Searched refs:logic (Results 1 – 25 of 240) sorted by relevance
12345678910
| /Linux-v6.1/arch/arm/boot/dts/ |
| D | vexpress-v2p-ca9.dts | 216 /* Test Chip internal logic voltage */
225 /* PL310, L2 cache, RAM cell supply (not PL310 logic) */
234 /* Cortex-A9 system supply, Cores, MPEs, SCU and PL310 logic */
261 /* Local board supply for miscellaneous logic external to the Test Chip */
270 /* PL310, L2 cache, RAM cell supply (not PL310 logic) */
277 /* Cortex-A9 system supply, Cores, MPEs, SCU and PL310 logic */
284 /* PL310, L2 cache, RAM cell supply (not PL310 logic) */
291 /* Cortex-A9 system supply, Cores, MPEs, SCU and PL310 logic */
|
| /Linux-v6.1/Documentation/driver-api/media/ |
| D | dtv-core.rst | 10 implement the digital demux logic (either in software or in hardware);
14 - A tuner driver that implements the logic which commands the part of
19 - A demodulator driver (a.k.a "demod") that implements the logic which
|
| /Linux-v6.1/Documentation/misc-devices/ |
| D | bh1770glc.rst | 22 interface and interrupt logic. In principle they can run on their own,
25 ALS produces 16 bit lux values. The chip contains interrupt logic to produce
57 Uses counting logic
110 Uses counting logic
|
| /Linux-v6.1/Documentation/devicetree/bindings/usb/ |
| D | dwc3-st.txt | 1 ST DWC3 glue logic
4 This driver controls the glue logic used to configure the dwc3 core on
9 - reg : glue logic base address and USB syscfg ctrl register offset
|
| D | nvidia,tegra124-xusb.txt | 46 - avddio-pex-supply: PCIe/USB3 analog logic power supply. Must supply 1.05 V.
47 - dvddio-pex-supply: PCIe/USB3 digital logic power supply. Must supply 1.05 V.
56 - dvddio-pex-supply: PCIe/USB3 analog logic power supply. Must supply 1.05 V.
|
| /Linux-v6.1/Documentation/driver-api/media/drivers/ |
| D | pvrusb2.rst | 76 pvrusb2-audio.[ch] - This is glue logic that resides between this
101 pvrusb2-eeprom.[ch] - This is glue logic that resides between this
107 device. It is a crude echo of corresponding logic in ivtv,
125 pvrusb2-hdw.c - This module implements all the various bits of logic
130 pvrusb2-i2c-chips-\*.c - These modules implement the glue logic to
134 implement just the logic that makes sense for a pure V4L
156 glue logic which is coordinated by pvrusb2-hdw, doled out by
180 pvrusb2-tuner.[ch] - This is glue logic that resides between this
194 pvrusb2-video-\*.[ch] - This is glue logic that resides between this
|
| /Linux-v6.1/Documentation/watchdog/ |
| D | mlx-wdt.rst | 11 Mellanox watchdog device is implemented in a programmable logic device.
36 with new programmer logic device.
66 Programmable logic device registers have little-endian order.
|
| /Linux-v6.1/Documentation/devicetree/bindings/media/i2c/ |
| D | tvp7002.txt | 25 Under normal operation, the field ID output is set to logic 1 for an odd field
26 (field 1) and set to logic 0 for an even field (field 0).
|
| /Linux-v6.1/Documentation/networking/dsa/ |
| D | bcm_sf2.rst | 84 hardware contains logic which will assert/de-assert link states accordingly for
101 - disabling packet processing logic
105 - turning off RGMII data processing logic when the link goes down
111 MAC controller wake-on logic. Whenever Wake-on-LAN is requested, an intersection
|
| /Linux-v6.1/Documentation/peci/ |
| D | peci.rst | 32 value is logic '0' or logic '1'. PECI Wire also includes variable data
|
| /Linux-v6.1/drivers/gpu/drm/logicvc/ |
| D | Kconfig | 9 DRM display driver for the logiCVC programmable logic block from Xylon
|
| /Linux-v6.1/Documentation/devicetree/bindings/regulator/ |
| D | act8945a-regulator.txt | 7 - active-semi,vsel-high: Indicates if the VSEL pin is set to logic-high.
