Searched refs:opposite (Results 1 – 25 of 60) sorted by relevance
123
10 the opposite is true. Say Y if you have either of these devices
12 the opposite level disables the WDT. Active level is determined
30 opposite value.
134 register is specified through the Comm byte. This is the opposite of149 This is the opposite of the Read Word operation. 16 bits196 The opposite of the Block Read command, this writes up to 32 bytes to315 The opposite of the Block Read command, this writes bytes to
43 * DRAM (providing 1.35V). The other regulator on the opposite side
95 /* active-high meaning opposite of regular PERST# active-low polarity */
90 /* active-high meaning opposite of regular PERST# active-low polarity */
146 /* active-high meaning opposite of regular PERST# active-low polarity */
45 of the endpoint may configured to be the opposite of the jack status if
56 Second the driver adjusts the image size (the opposite rectangle of the
66 indices do not indicate the opposite. The ``id`` must be unique.
127 driver should preferably adjust the opposite one. The
235 | Set ETEMP exponent bit 15 as the opposite of ete14329 | Set ETEMP exponent bit 15 as the opposite of ete14
81 But it is exactly the opposite. printk() calls must _not_ be KABI.
34 just the opposite).
910 int opposite = !stream; in snd_pcm_attach_substream() local912 for (substream = pcm->streams[opposite].substream; substream; in snd_pcm_attach_substream()
95 opposite physical level than the signal at the device's pin.123 to generate or receive a signal of the opposite polarity, software will be
58 as the opposite of "empty", which might be a tad confusing.)
43 In opposite to vcan loopback devices the vxcan only forwards CAN
36 byte, then the very next read should be the opposite byte. Our data
97 Note: "Cancelling" a filter by registering the opposite action for the same
181 Write verification is the opposite of the read verification - first the object297 the opposite order to the read verifiers. A typical write verifier::
116 data. Note that the opposite is not true - it would be valid for
399 // $p2 set if opposite direction done/will be done, so:
100 As it is cheap to convert seconds to nanoseconds, but the opposite
