Searched refs:auxiliary (Results 1 – 25 of 101) sorted by relevance
12345
| /Linux-v6.1/Documentation/driver-api/ |
| D | auxiliary_bus.rst | 9 .. kernel-doc:: drivers/base/auxiliary.c
15 .. kernel-doc:: drivers/base/auxiliary.c
25 .. kernel-doc:: drivers/base/auxiliary.c
42 .. kernel-doc:: drivers/base/auxiliary.c
48 .. kernel-doc:: drivers/base/auxiliary.c
|
| /Linux-v6.1/Documentation/ABI/testing/ |
| D | sysfs-driver-intel_sdsi | 1 What: /sys/bus/auxiliary/devices/intel_vsec.sdsi.X
30 What: /sys/bus/auxiliary/devices/intel_vsec.sdsi.X/guid
40 What: /sys/bus/auxiliary/devices/intel_vsec.sdsi.X/registers
51 What: /sys/bus/auxiliary/devices/intel_vsec.sdsi.X/provision_akc
60 What: /sys/bus/auxiliary/devices/intel_vsec.sdsi.X/provision_cap
72 What: /sys/bus/auxiliary/devices/intel_vsec.sdsi.X/state_certificate
|
| /Linux-v6.1/Documentation/devicetree/bindings/clock/ |
| D | brcm,bcm2835-aux-clock.txt | 1 Broadcom BCM2835 auxiliary peripheral support
6 The auxiliary peripherals (UART, SPI1, and SPI2) have a small register
|
| /Linux-v6.1/drivers/ata/ |
| D | libata-sata.c | 174 fis[16] = tf->auxiliary & 0xff; in ata_tf_to_fis()
175 fis[17] = (tf->auxiliary >> 8) & 0xff; in ata_tf_to_fis()
176 fis[18] = (tf->auxiliary >> 16) & 0xff; in ata_tf_to_fis()
177 fis[19] = (tf->auxiliary >> 24) & 0xff; in ata_tf_to_fis()
1396 tf->auxiliary = buf[14] << 16 | buf[15] << 8 | buf[16]; in ata_eh_read_log_10h()
1460 ((qc->result_tf.status & ATA_SENSE) || qc->result_tf.auxiliary)) { in ata_eh_analyze_ncq_error()
1463 sense_key = (qc->result_tf.auxiliary >> 16) & 0xff; in ata_eh_analyze_ncq_error()
1464 asc = (qc->result_tf.auxiliary >> 8) & 0xff; in ata_eh_analyze_ncq_error()
1465 ascq = qc->result_tf.auxiliary & 0xff; in ata_eh_analyze_ncq_error()
|
| /Linux-v6.1/Documentation/watchdog/ |
| D | mlx-wdt.rst | 40 Mellanox system can have 2 watchdogs: main and auxiliary.
41 Main and auxiliary watchdog devices can be enabled together
46 Actions without reset are provided for auxiliary watchdog device,
|
| /Linux-v6.1/Documentation/x86/ |
| D | elf_auxvec.rst | 7 This document describes the semantics of the x86 auxiliary vectors.
40 The exposed auxiliary vectors
|
| /Linux-v6.1/Documentation/networking/devlink/ |
| D | mlxsw.rst | 61 Line card auxiliary device info versions
64 The ``mlxsw`` driver reports the following versions for line card auxiliary device
|
| D | devlink-params.rst | 103 auxiliary device of the devlink device.
107 auxiliary device of the devlink device.
111 specific auxiliary device of the devlink device.
|
| /Linux-v6.1/arch/arm/boot/dts/ |
| D | bcm2711-rpi-400.dts | 10 /* 8250 auxiliary UART instead of pl011 */
|
| D | bcm2835-rpi-zero-w.dts | 22 /* 8250 auxiliary UART instead of pl011 */
|
| /Linux-v6.1/drivers/s390/block/ |
| D | dasd_fba.h | 37 __u8 auxiliary; member
|
| /Linux-v6.1/security/safesetid/ |
| D | Kconfig | 11 the given UIDs/GIDs from obtaining auxiliary privileges associated
|
| /Linux-v6.1/Documentation/devicetree/bindings/spi/ |
| D | brcm,bcm2835-spi.txt | 5 auxiliary block. This binding applies to the SPI0 controller.
|
| D | brcm,bcm2835-aux-spi.txt | 5 auxiliary block. This binding applies to the SPI1/2 controller.
|
| /Linux-v6.1/Documentation/devicetree/bindings/sound/ |
| D | nokia,rx51.txt | 7 auxiliary TLV320AIC3X node (in this order)
|
| /Linux-v6.1/drivers/base/ |
| D | Makefile | 10 obj-$(CONFIG_AUXILIARY_BUS) += auxiliary.o
|
| /Linux-v6.1/arch/arm/mm/ |
| D | proc-xsc3.S | 420 mrc p15, 0, r8, c1, c0, 1 @ auxiliary control reg
440 mcr p15, 0, r8, c1, c0, 1 @ auxiliary control reg
460 mrc p15, 0, r0, c1, c0, 1 @ get auxiliary control reg
463 mcr p15, 0, r0, c1, c0, 1 @ set auxiliary control reg
|
| /Linux-v6.1/Documentation/devicetree/bindings/arm/msm/ |
| D | qcom,kpss-gcc.txt | 34 an L2 cache auxiliary clock.
|
| /Linux-v6.1/drivers/peci/ |
| D | Kconfig | 24 responsible for creating auxiliary devices that can subsequently
|
| /Linux-v6.1/drivers/reset/ |
| D | reset-mpfs.c | 145 MODULE_DEVICE_TABLE(auxiliary, mpfs_reset_ids);
|
| /Linux-v6.1/drivers/net/ethernet/mellanox/mlx5/core/sf/dev/ |
| D | driver.c | 85 MODULE_DEVICE_TABLE(auxiliary, mlx5_sf_dev_id_table);
|
| /Linux-v6.1/Documentation/networking/device_drivers/ethernet/mellanox/ |
| D | mlx5.rst | 306 | (mlx5_core) | | auxiliary dev | | (mlx5_core) |
414 it and instantiate the devlink instance and class specific auxiliary devices
417 - Show the auxiliary device and port of the subfunction::
420 devlink dev show auxiliary/mlx5_core.sf.4
422 $ devlink port show auxiliary/mlx5_core.sf.4/1
423 auxiliary/mlx5_core.sf.4/1: type eth netdev p0sf88 flavour virtual port 0 splittable false
432 - Subfunction auxiliary device and class device hierarchy::
435 (subfunction auxiliary device)
449 auxiliary device of the subfunction. This results in changing the operational
|
| /Linux-v6.1/drivers/platform/x86/intel/pmt/ |
| D | telemetry.c | 139 MODULE_DEVICE_TABLE(auxiliary, pmt_telem_id_table);
|
| /Linux-v6.1/Documentation/admin-guide/device-mapper/ |
| D | statistics.rst | 99 An optional parameter. A word that provides auxiliary data
191 Store auxiliary data aux_data for the specified region.
210 Set the auxiliary data string to "foo bar baz" (the escape for each
|
| /Linux-v6.1/Documentation/hwmon/ |
| D | ltc2992.rst | 23 the input voltages and four auxiliary external voltages.
|
12345
