| /Linux-v6.1/drivers/hwmon/ |
| D | raspberrypi-hwmon.c | 39 dev_err_once(data->hwmon_dev, "Failed to get throttled (%d)\n", in rpi_firmware_get_throttled()
|
| /Linux-v6.1/drivers/gpu/drm/amd/amdkfd/ |
| D | kfd_interrupt.c | 152 dev_err_once(dev->adev->dev, "Ring entry too small\n"); in interrupt_wq()
|
| D | kfd_device.c | 835 dev_err_once(kfd_device, "Ring entry too small\n"); in kgd2kfd_interrupt()
|
| /Linux-v6.1/drivers/tty/serial/ |
| D | sifive.c | 658 dev_err_once(ssp->port.dev, "only 8-bit words supported\n"); in sifive_serial_set_termios()
663 dev_err_once(ssp->port.dev, "parity checking not supported\n"); in sifive_serial_set_termios()
665 dev_err_once(ssp->port.dev, "BREAK detection not supported\n"); in sifive_serial_set_termios()
|
| /Linux-v6.1/drivers/acpi/ |
| D | evged.c | 63 dev_err_once(event->dev, "IRQ method execution failed\n"); in acpi_ged_irq_handler()
|
| /Linux-v6.1/drivers/net/wireless/mediatek/mt7601u/ |
| D | dma.c | 98 dev_err_once(dev->dev, "Error: RXWI zero fields are set\n"); in mt7601u_rx_process_seg()
100 dev_err_once(dev->dev, "Error: RX path seen a non-pkt urb\n"); in mt7601u_rx_process_seg()
|
| /Linux-v6.1/drivers/media/i2c/ |
| D | ak7375.c | 201 dev_err_once(dev, "%s I2C failure: %d\n", in ak7375_vcm_suspend()
|
| D | dw9807-vcm.c | 246 dev_err_once(dev, "%s I2C failure: %d", __func__, ret); in dw9807_vcm_suspend()
|
| D | dw9714.c | 231 dev_err_once(dev, "%s I2C failure: %d", __func__, ret); in dw9714_vcm_suspend()
|
| /Linux-v6.1/drivers/thermal/tegra/ |
| D | tegra30-tsensor.c | 178 dev_err_once(ts->dev, "ch%u: counter invalid\n", tsc->id); in tegra_tsensor_get_temp()
191 dev_err_once(ts->dev, "ch%u: counter overflow\n", tsc->id); in tegra_tsensor_get_temp()
|
| /Linux-v6.1/include/linux/ |
| D | dev_printk.h | 191 #define dev_err_once(dev, fmt, ...) \ macro
|
| D | hid.h | 1212 dev_err_once(&(hid)->dev, fmt, ##__VA_ARGS__)
|
| /Linux-v6.1/drivers/rtc/ |
| D | rtc-mxc_v2.c | 64 dev_err_once(dev, "SRTC_LPSCLR stuck! Check your hw.\n"); in mxc_rtc_sync_lp_locked()
|
| /Linux-v6.1/drivers/gpu/drm/tiny/ |
| D | st7586.c | 148 dev_err_once(fb->dev->dev, "Failed to update display %d\n", ret); in st7586_fb_dirty()
|
| D | ili9225.c | 157 dev_err_once(fb->dev->dev, "Failed to update display %d\n", ret); in ili9225_fb_dirty()
|
| /Linux-v6.1/drivers/gpu/drm/msm/adreno/ |
| D | adreno_device.c | 419 dev_err_once(dev->dev, "no GPU device was found\n"); in adreno_load_gpu()
|
| /Linux-v6.1/drivers/acpi/nfit/ |
| D | intel.c | 504 dev_err_once(dev, "invalid firmware activate state %d\n", in intel_bus_fwa_state()
|
| /Linux-v6.1/drivers/media/cec/platform/seco/ |
| D | seco-cec.c | 487 dev_err_once(dev, "IRQ: R/W SMBus operation failed %d\n", status); in secocec_irq_handler()
|
| /Linux-v6.1/drivers/gpu/drm/gud/ |
| D | gud_drv.c | 174 dev_err_once(gdrm->drm.dev, in gud_usb_transfer()
|
| /Linux-v6.1/kernel/dma/ |
| D | direct.c | 526 dev_err_once(dev, in dma_direct_map_resource()
|
| /Linux-v6.1/drivers/platform/chrome/ |
| D | cros_ec_proto.c | 126 dev_err_once(ec_dev->dev, "missing EC transfer API, cannot send command\n"); in cros_ec_xfer_command()
|
| /Linux-v6.1/drivers/net/ethernet/amd/xgbe/ |
| D | xgbe-phy-v2.c | 1253 dev_err_once(pdata->dev, "%s: I2C error setting SFP MUX\n", in xgbe_phy_sfp_read_eeprom()
1264 dev_err_once(pdata->dev, "%s: I2C error reading SFP EEPROM\n", in xgbe_phy_sfp_read_eeprom()
1316 dev_err_once(pdata->dev, "%s: I2C error reading SFP GPIOs\n", in xgbe_phy_sfp_signals()
|
| /Linux-v6.1/sound/soc/atmel/ |
| D | mchp-i2s-mcc.c | 843 dev_err_once(dev->dev, "failed to enable GCLK: %d\n", in mchp_i2s_mcc_trigger()
|
| /Linux-v6.1/sound/soc/sof/intel/ |
| D | hda-stream.c | 1089 dev_err_once(sdev->dev, "hda_position_quirk value %d not supported\n", in hda_dsp_stream_get_position()
|
| /Linux-v6.1/drivers/scsi/cxlflash/ |
| D | ocxl_hw.c | 446 dev_err_once(dev, "%s: afu_reset() fop not supported\n", __func__); in ocxlflash_afu_reset()
|
