Home
last modified time | relevance | path

Searched refs:cle (Results 1 – 25 of 31) sorted by relevance

12

/Linux-v6.1/drivers/net/ethernet/apm/xgene/
Dxgene_enet_cle.c123 static int xgene_cle_dram_wr(struct xgene_enet_cle *cle, u32 *data, u8 nregs, in xgene_cle_dram_wr() argument
127 enum xgene_cle_parser parser = cle->active_parser; in xgene_cle_dram_wr()
128 void __iomem *base = cle->base; in xgene_cle_dram_wr()
134 nparsers = (type >= PTREE_RAM) ? 1 : cle->parsers; in xgene_cle_dram_wr()
156 struct xgene_enet_cle *cle) in xgene_cle_enable_ptree() argument
158 struct xgene_cle_ptree *ptree = &cle->ptree; in xgene_cle_enable_ptree()
159 void __iomem *addr, *base = cle->base; in xgene_cle_enable_ptree()
164 ptree->start_pkt += cle->jump_bytes; in xgene_cle_enable_ptree()
165 for (i = 0; i < cle->parsers; i++) { in xgene_cle_enable_ptree()
166 if (cle->active_parser != PARSER_ALL) in xgene_cle_enable_ptree()
[all …]
Dxgene_enet_main.h213 struct xgene_enet_cle cle; member
/Linux-v6.1/drivers/mtd/nand/raw/
Dgpio.c37 struct gpio_desc *cle; member
84 gpiod_set_value(gpiomtd->cle, 1); in gpio_nand_exec_instr()
88 gpiod_set_value(gpiomtd->cle, 0); in gpio_nand_exec_instr()
338 gpiomtd->cle = devm_gpiod_get(dev, "cle", GPIOD_OUT_LOW); in gpio_nand_probe()
339 if (IS_ERR(gpiomtd->cle)) { in gpio_nand_probe()
340 ret = PTR_ERR(gpiomtd->cle); in gpio_nand_probe()
Dorion_nand.c40 offs = (1 << board->cle); in orion_nand_cmd_ctrl()
134 board->cle = (u8)val; in orion_nand_probe()
136 board->cle = 0; in orion_nand_probe()
Dnandsim.c347 int cle; /* command Latch Enable */ member
1873 if (ns->lines.ale || ns->lines.cle) { in ns_nand_read_byte()
1933 if (ns->lines.ale && ns->lines.cle) { in ns_nand_write_byte()
1938 if (ns->lines.cle == 1) { in ns_nand_write_byte()
2118 if (ns->lines.ale || ns->lines.cle) { in ns_nand_read_buf()
2170 ns->lines.cle = 0; in ns_exec_op()
2175 ns->lines.cle = 1; in ns_exec_op()
Drenesas-nand-controller.c896 unsigned int cyc, cle, ale, bef_dly, ca_to_data; in rnandc_setup_interface() local
924 cle = sdr->tCLH_min + sdr->tCLS_min; in rnandc_setup_interface()
936 TIM_GEN_SEQ0_D0(TO_CYCLES64(cle - cyc, period_ns)) | in rnandc_setup_interface()
937 TIM_GEN_SEQ0_D1(TO_CYCLES64(cle - cyc, period_ns)) | in rnandc_setup_interface()
962 TIM_GEN_SEQ2_D10(TO_CYCLES64(cle - cyc, period_ns)) | in rnandc_setup_interface()
/Linux-v6.1/Documentation/devicetree/bindings/mtd/
Dorion-nand.txt9 - cle : Address line number connected to CLE. Default is 0
23 cle = <0>;
Ddavinci-nand.txt33 - ti,davinci-mask-cle: mask for CLE. Needed for executing command
84 ti,davinci-mask-cle = <0>;
Datmel-nand.txt180 atmel,nand-cmd-offset = <22>; /* cle */
203 atmel,nand-cmd-offset = <22>; /* cle */
/Linux-v6.1/Documentation/devicetree/bindings/pinctrl/
Dlantiq,pinctrl-xway.txt51 ebu wait, nand ale, nand cs1, nand cle, spi, spi_cs1, spi_cs2, spi_cs3,
62 ebu clk, ebu cs1, ebu wait, nand ale, nand cs1, nand cle, nand rdy,
83 ebu wait, nand ale, nand cs1, nand cle, spi_di, spi_do, spi_clk, spi_cs1,
94 ebu cs1, ebu wait, nand ale, nand cs1, nand cle, nand rdy, nand rd,
106 ebu cs1, ebu wait, nand ale, nand cs1, nand cle, nand rdy, nand rd,
120 exin0, exin1, exin2, exin4, nand ale, nand cs0, nand cs1, nand cle,
/Linux-v6.1/include/linux/platform_data/
Dmtd-orion_nand.h17 u8 cle; /* address line number connected to CLE */ member
/Linux-v6.1/arch/mips/boot/dts/ni/
D169445.dts70 <&gpio1 3 0>, /* cle */
/Linux-v6.1/arch/arm/boot/dts/
Dkeystone-k2l-evm.dts86 ti,davinci-mask-cle = <0x4000>;
Dkeystone-k2e-evm.dts113 ti,davinci-mask-cle = <0x4000>;
Dkeystone-k2hk-evm.dts130 ti,davinci-mask-cle = <0x4000>;
Dorion5x-kuroboxpro.dts87 cle = <0>;
Dda850-lcdk.dts355 ti,davinci-mask-cle = <0>;
Dda850-evm.dts436 ti,davinci-mask-cle = <0>;
Dkirkwood.dtsi48 cle = <0>;
/Linux-v6.1/arch/arm/mach-orion5x/
Ddb88f5281-setup.c149 .cle = 0,
Dkurobox_pro-setup.c75 .cle = 0,
/Linux-v6.1/arch/mips/boot/dts/ingenic/
Drs90.dts210 groups = "nand-cs1", "nand-cle-ale", "nand-fre-fwe";
Dci20.dts535 groups = "nemc-data", "nemc-cle-ale", "nemc-rd-we", "nemc-frd-fwe";
/Linux-v6.1/arch/powerpc/boot/dts/
Dxpedite5200.dts431 cle-line = <0x8>; /* CLE tied to A3 */
Dxpedite5200_xmon.dts435 cle-line = <0x8>; /* CLE tied to A3 */

12