Searched refs:multiplexing (Results 1 – 25 of 47) sorted by relevance
12
| /Linux-v6.1/Documentation/devicetree/bindings/pinctrl/ |
| D | cortina,gemini-pinctrl.txt | 4 see further arm/gemini.txt. It is a purely group-based multiplexing pin
12 Subnodes of the pin controller contain pin control multiplexing set-up
15 Please refer to pinctrl-bindings.txt for generic pin multiplexing nodes
|
| D | brcm,bcm2835-gpio.txt | 46 The BCM2835 pin configuration and multiplexing supports the generic bindings.
60 Legacy pin configuration and multiplexing binding:
61 *** (Its use is deprecated, use generic multiplexing and configuration
|
| D | ste,nomadik.txt | 22 pin multiplexing node layout from the standard pin control bindings
25 Required pin multiplexing subnode properties:
29 group that will be combined with the function to form a multiplexing
|
| D | nxp,lpc1850-scu.txt | 9 The lpc1850-scu driver uses the generic pin multiplexing and generic pin
|
| D | pinctrl-bindings.txt | 3 Hardware modules that control pin multiplexing or configuration parameters
103 == Generic pin multiplexing node content ==
|
| D | pinctrl-st.txt | 4 PIO multiplexing block. Each pin supports GPIO functionality (ALT0)
11 ST pinctrl driver controls PIO multiplexing block and also interacts with
|
| D | ste,abx500.txt | 11 ST Ericsson's pin configuration nodes use the generic pin multiplexing
|
| D | fsl,imx-pinctrl.txt | 5 multiplexing the PAD input/output signals. For each PAD there are up to
|
| D | fsl,mxs-pinctrl.txt | 4 has 32 pins. Each pin has 4 multiplexing functions, and generally, the 4th
|
| D | atmel,at91-pinctrl.txt | 5 multiplexing the PAD input/output signals. For each PAD there are up to
|
| /Linux-v6.1/arch/arm/mach-davinci/ |
| D | Kconfig | 176 bool "DAVINCI multiplexing support"
180 Pin multiplexing support for DAVINCI boards. If your bootloader
181 sets the multiplexing correctly, say N. Otherwise, or if unsure,
188 Makes the multiplexing functions print out a lot of debug info.
190 multiplexing registers.
197 to change the pin multiplexing setup. When there are no warnings
|
| /Linux-v6.1/arch/arm/mach-omap1/ |
| D | Kconfig | 58 bool "OMAP multiplexing support"
61 Pin multiplexing support for OMAP boards. If your bootloader
62 sets the multiplexing correctly, say N. Otherwise, or if unsure,
69 Makes the multiplexing functions print out a lot of debug info.
71 multiplexing registers.
79 to change the pin multiplexing setup. When there are no warnings
|
| /Linux-v6.1/net/kcm/ |
| D | Kconfig | 10 for multiplexing messages of a message based application
|
| /Linux-v6.1/Documentation/driver-api/tty/ |
| D | n_gsm.rst | 7 This line discipline implements the GSM 07.10 multiplexing protocol
92 Note that after closing the physical port the modem is still in multiplexing
95 a disconnect command frame manually before initializing the multiplexing mode
|
| /Linux-v6.1/drivers/net/ethernet/qualcomm/rmnet/ |
| D | Kconfig | 12 for handling data in the multiplexing and aggregation protocol (MAP)
|
| /Linux-v6.1/Documentation/devicetree/bindings/i2c/ |
| D | i2c-demux-pinctrl.txt | 3 This binding describes an I2C bus demultiplexer that uses pin multiplexing to
4 route the I2C signals, and represents the pin multiplexing configuration using
|
| /Linux-v6.1/Documentation/devicetree/bindings/fsi/ |
| D | fsi-master-gpio.txt | 12 - mux-gpios = <gpio-descriptor>; : GPIO for pin multiplexing with other
|
| D | fsi-master-ast-cf.txt | 14 - mux-gpios = <gpio-descriptor>; : GPIO for pin multiplexing with other
|
| /Linux-v6.1/drivers/video/fbdev/ |
| D | cirrusfb.c | 361 int multiplexing; member
485 cinfo->multiplexing = 0; in cirrusfb_check_pixclock()
507 cinfo->multiplexing = 1; in cirrusfb_check_pixclock()
511 cinfo->multiplexing = 1; in cirrusfb_check_pixclock()
736 if (cinfo->multiplexing) { in cirrusfb_set_par_foo()
841 if (cinfo->multiplexing) in cirrusfb_set_par_foo()
955 cinfo->multiplexing ? in cirrusfb_set_par_foo()
1000 if (cinfo->multiplexing) in cirrusfb_set_par_foo()
1029 cinfo->multiplexing ? in cirrusfb_set_par_foo()
1073 if (cinfo->multiplexing) in cirrusfb_set_par_foo()
|
| /Linux-v6.1/Documentation/driver-api/media/ |
| D | dtv-core.rst | 27 .. [#f1] Some standards use TCP/IP for multiplexing data, like DVB-H (an
|
| /Linux-v6.1/Documentation/driver-api/80211/ |
| D | mac80211-advanced.rst | 154 :doc: Spatial multiplexing power save
|
| /Linux-v6.1/Documentation/userspace-api/media/v4l/ |
| D | func-select.rst | 13 v4l2-select - Synchronous I/O multiplexing
|
| /Linux-v6.1/drivers/i2c/muxes/ |
| D | Kconfig | 83 multiplexer that uses the pinctrl subsystem, i.e. pin multiplexing.
|
| /Linux-v6.1/Documentation/networking/caif/ |
| D | linux_caif.rst | 117 - CFMUX CAIF Mux layer. Handles multiplexing between multiple
|
| /Linux-v6.1/drivers/i2c/ |
| D | Kconfig | 63 tristate "I2C bus multiplexing support"
|
12