8 If this property is missing, assume the VSEL pin is set to logic-low.
|
| /Linux-v6.1/drivers/net/ethernet/mellanox/mlxfw/ |
| D | Kconfig | 10 flashing common logic.
|
| /Linux-v6.1/Documentation/driver-api/gpio/ |
| D | intro.rst | 39 several dozen of them. Programmable logic devices (like FPGAs) can easily
56 input de-glitch/debounce logic, sometimes with software controls.
99 logic (low=true) perspective this is a "wire-OR".
115 The same logic can be applied to emulate open source signaling, by driving the
|
| /Linux-v6.1/Documentation/networking/device_drivers/ethernet/altera/ |
| D | altera_tse.rst | 39 developer wishes to support their own soft DMA logic and driver support. Any
85 interrupt is driven by the transmit DMA logic. The driver handles the transmit
91 The driver will post receive buffers to the receive DMA logic during driver
93 underlying DMA logic (MSGDMA is able queue receive buffers, SGDMA is not able
94 to queue receive buffers to the SGDMA receive logic). When a packet is
95 received, the DMA logic generates an interrupt. The driver handles a receive
96 interrupt by obtaining the DMA receive logic status, reaping receive
|
| /Linux-v6.1/drivers/dma/dw-edma/ |
| D | Kconfig | 17 Provides a glue-logic between the Synopsys DesignWare
|
| /Linux-v6.1/drivers/nfc/st21nfca/ |
| D | Kconfig | 7 HCI logic and hooks into the NFC kernel APIs. Physical layers will
|
| /Linux-v6.1/Documentation/ABI/testing/ |
| D | sysfs-devices-system-xen_cpu | 20 logic restrictions and assumptions.
|
| /Linux-v6.1/Documentation/devicetree/bindings/clock/ |
| D | nvidia,tegra124-dfll.txt | 17 - registers for the DFLL control logic.
18 - registers for the I2C output logic.
25 - soc: Clock source for the DFLL control logic.
|
| /Linux-v6.1/Documentation/target/ |
| D | tcm_mod_builder.rst | 17 1) Generate new API callers for drivers/target/target_core_fabric_configs.c logic
25 using drivers/target/target_core_fabric_lib.c logic.
26 4) NOP API calls for all other Data I/O path and fabric dependent attribute logic
|
| /Linux-v6.1/Documentation/mm/damon/ |
| D | design.rst | 14 of DAMON, is in the pure logic space. DAMON separates the two parts in
16 primitives implementations configurable with the core logic. We call the low
87 logic. DAMON does nothing to avoid disturbing Idle page tracking, so handling
89 conflict with the reclaim logic using ``PG_idle`` and ``PG_young`` page flags,
|
| /Linux-v6.1/Documentation/power/ |
| D | suspend-and-interrupts.rst | 65 That may involve turning on a special signal handling logic within the platform
76 those purposes. Namely, enable_irq_wake() turns on the platform's logic for
78 turns that logic off.
111 any special interrupt handling logic for it to work.
|
| /Linux-v6.1/Documentation/block/ |
| D | ublk.rst | 10 ublk is a generic framework for implementing block device logic from userspace.
39 logic is totally done by userspace, such as loop's IO handling, NBD's IO
64 ublk requires userspace ublk server to handle real block device logic.
112 related, or request queue limit related, but can't be IO logic specific,
113 because the driver does not handle any IO logic. This command has to be
260 ublk driver doesn't handle any IO logic. Its function is well defined
|
| /Linux-v6.1/Documentation/devicetree/bindings/soc/xilinx/ |
| D | xlnx,vcu.txt | 8 and programmable logic. Also provides the list of register set to configure
|
| /Linux-v6.1/Documentation/devicetree/bindings/pwm/ |
| D | nxp,pca9685-pwm.txt | 12 - invert (bool): boolean to enable inverted logic
|
12345678910
