| /Linux-v6.1/arch/arm/boot/dts/ |
| D | at91-natte.dtsi | 71 ti,charge-current = <2000>;
72 ti,charge-voltage = <16800>;
87 ti,charge-current = <2000>;
88 ti,charge-voltage = <16800>;
103 ti,charge-current = <2000>;
104 ti,charge-voltage = <16800>;
119 ti,charge-current = <2000>;
120 ti,charge-voltage = <16800>;
135 ti,charge-current = <2000>;
136 ti,charge-voltage = <16800>;
[all …]
|
| D | qcom-msm8974-sony-xperia-rhine-amami.dts | 10 qcom,fast-charge-safe-current = <1300000>;
11 qcom,fast-charge-current-limit = <1300000>;
|
| D | qcom-apq8026-asus-sparrow.dts | 250 qcom,fast-charge-safe-current = <1500000>;
251 qcom,fast-charge-current-limit = <350000>;
252 qcom,fast-charge-safe-voltage = <4430000>;
253 qcom,fast-charge-high-threshold-voltage = <4400000>;
|
| D | qcom-msm8974pro-fairphone-fp2.dts | 401 usb-charge-current-limit = <1500000>;
402 qcom,fast-charge-safe-current = <1500000>;
403 qcom,fast-charge-current-limit = <1500000>;
404 qcom,fast-charge-safe-voltage = <4380000>;
405 qcom,fast-charge-high-threshold-voltage = <4350000>;
|
| D | qcom-msm8974-sony-xperia-rhine.dtsi | 434 qcom,fast-charge-safe-current = <1500000>;
435 qcom,fast-charge-current-limit = <1500000>;
437 qcom,fast-charge-safe-voltage = <4400000>;
438 qcom,fast-charge-high-threshold-voltage = <4350000>;
439 qcom,fast-charge-low-threshold-voltage = <3400000>;
|
| D | qcom-apq8026-lg-lenok.dts | 278 qcom,fast-charge-safe-current = <450000>;
279 qcom,fast-charge-current-limit = <400000>;
280 qcom,fast-charge-safe-voltage = <4350000>;
281 qcom,fast-charge-high-threshold-voltage = <4350000>;
|
| D | qcom-msm8974pro-sony-xperia-shinano-castor.dts | 540 qcom,fast-charge-safe-current = <1500000>;
541 qcom,fast-charge-current-limit = <1500000>;
543 qcom,fast-charge-safe-voltage = <4400000>;
544 qcom,fast-charge-high-threshold-voltage = <4350000>;
545 qcom,fast-charge-low-threshold-voltage = <3400000>;
|
| /Linux-v6.1/drivers/macintosh/ |
| D | apm_emu.c | 25 long charge = -1; in pmu_apm_get_power_status() local
43 if (charge < 0) in pmu_apm_get_power_status()
44 charge = 0; in pmu_apm_get_power_status()
45 percentage += (pmu_batteries[i].charge * 100) / in pmu_apm_get_power_status()
47 charge += pmu_batteries[i].charge; in pmu_apm_get_power_status()
62 time_units = (charge * 59) / (amperage * -1); in pmu_apm_get_power_status()
64 time_units = (charge * 16440) / (amperage * -60); in pmu_apm_get_power_status()
|
| /Linux-v6.1/Documentation/power/ |
| D | power_supply_class.rst | 63 | **Because both "charge" (µAh) and "energy" (µWh) represents "capacity" |
88 batteries can typically charge at different rates.
125 design charge values, when battery considered full/empty.
131 These attributes means "last remembered value of charge when battery
132 became full/empty". It also could mean "value of charge when battery
140 the current charge counter (in µAh). This could easily
145 the maximum charge current during precharge phase of charge cycle
149 Charge termination current. The charge cycle terminates when battery
150 voltage is above recharge threshold, and charge current is below
154 constant charge current programmed by charger.
[all …]
|
| /Linux-v6.1/Documentation/ABI/testing/ |
| D | sysfs-driver-samsung-laptop | 27 Description: Max battery charge level can be modified, battery cycle
28 life can be extended by reducing the max battery charge
31 - 0 means normal battery mode (100% charge)
32 - 1 means battery life extender mode (80% charge)
38 Description: Use your USB ports to charge devices, even
|
| D | sysfs-bus-i2c-devices-bq32k | 5 Description: Attribute for enable/disable the trickle charge bypass
7 enable/disable the Trickle charge FET bypass.
|
| D | sysfs-class-power | 335 Maximum allowable charging current. Used for charge rate
383 algorithm to adjust the charge rate dynamically, without
430 for a battery charge cycle.
