| /Linux-v6.1/net/core/ |
| D | failover.c | 23 struct failover *failover; in failover_get_bymac() local
26 list_for_each_entry(failover, &failover_list, list) { in failover_get_bymac()
27 failover_dev = rtnl_dereference(failover->failover_dev); in failover_get_bymac()
29 *ops = rtnl_dereference(failover->ops); in failover_get_bymac()
242 struct failover *failover_register(struct net_device *dev, in failover_register()
245 struct failover *failover; in failover_register() local
250 failover = kzalloc(sizeof(*failover), GFP_KERNEL); in failover_register()
251 if (!failover) in failover_register()
254 rcu_assign_pointer(failover->ops, ops); in failover_register()
255 netdev_hold(dev, &failover->dev_tracker, GFP_KERNEL); in failover_register()
[all …]
|
| D | Makefile | 38 obj-$(CONFIG_FAILOVER) += failover.o
|
| /Linux-v6.1/include/net/ |
| D | failover.h | 25 struct failover { struct
32 struct failover *failover_register(struct net_device *dev, argument
34 void failover_unregister(struct failover *failover);
|
| D | net_failover.h | 30 struct failover *net_failover_create(struct net_device *standby_dev);
31 void net_failover_destroy(struct failover *failover);
|
| /Linux-v6.1/Documentation/networking/ |
| D | net_failover.rst | 10 The net_failover driver provides an automated failover mechanism via APIs
11 to create and destroy a failover master netdev and manages a primary and
12 standby slave netdevs that get registered via the generic failover
15 The failover netdev acts a master device and controls 2 slave devices. The
18 netdev. Both 'standby' and 'failover' netdevs are associated with the same
19 'pci' device. The user accesses the network interface via 'failover' netdev.
20 The 'failover' netdev chooses 'primary' netdev as default for transmits when
63 virtio-net device is set to 'down' to ensure that the 'failover' netdev prefers
87 Here, ens10 is the 'failover' master interface, ens10nsby is the slave 'standby'
92 device; and on the first boot, the VM might end up with both 'failover' device
[all …]
|
| D | failover.rst | 10 The failover module provides a generic interface for paravirtual drivers
11 to register a netdev and a set of ops with a failover instance. The ops
14 with the same mac address as the failover netdev.
|
| D | index.rst | 25 failover
|
| D | xfrm_sync.rst | 20 with as minimal loss at failover time.
33 note that: lifetime time limit is not important if you assume the failover
|
| D | bonding.rst | 244 The bandwidth and count selection policies permit failover of
441 In order to provide orderly failover semantics, backup interfaces
478 address of the bond changes during a failover.
508 failover time (and the formerly active slave receives
608 In bonding version 2.6.2 or later, when a failover
750 failover event. As soon as the link is up on the new slave
777 Advertisement) when they are issued after a failover event.
1003 hash to load-balance traffic per-vlan, with failover
1021 a failover event. One membership report is issued immediately after
1022 the failover, subsequent packets are sent in each 200ms interval.
[all …]
|
| D | ip-sysctl.rst | 2691 https://datatracker.ietf.org/doc/draft-ietf-tsvwg-sctp-failover for
2796 setting is primarily used to enable fast failover mechanisms without
2798 http://www.ietf.org/id/draft-nishida-tsvwg-sctp-failover-05.txt
|
| /Linux-v6.1/drivers/net/ |
| D | net_failover.c | 710 struct failover *net_failover_create(struct net_device *standby_dev) in net_failover_create()
714 struct failover *failover; in net_failover_create() local
764 failover = failover_register(failover_dev, &net_failover_ops); in net_failover_create()
765 if (IS_ERR(failover)) { in net_failover_create()
766 err = PTR_ERR(failover); in net_failover_create()
770 return failover; in net_failover_create()
792 void net_failover_destroy(struct failover *failover) in net_failover_destroy() argument
798 if (!failover) in net_failover_destroy()
801 failover_dev = rcu_dereference(failover->failover_dev); in net_failover_destroy()
816 failover_unregister(failover); in net_failover_destroy()
|
| D | virtio_net.c | 286 struct failover *failover; member
3898 vi->failover = net_failover_create(vi->dev); in virtnet_probe()
3899 if (IS_ERR(vi->failover)) { in virtnet_probe()
3900 err = PTR_ERR(vi->failover); in virtnet_probe()
3954 net_failover_destroy(vi->failover); in virtnet_probe()
3990 net_failover_destroy(vi->failover); in virtnet_remove()
|
| D | Kconfig | 619 This provides an automated failover mechanism via APIs to create
620 and destroy a failover master netdev and manages a primary and
621 standby slave netdevs that get registered via the generic failover
|
| /Linux-v6.1/drivers/block/drbd/ |
| D | Kconfig | 37 For automatic failover you need a cluster manager (e.g. heartbeat).
|
| /Linux-v6.1/net/ |
| D | Kconfig | 449 tristate "Generic failover module"
451 The failover module provides a generic interface for paravirtual
452 drivers to register a netdev and a set of ops with a failover
456 failover netdev. This enables paravirtual drivers to use a
|
| /Linux-v6.1/Documentation/scsi/ |
| D | aacraid.rst | 155 - Performance tuning, card failover and bug mitigations.
|
| /Linux-v6.1/drivers/net/ethernet/marvell/ |
| D | Kconfig | 121 It does not support the link failover and network management
|
| /Linux-v6.1/Documentation/admin-guide/device-mapper/ |
| D | switch.rst | 59 failover reasons.
|
| /Linux-v6.1/net/netfilter/ipvs/ |
| D | Kconfig | 157 tristate "weighted failover scheduling"
159 The weighted failover scheduling algorithm directs network
|
| /Linux-v6.1/Documentation/admin-guide/ |
| D | xfs.rst | 209 where failover must not result in clients seeing
211 failover event.
|
| /Linux-v6.1/drivers/infiniband/ulp/rtrs/ |
| D | README | 31 between client and server. Those are used for load balancing and failover.
|
| /Linux-v6.1/Documentation/translations/it_IT/process/ |
| D | changes.rst | 318 implementare un *failover*. Anche quando il sistema funziona bene, ``rmtab``
|
| /Linux-v6.1/Documentation/admin-guide/sysctl/ |
| D | vm.rst | 825 1 and 2 are for failover of clustering. Please select either
826 according to your policy of failover.
|
| /Linux-v6.1/Documentation/networking/device_drivers/ethernet/mellanox/ |
| D | mlx5.rst | 193 metadata. Metadata tagging must be enabled for multi-port RoCE, failover
|
| /Linux-v6.1/drivers/net/ethernet/ibm/ |
| D | ibmvnic.c | 6273 static DEVICE_ATTR_WO(failover);
|
