Searched refs:exceed (Results 1 – 25 of 105) sorted by relevance
12345
/Linux-v6.1/tools/testing/selftests/drivers/net/mlxsw/ |
D | tc_restrictions.sh | 320 action police rate 0.5kbit burst 1m conform-exceed drop/ok 325 action police rate 2.5tbit burst 1g conform-exceed drop/ok 330 action police rate 1.5kbit burst 1m conform-exceed drop/ok 337 action police rate 1.9tbit burst 1g conform-exceed drop/ok 344 action police rate 1.5kbit burst 512b conform-exceed drop/ok 349 action police rate 1.5kbit burst 2k conform-exceed drop/ok 370 action police rate 100mbit burst 100k conform-exceed drop/ok 377 action police rate 100mbit burst 100k conform-exceed drop/pipe \ 378 action police rate 200mbit burst 200k conform-exceed drop/ok
|
D | tc_police_occ.sh | 72 action police rate 100mbit burst 100k conform-exceed drop/ok 82 action police rate 100mbit burst 100k conform-exceed drop/ok \
|
D | tc_police_scale.sh | 48 conform-exceed drop/ok
|
/Linux-v6.1/tools/testing/selftests/net/forwarding/ |
D | tc_police.sh | 160 action police rate 80mbit burst 16k conform-exceed drop/ok 172 action police rate 80mbit burst 16k conform-exceed drop/ok 214 action police rate 80mbit burst 16k conform-exceed drop/ok \ 253 action police rate 80mbit burst 16k conform-exceed drop/pipe \ 332 action police pkts_rate 2000 pkts_burst 400 conform-exceed drop/ok 344 action police pkts_rate 2000 pkts_burst 400 conform-exceed drop/ok 360 action police mtu 1042 conform-exceed drop/ok
|
/Linux-v6.1/arch/arm/boot/dts/ |
D | bcm283x-rpi-usb-otg.dtsi | 8 * fifo sizes shouldn't exceed 3776 bytes.
|
/Linux-v6.1/Documentation/devicetree/bindings/usb/ |
D | maxim,max3421.txt | 5 - spi-max-frequency: maximum frequency for this device must not exceed 26 MHz.
|
/Linux-v6.1/Documentation/ABI/testing/ |
D | sysfs-class-led-multicolor | 21 not exceed /sys/class/leds/<led>/max_brightness.
|
D | sysfs-class-net-cdc_ncm | 46 The maximum NTB size for RX. Cannot exceed the 62 The maximum NTB size for TX. Cannot exceed the
|
/Linux-v6.1/Documentation/admin-guide/ |
D | cputopology.rst | 62 HOTPLUGGED off or exceed the limit of CPUs allowed by the 78 In this example, there are 64 CPUs in the system but cpus 32-63 exceed
|
D | binfmt-misc.rst | 95 - the whole register string may not exceed 1920 characters 98 - the interpreter string may not exceed 127 characters
|
/Linux-v6.1/Documentation/filesystems/ |
D | quota.rst | 11 and the second one hardlimit. A user can never exceed a hardlimit for any 12 resource (unless he has CAP_SYS_RESOURCE capability). User is allowed to exceed
|
/Linux-v6.1/drivers/block/paride/ |
D | Transition-notes | 11 IOW, the sequence is A?(BA|BC|B)*. OTOH, number of B can not exceed 16 since at any time number of B can not exceed the number of these 17 moments which, in turn, can not exceed the number of A and C.
|
/Linux-v6.1/Documentation/hwmon/ |
D | tmp108.rst | 22 can be set when temperatures exceed minimum or maximum values plus or minus a
|
/Linux-v6.1/Documentation/s390/ |
D | 3270.ChangeLog | 11 * Oversize 3270 screen widths may exceed GEOM_MAXINPLEN columns,
|
/Linux-v6.1/Documentation/devicetree/bindings/mtd/ |
D | vf610-nfc.txt | 14 rate and should not exceed maximum timing for any NAND memory chip
|
/Linux-v6.1/drivers/net/ethernet/microchip/lan966x/ |
D | lan966x_police.c | 81 if (act->police.exceed.act_id != FLOW_ACTION_DROP) { in lan966x_police_validate()
|
/Linux-v6.1/drivers/net/ethernet/mscc/ |
D | ocelot_police.c | 165 if (a->police.exceed.act_id != FLOW_ACTION_DROP) { in ocelot_policer_validate()
|
/Linux-v6.1/Documentation/mm/ |
D | overcommit-accounting.rst | 22 system is not permitted to exceed swap + a configurable amount
|
/Linux-v6.1/net/sched/ |
D | act_police.c | 461 &entry->police.exceed.extval, in tcf_police_offload_act_setup() 466 entry->police.exceed.act_id = act_id; in tcf_police_offload_act_setup()
|
/Linux-v6.1/Documentation/networking/device_drivers/wwan/ |
D | iosm.rst | 56 The MBIM control messages from the management application must not exceed the
|
D | t7xx.rst | 64 The MBIM control messages from the management application must not exceed the
|
/Linux-v6.1/Documentation/infiniband/ |
D | user_verbs.rst | 55 unprivileged processes do not exceed their RLIMIT_MEMLOCK limit.
|
/Linux-v6.1/Documentation/admin-guide/sysctl/ |
D | fs.rst | 173 with writes enabled, any UID or GID that would exceed 65535 is translated 363 NULL. If it exceed msg_max, the default value is initialized msg_max. 367 exceed msgsize_max, the default value is initialized msgsize_max.
|
/Linux-v6.1/tools/testing/selftests/drivers/net/ocelot/ |
D | tc_flower_chains.sh | 175 action police rate 50mbit burst 64k conform-exceed drop/pipe \
|
/Linux-v6.1/Documentation/scsi/ |
D | ChangeLog.ips | 38 4.72.00 - Allow for a Scatter-Gather Element to exceed MAX_XFER Size
|
12345