Home
last modified time | relevance | path

Searched refs:pci_warn (Results 1 – 25 of 37) sorted by relevance

12

/Linux-v6.1/drivers/vfio/pci/
Dvfio_pci.c89 pci_warn(pdev, in vfio_pci_is_denylisted()
95 pci_warn(pdev, "%04x:%04x exists in vfio-pci device denylist, driver probing disallowed.\n", in vfio_pci_is_denylisted()
117 pci_warn(pdev, "Failed to setup Intel IGD regions\n"); in vfio_pci_open_device()
Dvfio_pci_config.c1370 pci_warn(pdev, "%s: unknown length for PCI cap %#x@%#x\n", in vfio_cap_len()
1444 pci_warn(pdev, "%s: unknown length for PCI ecap %#x@%#x\n", in vfio_ext_cap_len()
1574 pci_warn(pdev, "%s: PCI config conflict @%#x, was cap %#x now cap %#x\n", in vfio_cap_init()
1662 pci_warn(pdev, "%s: PCI config conflict @%#x, was ecap %#x now ecap %#x\n", in vfio_ecap_init()
1787 pci_warn(pdev, in vfio_config_init()
Dvfio_pci_core.c910 pci_warn(vdev->pdev, in vfio_pci_ioctl_get_info()
1817 pci_warn(pdev, in vfio_pci_core_request()
1984 pci_warn(vdev->pdev, in vfio_pci_bus_notifier()
2150 pci_warn(pdev, "Cannot bind to PF with SR-IOV enabled\n"); in vfio_pci_core_register_device()
/Linux-v6.1/drivers/pci/pcie/
Ddpc.c138 pci_warn(pdev, "root port still busy\n"); in dpc_wait_rp_inactive()
276 pci_warn(pdev, "%s detected\n", in dpc_process_error()
366 pci_warn(pdev, "request IRQ%d failed: %d\n", dev->irq, in dpc_probe()
Daer_inject.c406 pci_warn(dev, "The correctable error(s) is masked by device\n"); in aer_inject()
413 pci_warn(dev, "The uncorrectable error(s) is masked by device\n"); in aer_inject()
468 pci_warn(edev->port, "AER service is not initialized\n"); in aer_inject()
Derr.c214 pci_warn(bridge, "subordinate device reset failed\n"); in pcie_do_recovery()
/Linux-v6.1/drivers/pci/
Dquirks.c956 pci_warn(dev, "TI XIO2000a quirk detected; secondary bus fast back-to-back transfers disabled\n"); in quirk_xio2000a()
1027 pci_warn(dev, "I/O APIC: AMD Erratum #22 may be present. In the event of instability try\n"); in quirk_amd_ioapic()
1028 pci_warn(dev, " : booting with the \"noapic\" option\n"); in quirk_amd_ioapic()
1203 pci_warn(dev, "BIOS failed to enable PCI standards compliance; fixing this error\n"); in quirk_amd_ordering()
1869 pci_warn(pdev, "could not add stall property"); in quirk_huawei_pcie_sva()
1885 pci_warn(dev, "PXH quirk detected; SHPC device MSI disabled\n"); in quirk_pcie_pxh()
2345 pci_warn(dev, "Can't map e100 registers\n"); in quirk_e100_interrupt()
2351 pci_warn(dev, "Firmware left e100 interrupts enabled; disabling\n"); in quirk_e100_interrupt()
2566 pci_warn(dev, "MSI quirk detected; MSI disabled\n"); in quirk_disable_all_msi()
2582 pci_warn(dev, "MSI quirk detected; subordinate MSI disabled\n"); in quirk_disable_msi()
[all …]
Dp2pdma.c381 pci_warn(root, "Host bridge not in P2PDMA whitelist: %04x:%04x\n", in __host_bridge_whitelist()
519 pci_warn(client, "ACS redirect is set between the client and provider (%s)\n", in calc_map_type_and_dist()
521 …pci_warn(client, "to disable ACS redirect for this path, add the kernel parameter: pci=disable_acs… in calc_map_type_and_dist()
530 …pci_warn(client, "cannot be used for peer-to-peer DMA as the client and provider (%s) do not share… in calc_map_type_and_dist()
Dvpd.c69 pci_warn(dev, "failed VPD read at offset %zu\n", in pci_vpd_size()
151 …pci_warn(dev, "VPD access failed. This is likely a firmware bug on this device. Contact the card… in pci_vpd_wait()
549 pci_warn(dev, FW_BUG "disabling VPD access (can't determine size of non-standard VPD format)\n"); in quirk_blacklist_vpd()
Dpci-acpi.c147 pci_warn(dev, "PCI settings rev %d not supported; using defaults\n", in program_hpx_type0()
219 pci_warn(dev, "PCI-X settings not supported\n"); in program_hpx_type1()
297 pci_warn(dev, "PCIe settings rev %d not supported\n", in program_hpx_type2()
535 pci_warn(dev, "Encountered _HPX type 3 with unsupported config space location"); in program_hpx_type3_register()
