/drivers/staging/most/Documentation/ |
| D | driver_usage.txt | 205 When transmitting synchronous data the allocated channel width needs to be
223 When transmitting isochronous AVP data the desired packet size needs to be
|
| /Linux-v6.1/Documentation/userspace-api/media/v4l/ |
| D | dev-rds.rst | 13 at devices capable of receiving and/or transmitting RDS information.
|
| /Linux-v6.1/Documentation/driver-api/ |
| D | slimbus.rst | 36 Framer device is responsible for clocking the bus, and transmitting frame-sync
|
| /Linux-v6.1/Documentation/ABI/testing/ |
| D | sysfs-class-net-cdc_ncm | 76 aggregate before transmitting an NTB frame.
|
