Searched refs:autodetected (Results 1 – 18 of 18) sorted by relevance
| /Linux-v6.1/arch/mips/alchemy/ |
| D | Kconfig | 23 Board type is autodetected during boot.
|
| /Linux-v6.1/Documentation/hwmon/ |
| D | corsair-cpro.rst | 24 Since it is a USB device, hotswapping is possible. The device is autodetected.
|
| D | nzxt-smart2.rst | 27 The device should be autodetected, and the driver should load automatically.
|
| /Linux-v6.1/Documentation/input/joydev/ |
| D | joystick.rst | 154 However the only types that can be autodetected are:
239 are autodetected, and thus no module parameters are needed.
268 ADI devices are autodetected, and the driver supports up to two (any
290 All these devices are autodetected, and you can even use any combination
309 All these devices are autodetected. Because the Assassin 3D and the Panther
333 TMDC devices are autodetected, and thus no parameters to the module
416 driver. Since they can't be autodetected, the driver has a command line:
|
| /Linux-v6.1/Documentation/admin-guide/media/ |
| D | cx88.rst | 40 34xxx models [card=1,autodetected]
|
| D | bt8xx.rst | 104 The autodetected values are determined by the cards' "response string".
|
| D | bttv.rst | 80 ID and therefore can't be autodetected. There is a list with the ID's
214 tda9850 = 1 The tea6300 can't be autodetected and is
473 - tuner type is autodetected
|
| /Linux-v6.1/Documentation/driver-api/media/drivers/ |
| D | bttv-devel.rst | 20 bttv0: model: BT848(Hauppauge old) [autodetected]
|
| D | zoran.rst | 60 Not autodetected, card=8 is necessary.
|
| /Linux-v6.1/Documentation/devicetree/bindings/net/ |
| D | micrel-ksz90x1.txt | 188 /* Attach to an Ethernet device with autodetected PHY */
|
| /Linux-v6.1/drivers/media/pci/saa7134/ |
| D | saa7134-core.c | 1112 dev->autodetected = card[dev->nr] != dev->board; in saa7134_initdev()
1123 dev->board, dev->autodetected ? in saa7134_initdev()
|
| D | saa7134.h | 555 int autodetected; member
|
| D | saa7134-cards.c | 7860 if (dev->autodetected && (dev->eedata[0x41] == 0x1c)) { in saa7134_board_init2()
7890 if (dev->autodetected && (dev->eedata[0x49] == 0x50)) { in saa7134_board_init2()
7907 if (dev->autodetected && (dev->eedata[0x27] == 0x03)) { in saa7134_board_init2()
8017 if (!dev->autodetected || (dev->eedata[0x41] == 0xd0)) in saa7134_board_init2()
|
| /Linux-v6.1/Documentation/fb/ |
| D | matroxfb.rst | 141 it is autodetected for intel's 82437. In this case device does
319 - Gxx0 SGRAM/SDRAM is not autodetected.
|
| /Linux-v6.1/Documentation/admin-guide/ |
| D | svga.rst | 125 0x0100. All VESA modes should be autodetected and shown on the menu.
|
| D | md.rst | 84 superblock can be autodetected and run at boot time.
|
| D | kernel-parameters.txt | 3464 will be autodetected by the client, and it will fall
|
| /Linux-v6.1/Documentation/m68k/ |
| D | kernel-options.rst | 910 controller and should be autodetected by the driver. An example is the
|