962 pci_warn(dev, "ACPI _RST failed\n"); in pci_dev_acpi_reset()
Diov.c457 pci_warn(pdev, "%d VFs already enabled. Disable before enabling %d VFs\n", in sriov_numvfs_store()
468 pci_warn(pdev, "%d VFs requested; only %d enabled\n", in sriov_numvfs_store()
934 pci_warn(dev, "driver left SR-IOV enabled after remove\n"); in pci_iov_remove()
1214 pci_warn(dev, "Cannot modify SR-IOV while VFs are assigned\n"); in pci_sriov_configure_simple()
Dprobe.c1275 pci_warn(dev, "Primary bus is hard wired to 0\n"); in pci_scan_bridge_extend()
1328 pci_warn(dev, "bridge has subordinate %02x but max busn %02x\n", in pci_scan_bridge_extend()
2016 …pci_warn(dev, "can't set Max Payload Size to %d; if necessary, use \"pci=pcie_bus_safe\" and repor… in pci_configure_mps()
2032 …pci_warn(dev, "Max Payload Size %d, but upstream %s set to %d; if necessary, use \"pci=pcie_bus_sa… in pci_configure_mps()
2054 …pci_warn(dev, "can't set Max Payload Size to %d; if necessary, use \"pci=pcie_bus_safe\" and repor… in pci_configure_mps()
2782 pci_warn(dev, "Failed attempting to set the MRRS\n"); in pcie_write_mrrs()
Dbus.c326 pci_warn(dev, "device attach failed (%d)\n", retval); in pci_bus_add_device()
Dxen-pcifront.c279 pci_warn(dev, "MSI-X entry %d is invalid: %d!\n", in pci_frontend_enable_msix()
332 pci_warn(dev, "MSI entry is invalid: %d!\n", in pci_frontend_enable_msi()
Dpci.c921 …pci_warn(dev, "cannot disable ACS redirect for this hardware as it does not have ACS capabilities\… in pci_disable_acs_redir()
1172 pci_warn(dev, "not ready %dms after %s; giving up\n", in pci_dev_wait()
2496 pci_warn(dev, "can't enable PME#\n"); in pci_pme_active()
3992 pci_warn(pdev, "BAR %d: can't reserve %pR\n", bar, in __pci_request_region()
5275 pci_warn(pdev, "All device reset methods disabled by user"); in reset_method_store()
5319 pci_warn(pdev, "Device-specific reset disabled/de-prioritized by user"); in reset_method_store()
6421 pci_warn(dev, "Unable to allocate DMA alias mask\n"); in pci_add_dma_alias()
6657 pci_warn(dev, "Can't reassign resources to host bridge\n"); in pci_reassigndev_resource_alignment()
/Linux-v6.1/drivers/i2c/busses/
Di2c-amd-mp2-pci.c33 pci_warn(privdata->pci_dev, in amd_mp2_c2p_mutex_unlock()
189 pci_warn(pdev, "received msg but no cmd was sent (bus = %d)!\n", in amd_mp2_process_event()
233 pci_warn(pdev, "received irq without message\n"); in amd_mp2_irq_isr()
/Linux-v6.1/drivers/pci/hotplug/
Dpciehp.h42 pci_warn(ctrl->pcie->port, format, ## arg)
Dshpchp.h59 pci_warn(ctrl->pci_dev, format, ## arg)
Dpnv_php.c23 ((sl)->pdev ? pci_warn((sl)->pdev, x) : dev_warn(&(sl)->bus->dev, x))
/Linux-v6.1/drivers/media/pci/zoran/
Dzoran_card.c1011 pci_warn(zr->pci_dev, in zr36057_init()
1019 pci_warn(zr->pci_dev, "default_input value %d out of range (0-%d)\n", in zr36057_init()
1239 pci_warn(pdev, "%s: chipset does not support reliable PCI-PCI DMA\n", in zoran_probe()
Dzoran_device.c348 pci_warn(zr->pci_dev, "%s(1) with SnapShot on!?\n", __func__); in zr36057_set_memgrab()
873 pci_warn(zr->pci_dev, "BuzIRQ with SnapShot off ???\n"); in zoran_irq()
/Linux-v6.1/drivers/dma/dw-edma/
Ddw-edma-pcie.c341 pci_warn(pdev, "can't remove device properly: %d\n", err); in dw_edma_pcie_remove()
/Linux-v6.1/drivers/crypto/hisilicon/sec2/
Dsec_main.c1233 pci_warn(pdev, "Failed to init debugfs!\n"); in sec_probe()
1242 pci_warn(qm->pdev, in sec_probe()
/Linux-v6.1/arch/powerpc/platforms/pseries/
Dsetup.c759 pci_warn(pdev, "No hypervisor support for SR-IOV on this device, IOV BARs disabled.\n"); in pseries_disable_sriov_resources()
/Linux-v6.1/drivers/net/ethernet/sfc/falcon/
Defx.c2784 pci_warn(dev, "Unable to read VPD\n"); in ef4_probe_vpd_strings()
2791 pci_warn(dev, "Part number not found or incomplete\n"); in ef4_probe_vpd_strings()
2798 pci_warn(dev, "Serial number not found or incomplete\n"); in ef4_probe_vpd_strings()

12