Searched refs:multiplexer (Results 1 – 25 of 54) sorted by relevance
123
| /Linux-v6.1/drivers/i2c/muxes/ |
| D | Kconfig | 23 tristate "GPIO-based I2C multiplexer"
27 GPIO based I2C multiplexer. This driver provides access to
35 tristate "General Purpose I2C multiplexer"
40 general purpose I2C multiplexer. This driver provides access to
48 tristate "LTC LTC4306/5 I2C multiplexer"
78 tristate "pinctrl-based I2C multiplexer"
83 multiplexer that uses the pinctrl subsystem, i.e. pin multiplexing.
91 tristate "Register-based I2C multiplexer"
95 register based I2C multiplexer. This driver provides access to
112 tristate "Mellanox CPLD based I2C multiplexer"
[all …]
|
| /Linux-v6.1/Documentation/devicetree/bindings/net/ |
| D | mdio-mux-meson-g12a.txt | 1 Properties for the MDIO bus multiplexer/glue of Amlogic G12a SoC family.
3 This is a special case of a MDIO bus multiplexer. It allows to choose between
7 Required properties in addition to the generic multiplexer properties:
9 - reg: physical address and length of the multiplexer/glue registers
18 mdio_mux: mdio-multiplexer@4c000 {
|
| /Linux-v6.1/drivers/mux/ |
| D | Kconfig | 28 ADGS1408 8:1 multiplexer and ADGS1409 double 4:1 multiplexer
40 The driver builds a single multiplexer controller using a number
41 of gpio pins. For N pins, there will be 2^N possible multiplexer
54 The driver builds multiplexer controllers for bitfields in either
56 bitfields, there will be 2^N possible multiplexer states.
|
| /Linux-v6.1/drivers/net/mdio/ |
| D | Kconfig | 208 tristate "Amlogic G12a based MDIO bus multiplexer"
214 This module provides a driver for the MDIO multiplexer/glue of
225 BCM6368 based Broadcom SoCs. This multiplexer connects one of several
227 external and selection logic lies inside the same multiplexer.
236 iProc based Broadcom SoCs. This multiplexer connects one of several
238 external and selection logic lies inside the same multiplexer.
246 are controlled via GPIO lines. The multiplexer connects one of
251 tristate "MDIO bus multiplexer using kernel multiplexer subsystem"
256 This module provides a driver for MDIO bus multiplexer
257 that is controlled via the kernel multiplexer subsystem. The
[all …]
|
| D | Makefile | 32 obj-$(CONFIG_MDIO_BUS_MUX_MULTIPLEXER) += mdio-mux-multiplexer.o
|
| /Linux-v6.1/Documentation/devicetree/bindings/iio/adc/ |
| D | xilinx-xadc.txt | 38 * "none": No external multiplexer is used, this is the default
40 * "single": External multiplexer mode is used with one
41 multiplexer.
42 * "dual": External multiplexer mode is used with two
46 Valid values for single external multiplexer mode are:
52 Valid values for dual external multiplexer mode are:
59 external multiplexer mode (either single or dual). If the device is
60 not using external multiplexer mode the property is ignored.
|
| /Linux-v6.1/drivers/iio/multiplexer/ |
| D | Kconfig | 10 tristate "IIO multiplexer driver"
13 Say yes here to build support for the IIO multiplexer.
|
| /Linux-v6.1/Documentation/devicetree/bindings/sound/ |
| D | amlogic,axg-tdm-formatters.txt | 16 * "sclk_sel" : bit clock input multiplexer.
18 * "lrclk_sel": sample clock input multiplexer
|
| /Linux-v6.1/Documentation/hwmon/ |
| D | da9055.rst | 18 multiplexer. The analogue input multiplexer will allow conversion of up to 5
|
| D | da9052.rst | 19 multiplexer. The analogue input multiplexer will allow conversion of up to 10
|
| /Linux-v6.1/Documentation/devicetree/bindings/display/imx/ |
| D | ldb.txt | 14 multiplexer in the front to select any of the four IPU display
55 On i.MX5, the internal two-input-multiplexer is used. Due to hardware
59 to the four LVDS multiplexer inputs.
|
| /Linux-v6.1/drivers/gpu/vga/ |
| D | Kconfig | 10 Many laptops released in 2008/9/10 have two GPUs with a multiplexer
|
| /Linux-v6.1/Documentation/devicetree/bindings/i2c/ |
| D | i2c-mux-reg.txt | 3 This binding describes an I2C bus multiplexer that uses a single register
8 - i2c-parent: The phandle of the I2C bus that this multiplexer's master-side
|
| /Linux-v6.1/drivers/iio/ |
| D | Makefile | 35 obj-y += multiplexer/
|
| D | Kconfig | 89 source "drivers/iio/multiplexer/Kconfig"
|
| /Linux-v6.1/Documentation/devicetree/bindings/clock/ |
| D | microchip,pic32.txt | 3 Microchip clock controller is consists of few oscillators, PLL, multiplexer
|
| /Linux-v6.1/Documentation/ABI/testing/ |
| D | sysfs-bus-i2c-devices-pca954x | 7 written to control the behaviour of the multiplexer on
|
| /Linux-v6.1/arch/arm64/boot/dts/freescale/ |
| D | fsl-lx2160a-qds.dts | 36 compatible = "mdio-mux-multiplexer";
104 compatible = "mdio-mux-multiplexer";
|
| D | fsl-lx2162a-qds.dts | 34 compatible = "mdio-mux-multiplexer";
114 compatible = "mdio-mux-multiplexer";
|
| /Linux-v6.1/drivers/usb/typec/mux/ |
| D | Kconfig | 29 control the USB role switch and also the multiplexer/demultiplexer
|
| /Linux-v6.1/Documentation/devicetree/bindings/clock/st/ |
| D | st,clkgen.txt | 4 A Clockgen node can contain pll, diviser or multiplexer nodes.
|
| /Linux-v6.1/drivers/usb/roles/ |
| D | Kconfig | 9 multiplexer/demultiplexer switch is used to route the data lines on
|
| /Linux-v6.1/Documentation/devicetree/bindings/clock/ti/ |
| D | composite.txt | 8 a multiplexer clock with multiple input clock signals or parents, one
|
| D | mux.txt | 6 register-mapped multiplexer with multiple input clock signals or
|
| /Linux-v6.1/Documentation/devicetree/bindings/interrupt-controller/ |
| D | amlogic,meson-gpio-intc.txt | 5 a 256 pads to 8 GIC interrupt multiplexer, with a filter block to select edge
|
123
