Searched refs:ground (Results 1 – 25 of 27) sorted by relevance
12
| /Linux-v6.1/Documentation/hwmon/ |
| D | ntc_thermistor.rst | 56 -+- (ground)
68 -+- (ground)
80 -+----+- (ground)
92 -+- (ground)
|
| D | smsc47m192.rst | 108 to ground or Vcc. '1' indicates a diode fault.
|
| D | adm1026.rst | 96 voltage from the power lead rather than on the ground lead.
|
| /Linux-v6.1/drivers/extcon/ |
| D | extcon-intel-mrfld.c | 98 bool ground; in mrfld_extcon_get_id() local
122 ground = id & BCOVE_USBIDSTS_GND; in mrfld_extcon_get_id()
125 return ground ? INTEL_USB_ID_GND : INTEL_USB_ID_FLOAT; in mrfld_extcon_get_id()
127 return ground ? INTEL_USB_ID_FLOAT : INTEL_USB_ID_GND; in mrfld_extcon_get_id()
|
| /Linux-v6.1/drivers/iio/position/ |
| D | Kconfig | 28 and keyboard angle respect to horizon (ground).
|
| /Linux-v6.1/Documentation/devicetree/bindings/iio/ |
| D | mount-matrix.txt | 96 ground plane and positive towards magnetic North, (x) is in the ground plane,
98 perpendicular to the ground plane and positive upwards.
|
| /Linux-v6.1/arch/arm/boot/dts/ |
| D | rk3288-veyron-sdmmc.dtsi | 34 * Builtin CD line is hooked to ground to prevent JTAG at boot
|
| D | kirkwood-openblocks_a7.dts | 84 * ground.
|
| D | at91-sama5d2_icp.dts | 374 * connect it to ground to get an edge e.g.
|
| D | at91-sama5d2_xplained.dts | 459 * connect it to ground to get an edge e.g.
|
| D | exynos5422-odroid-core.dtsi | 506 samsung,s2mps11-acokb-ground;
|
| /Linux-v6.1/drivers/auxdisplay/ |
| D | Kconfig | 378 0 : no connection (eg: connected to ground)
393 0 : no connection (eg: connected to ground)
408 0 : no connection (eg: connected to ground)
423 0 : no connection (eg: connected to ground)
438 0 : no connection (eg: connected to ground)
453 0 : no connection (eg: connected to ground)
|
| /Linux-v6.1/rust/alloc/ |
| D | README.md | 24 We agreed on a middle-ground: we would keep a subset of `alloc`
|
| /Linux-v6.1/Documentation/w1/ |
| D | w1-generic.rst | 6 signal wire (plus ground, so two wires).
8 Devices communicate on the bus by pulling the signal to ground via an open
|
| /Linux-v6.1/arch/arm64/boot/dts/qcom/ |
| D | sc7180-trogdor-lazor.dtsi | 12 semtech,cs0-ground;
|
| /Linux-v6.1/Documentation/misc-devices/ |
| D | lis3lv02d.rst | 95 fall to the ground is out of question...
|
| /Linux-v6.1/Documentation/ABI/testing/ |
| D | sysfs-bus-iio | 662 1kohm_to_gnd: connected to ground via an 1kOhm resistor,
663 2.5kohm_to_gnd: connected to ground via a 2.5kOhm resistor,
664 6kohm_to_gnd: connected to ground via a 6kOhm resistor,
665 20kohm_to_gnd: connected to ground via a 20kOhm resistor,
666 90kohm_to_gnd: connected to ground via a 90kOhm resistor,
667 100kohm_to_gnd: connected to ground via an 100kOhm resistor,
668 125kohm_to_gnd: connected to ground via an 125kOhm resistor,
669 500kohm_to_gnd: connected to ground via a 500kOhm resistor,
670 640kohm_to_gnd: connected to ground via a 640kOhm resistor,
1869 * Y is in the ground plane and positive towards magnetic North ;
[all …]
|
| /Linux-v6.1/Documentation/sound/designs/ |
| D | channel-mapping-api.rst | 41 As a ground design, each PCM substream may contain a control element
|
| /Linux-v6.1/Documentation/driver-api/ |
| D | edac.rst | 13 creating a common ground for discussion, terms and their definitions
|
| D | pin-control.rst | 896 system sleep, we need to put this pin into "GPIO mode" and ground it.
|
| /Linux-v6.1/arch/arm64/boot/dts/rockchip/ |
| D | rk3399-gru.dtsi | 541 * hooked to ground. Because we specified "cd-gpios" below dw_mmc
796 * In our case the official card detect is hooked to ground
|
| /Linux-v6.1/Documentation/input/devices/ |
| D | joystick-parport.rst | 87 Ground is quite easy. On PC's parallel port the ground is on any of the
88 pins from pin 18 to pin 25. So use any pin of these you like for the ground::
|
| /Linux-v6.1/arch/arm64/boot/dts/exynos/ |
| D | exynos5433-tm2-common.dtsi | 393 samsung,s2mps11-wrstbi-ground;
|
| /Linux-v6.1/Documentation/process/ |
| D | applying-patches.rst | 414 The -mm patches serve as a sort of proving ground for new features and other
|
| D | howto.rst | 528 as a dumping ground for your feature. However, don't send 50 emails at
|
12
