Searched refs:proximity (Results 1 – 25 of 52) sorted by relevance
123
| /Linux-v6.1/Documentation/misc-devices/ |
| D | bh1770glc.rst | 20 BH1770GLC and SFH7770 are combined ambient light and proximity sensors.
21 ALS and proximity parts operates on their own, but they shares common I2C
23 but ALS side results are used to estimate reliability of the proximity sensor.
29 amount of reflected IR light and produces proximity result. Resolution is
31 reliability of the proximity results. Thus ALS is always running while
32 proximity detection is needed.
36 by using a delayed work. As long as there is proximity threshold above
37 interrupts the delayed work is pushed forward. So, when proximity level goes
39 finally run. This is handled as no proximity indication.
100 RO - measured proximity value
[all …]
|
| D | apds990x.rst | 19 APDS990x is a combined ambient light and proximity sensor. ALS and proximity
21 while the proximity functionality is enabled.
101 RO - measured proximity value
109 RW - enable / disable proximity - uses counting logic
111 - 1 enables the proximity
112 - 0 disables the proximity
118 values: 0 or prox0_sensor_range value. 0 means no proximity,
119 1023 means proximity. This causes minimal number of interrupts.
128 RW - threshold level which trigs proximity events.
|
| /Linux-v6.1/Documentation/ABI/testing/ |
| D | sysfs-bus-iio-light-isl29018 | 9 Scheme 0, makes full n (4, 8, 12, 16) bits (unsigned) proximity
10 detection. The range of Scheme 0 proximity count is from 0 to
13 range of Scheme 1 proximity count is from -2^(n-1) to 2^(n-1).
15 Scheme 0 has wider dynamic range, Scheme 1 proximity detection
|
| D | sysfs-bus-iio-sx9310 | 8 proximity measurements constructed by hardware by
|
| D | sysfs-bus-iio-proximity | 6 Near level for proximity sensors. This is a single integer
|
| D | sysfs-driver-intc_sar | 47 proximity-sensor data available to the embedded controller on
|
| D | sysfs-bus-iio | 47 For proximity sensors which give the proximity (of a person) to
51 * "proximity-wifi"
52 * "proximity-lte"
53 * "proximity-wifi-lte"
54 * "proximity-wifi-left"
55 * "proximity-wifi-right"
57 These are used to indicate to userspace that these proximity
63 In some laptops/tablets the standardized proximity sensor labels
64 instead indicate proximity to a specific part of the device:
66 * "proximity-palmrest" indicates proximity to the keyboard's palmrest
[all …]
|
| /Linux-v6.1/drivers/iio/proximity/ |
| D | Kconfig | 28 Say Y here to enable the proximity sensor implemented via the ChromeOS EC MKBP
118 Common Semtech proximity sensor code.
121 tristate "SX9310/SX9311 Semtech proximity sensor"
129 proximity/button sensor.
135 tristate "SX9324 Semtech proximity sensor"
143 proximity/button sensor.
149 tristate "SX9360 Semtech proximity sensor"
157 proximity/button sensor, a simplified SX9324.
163 tristate "SX9500 Semtech proximity sensor"
170 proximity/button sensor.
[all …]
|
| /Linux-v6.1/drivers/iio/light/ |
| D | Kconfig | 77 tristate "Avago APDS9960 gesture/RGB/ALS/proximity sensor"
84 APDS9960 gesture/RGB/ALS/proximity sensor.
157 tristate "Capella CM3605 ambient light and proximity sensor"
160 ambient light and short range proximity sensor.
170 This option enables proximity & RGB sensor using
180 Say Y here if you use the light and proximity sensors
191 Say Y here if you have a Sharp GP2AP002 proximity/ALS combo-chip
205 Say Y here if you have a Sharp GP2AP020A00F proximity/ALS combo-chip
222 tristate "Intersil 29018 light and proximity sensor"
228 proximity infrared sensing from Intersil ISL29018.
[all …]
|
| /Linux-v6.1/arch/arm64/boot/dts/freescale/ |
| D | imx8mq-librem5-r4.dts | 25 &proximity {
26 proximity-near-level = <10>;
|
| D | imx8mq-librem5-r2.dts | 27 &proximity {
28 proximity-near-level = <120>;
|
| D | imx8mq-librem5-r3.dtsi | 43 &proximity {
44 proximity-near-level = <25>;
|
| /Linux-v6.1/Documentation/driver-api/iio/ |
| D | intro.rst | 28 * proximity sensors
33 combined functionality (e.g. light plus proximity sensor).
|
| /Linux-v6.1/arch/arm64/boot/dts/qcom/ |
| D | sc7180-trogdor-coachz.dtsi | 88 cros_ec_proximity: proximity {
89 compatible = "google,cros-ec-mkbp-proximity";
90 label = "proximity-wifi";
|
| D | sc7180-trogdor-coachz-r3-lte.dts | 17 label = "proximity-wifi-lte";
|
| D | sc7180-trogdor-coachz-r1-lte.dts | 17 label = "proximity-wifi-lte";
|
| D | sc7180-trogdor-lte-sku.dtsi | 9 label = "proximity-wifi-lte";
|
| D | msm8916-alcatel-idol347.dts | 97 proximity@48 {
295 proximity_int_default: proximity-int-default {
|
| D | sc7280-herobrine.dtsi | 388 ap_sar_sensor0: proximity@28 {
400 label = "proximity-wifi_cellular-0";
404 ap_sar_sensor1: proximity@2c {
416 label = "proximity-wifi_cellular-1";
|
| D | msm8916-huawei-g7.dts | 119 proximity@39 {
130 amstaos,proximity-diodes = <1>;
|
| /Linux-v6.1/drivers/iio/ |
| D | Makefile | 41 obj-y += proximity/
|
| /Linux-v6.1/arch/arm/boot/dts/ |
| D | ste-ux500-samsung-golden.dts | 236 proximity@44 {
250 sharp,proximity-far-hysteresis = <0x40>;
251 sharp,proximity-close-hysteresis = <0x0f>;
647 proximity {
|
| D | ste-ux500-samsung-kyle.dts | 399 proximity@44 {
410 sharp,proximity-far-hysteresis = /bits/ 8 <0x2f>;
411 sharp,proximity-close-hysteresis = /bits/ 8 <0x0f>;
607 /* Interrupt line for light/proximity sensor GP2AP002 */
|
| D | ste-ux500-samsung-skomer.dts | 394 proximity@44 {
405 sharp,proximity-far-hysteresis = /bits/ 8 <0x2f>;
406 sharp,proximity-close-hysteresis = /bits/ 8 <0x0f>;
609 /* Interrupt line for light/proximity sensor GP2AP002 */
|
| /Linux-v6.1/Documentation/hwmon/ |
| D | ltc4261.rst | 56 the proximity of the ADIN2 pin to the OV pin. ADIN2 is, however, not available
|
123
