| /Linux-v6.1/Documentation/devicetree/bindings/pci/ |
| D | spear13xx-pcie.txt | 14 - st,pcie-is-gen1 indicates that forced gen1 initialization is needed.
|
| /Linux-v6.1/tools/testing/selftests/rcutorture/doc/ |
| D | TINY_RCU.txt | 38 All forced by CONFIG_TINY_RCU.
|
| /Linux-v6.1/Documentation/ABI/stable/ |
| D | sysfs-class-rfkill | 64 transmitter is forced off by something outside of
78 The transmitter is forced off by something outside of
|
| /Linux-v6.1/drivers/mtd/nand/raw/ |
| D | nand_micron.c | 60 bool forced; member
172 if (micron->ecc.forced) in micron_nand_on_die_ecc_setup()
519 micron->ecc.forced = true; in micron_nand_init()
|
| /Linux-v6.1/arch/mips/vdso/ |
| D | Kconfig | 5 # of which we are forced to disable the VDSO symbols when building
|
| /Linux-v6.1/kernel/livepatch/ |
| D | transition.c | 659 klp_transition_patch->forced = true; in klp_force_transition()
663 patch->forced = true; in klp_force_transition()
|
| /Linux-v6.1/Documentation/networking/device_drivers/ethernet/ti/ |
| D | tlan.rst | 86 if a card which only supports 10Mbs is forced into 100Mbs
123 Now eth0 will use auto-neg and eth1 will be forced to 100Mbit/HD.
|
| /Linux-v6.1/Documentation/driver-api/mmc/ |
| D | mmc-dev-parts.rst | 21 To enable write access to /dev/mmcblkXbootY, disable the forced read-only
|
| /Linux-v6.1/arch/m68k/fpsp040/ |
| D | res_func.S | 474 | If bit 2 is set, round is forced to double. If it is clear,
475 | and bit 6 is set, round is forced to single. If both are clear,
486 | The move or operation is not with forced precision. Use the
766 btstl #6,%d0 |test for forced precision
770 movel #0x1,%d0 |inst is forced single
773 movel #0x2,%d0 |inst is forced double
776 bfextu FPCR_MODE(%a6){#0:#2},%d0 |inst not forced - use fpcr prec
1234 btstl #6,%d0 |test for forced precision
1238 movel #0x1,%d0 |inst is forced single
1241 movel #0x2,%d0 |inst is forced double
[all …]
|
| /Linux-v6.1/include/linux/ |
| D | livepatch.h | 169 bool forced; member
|
| /Linux-v6.1/arch/sparc/kernel/ |
| D | syscalls.S | 231 5: call %l7 ! CTI Group brk forced
255 2: call %l7 ! CTI Group brk forced
|
| /Linux-v6.1/Documentation/admin-guide/hw-vuln/ |
| D | core-scheduling.rst | 115 then the sibling is considered to be in a `forced idle` state. I.e., it may
125 siblings could be forced to select a lower priority task if the highest
127 task. If a sibling does not have a trusted task to run, it will be forced idle
157 and are considered system-wide trusted. The forced-idling of siblings running
|
| /Linux-v6.1/Documentation/ABI/testing/ |
| D | sysfs-bus-pci-drivers-ehci_hcd | 32 Reading the file gives the list of ports currently forced
|
| /Linux-v6.1/Documentation/mm/damon/ |
| D | faq.rst | 49 regions size is forced to be ``>=page size``, the region split will make no
|
| /Linux-v6.1/drivers/scsi/aacraid/ |
| D | commsup.c | 1476 static int _aac_reset_adapter(struct aac_dev *aac, int forced, u8 reset_type) in _aac_reset_adapter() argument
1508 bled = forced ? 0 : aac_adapter_check_health(aac); in _aac_reset_adapter()
1628 int aac_reset_adapter(struct aac_dev *aac, int forced, u8 reset_type) in aac_reset_adapter() argument
1653 if (forced < 2) in aac_reset_adapter()
1656 bled = forced ? forced : in aac_reset_adapter()
1664 if ((forced < 2) && (retval == -ENODEV)) { in aac_reset_adapter()
|
| /Linux-v6.1/Documentation/devicetree/bindings/mfd/ |
| D | qcom-rpm.txt | 200 Definition: indicates that the regulator should be forced to a
226 Definition: indicates that the regulator should not be forced to any
|
| /Linux-v6.1/Documentation/devicetree/bindings/regulator/ |
| D | palmas-pmic.txt | 49 2 - eco, 3 - forced pwm
|
| /Linux-v6.1/Documentation/hwmon/ |
| D | thmc50.rst | 66 A typical symptom of wrong setting is a fan forced to full speed.
|
| /Linux-v6.1/kernel/irq/ |
| D | Kconfig | 111 # Support forced irq threading
|
| /Linux-v6.1/kernel/module/ |
| D | main.c | 664 static int try_stop_module(struct module *mod, int flags, int *forced) in try_stop_module() argument
668 *forced = try_force_unload(flags); in try_stop_module()
669 if (!(*forced)) in try_stop_module()
702 int ret, forced = 0; in SYSCALL_DEFINE2() local
738 forced = try_force_unload(flags); in SYSCALL_DEFINE2()
739 if (!forced) { in SYSCALL_DEFINE2()
746 ret = try_stop_module(mod, flags, &forced); in SYSCALL_DEFINE2()
|
| /Linux-v6.1/Documentation/kbuild/ |
| D | kconfig.rst | 80 that are to be forced. If this file is not found, it checks for a
81 file named "all.config" to contain forced values.
|
| /Linux-v6.1/Documentation/devicetree/bindings/net/ |
| D | keystone-netcp.txt | 100 - mac<->mac forced mode: 2
104 - 10Gb mac<->mac forced mode : 11
|
| /Linux-v6.1/drivers/opp/ |
| D | core.c | 1068 struct dev_pm_opp *opp, void *clk_data, bool forced) in _set_opp() argument
1083 if (!forced && old_opp == opp && opp_table->enabled) { in _set_opp()
1181 bool forced = false; in dev_pm_opp_set_rate() local
1229 forced = opp_table->rate_clk_single != target_freq; in dev_pm_opp_set_rate()
1232 ret = _set_opp(dev, opp_table, opp, &target_freq, forced); in dev_pm_opp_set_rate()
|
| /Linux-v6.1/drivers/firmware/ |
| D | qcom_scm.c | 162 bool forced = false; in __get_convention() local
184 forced = true; in __get_convention()
200 forced ? " (forced)" : ""); in __get_convention()
|
| /Linux-v6.1/Documentation/block/ |
| D | writeback_cache_control.rst | 17 a forced cache flush, and the Force Unit Access (FUA) flag for requests.
|