476 inhibit-charge: Do not charge while AC is attached
509 Reports the number of full charge + discharge cycles the
629 charger operates in fast-charge mode. When the timer expires
630 the device will terminate fast-charge mode (charging current
644 charger operates in fast-charge mode. When the timer expires
645 the device will terminate fast-charge mode (charging current
660 charge mode drops below this value, the charger will trigger
[all …]
|
| /Linux-v6.1/arch/arm/mach-pxa/ |
| D | sharpsl_pm.c | 306 sharpsl_pm.machinfo->charge(0); in sharpsl_charge_off()
316 sharpsl_pm.machinfo->charge(0); in sharpsl_charge_error()
333 sharpsl_pm.machinfo->charge(0); in sharpsl_charge_toggle()
335 sharpsl_pm.machinfo->charge(1); in sharpsl_charge_toggle()
525 sharpsl_pm.machinfo->charge(0); in sharpsl_check_battery_voltage()
687 sharpsl_pm.machinfo->charge(0); in sharpsl_off_charge_error()
713 sharpsl_pm.machinfo->charge(0); in sharpsl_off_charge_battery()
715 sharpsl_pm.machinfo->charge(1); in sharpsl_off_charge_battery()
733 sharpsl_pm.machinfo->charge(0); in sharpsl_off_charge_battery()
735 sharpsl_pm.machinfo->charge(1); in sharpsl_off_charge_battery()
[all …]
|
| D | corgi_pm.c | 108 sharpsl_pm.machinfo->charge(0); in corgi_should_wakeup()
164 .charge = corgi_charge,
|
| D | spitz_pm.c | 142 sharpsl_pm.machinfo->charge(0); in spitz_should_wakeup()
200 .charge = spitz_charge,
|
| /Linux-v6.1/Documentation/devicetree/bindings/rtc/ |
| D | rtc-palmas.txt | 16 - ti,backup-battery-charge-high-current: Enable high current charging in
19 charge battery to lower current i.e. < 100uA.
29 ti,backup-battery-charge-high-current;
|
| /Linux-v6.1/Documentation/devicetree/bindings/power/supply/ |
| D | max8925_battery.txt | 7 - fast-charge: set charging current in fast mode
15 fast-charge = <7>;
|
| /Linux-v6.1/Documentation/devicetree/bindings/sound/ |
| D | ti,tas5086.txt | 14 - ti,charge-period: This property should contain the time in microseconds
16 split-capacitor charge period. The hardware chip
44 ti,charge-period = <156000>;
|
| /Linux-v6.1/Documentation/admin-guide/laptops/ |
| D | lg-laptop.rst | 42 sets the maximum capacity to charge the battery. Limiting the charge
55 USB charge
|
| /Linux-v6.1/arch/arm64/boot/dts/sprd/ |
| D | sp9860g-1h10.dts | 45 charge-full-design-microamp-hours = <1900000>;
46 charge-term-current-microamp = <120000>;
|
| /Linux-v6.1/drivers/power/supply/ |
| D | ltc2941-battery-gauge.c | 77 int charge; /* Last charge register content */ member
415 int charge = ltc294x_read_charge_register(info, LTC294X_REG_ACC_CHARGE_MSB); in ltc294x_update() local
417 if (charge != info->charge) { in ltc294x_update()
418 info->charge = charge; in ltc294x_update()
|
| D | wm8350_power.c | 160 char *charge; in charger_state_show() local
167 charge = "Charger Off"; in charger_state_show()
170 charge = "Trickle Charging"; in charger_state_show()
173 charge = "Fast Charging"; in charger_state_show()
179 return sprintf(buf, "%s\n", charge); in charger_state_show()
|
| /Linux-v6.1/Documentation/devicetree/bindings/input/touchscreen/ |
| D | imx6ul_tsc.txt | 18 - pre-charge-time: the touch screen need some time to precharge.
36 pre-charge-time = <0xffff>;
|
| /Linux-v6.1/Documentation/devicetree/bindings/input/ |
| D | microchip,qt1050.txt | 33 - microchip,pre-charge-time-ns:
62 microchip,pre-charge-time-ns = <10000>;
|
| /Linux-v6.1/arch/arm64/boot/dts/freescale/ |
| D | imx8mq-librem5-r2.dts | 17 ti,charge-current = <1600000>; /* uA */
|
