Searched refs:OTP (Results 1 – 25 of 26) sorted by relevance
12
| /Linux-v6.1/drivers/nvmem/ |
| D | Kconfig | 39 tristate "Broadcom On-Chip OTP Controller support"
44 Say y here to enable read/write access to the Broadcom OTP
70 tristate "i.MX 6/7/8 On-Chip OTP Controller support"
74 This is a driver for the On-Chip OTP Controller (OCOTP) available on
82 tristate "i.MX8 SCU On-Chip OTP Controller support"
86 This is a driver for the SCU On-Chip OTP Controller (OCOTP)
102 tristate "Microchip LAN9662 OTP controller support"
106 This driver enables the OTP controller available on Microchip LAN9662
107 SoCs. It controls the access to the OTP memory connected to it.
133 tristate "NXP LPC18XX OTP Memory Support"
[all …]
|
| /Linux-v6.1/drivers/mtd/nand/onenand/ |
| D | Kconfig | 45 bool "OneNAND OTP Support"
49 Also, 1st Block of NAND Flash Array can be used as OTP.
51 The OTP block can be read, programmed and locked using the same
53 OTP block cannot be erased.
55 OTP block is fully-guaranteed to be a valid block.
|
| /Linux-v6.1/Documentation/devicetree/bindings/nvmem/ |
| D | vf610-ocotp.txt | 1 On-Chip OTP Memory for Freescale Vybrid
8 reg : Address and length of OTP controller and fuse map registers
|
| D | lpc1850-otp.txt | 1 * NXP LPC18xx OTP memory
3 Internal OTP (One Time Programmable) memory for NXP LPC18xx/43xx devices.
|
| D | brcm,ocotp.txt | 1 Broadcom OTP memory controller
8 - reg: Base address of the OTP controller.
|
| D | rockchip-otp.txt | 1 Rockchip internal OTP (One Time Programmable) memory device tree bindings
|
| /Linux-v6.1/drivers/misc/mchp_pci1xxxx/ |
| D | Kconfig | 2 tristate "Microchip PCI1XXXX PCIe to GPIO Expander + OTP/EEPROM manager"
10 which also has registers to interface with the OTP and EEPROM.
|
| /Linux-v6.1/Documentation/devicetree/bindings/regulator/ |
| D | palmas-pmic.txt | 3 The tps659038 for the AM57x class have OTP spins that
5 is not a need to add the OTP spins to the palmas driver. The
35 For ti,palmas-pmic - smps12, smps123, smps3 depending on OTP,
50 ti,smps-range - OTP has the wrong range set for the hardware so override
|
| /Linux-v6.1/Documentation/devicetree/bindings/net/ |
| D | microchip,lan78xx.txt | 3 The LAN78XX devices are usually configured by programming their OTP or with
5 The Device Tree properties, if present, override the OTP and EEPROM.
|
| /Linux-v6.1/Documentation/devicetree/bindings/watchdog/ |
| D | da9062-wdt.txt | 16 default chip's OTP setting for WATCHDOG_SD bit. If this property is NOT
18 chip's OTP settings.
|
| /Linux-v6.1/Documentation/hwmon/ |
| D | sht15.rst | 48 The humidity calibration coefficients are programmed into an OTP memory on the
67 flag to indicate not to reload from OTP (default to false).
|
| /Linux-v6.1/Documentation/ABI/testing/ |
| D | debugfs-turris-mox-rwtm | 9 device's OTP. The message must be exactly 64 bytes
|
| /Linux-v6.1/drivers/mtd/chips/ |
| D | Kconfig | 156 bool "Protection Registers aka one-time programmable (OTP) bits"
166 programmable (OTP) bits; when programmed, register bits cannot be
173 because the Lock Register bits themselves are OTP, when programmed,
178 in the programming of OTP bits will waste them.
|
| /Linux-v6.1/Documentation/devicetree/bindings/mfd/ |
| D | palmas.txt | 31 hardware, if not set will use muxing in OTP.
|
| D | da9062.txt | 35 modified to match the chip's OTP settings).
|
| /Linux-v6.1/Documentation/devicetree/bindings/input/ |
| D | ti,palmas-pwrbutton.txt | 18 NOTE: This depends on OTP support and POWERHOLD signal configuration
|
| /Linux-v6.1/Documentation/w1/slaves/ |
| D | w1_ds2406.rst | 15 These chips also provide 128 bytes of OTP EPROM, but reading/writing it is
|
| /Linux-v6.1/arch/arm/boot/dts/ |
| D | berlin2cd-valve-steamlink.dts | 42 * less depending on leakage value in OTP), and buck2 likely used for
|
| D | imx6q-gk802.dts | 61 /* SDMC DM2016 1024 bit EEPROM + 128 bit OTP */
|
| /Linux-v6.1/drivers/soc/amlogic/ |
| D | meson-secure-pwrc.c | 107 SEC_PD(OTP, 0),
|
| /Linux-v6.1/drivers/mtd/devices/ |
| D | Kconfig | 73 bool "DataFlash OTP support (Security Register)"
77 one-time-programmable (OTP) data. The first half may be written
|
| /Linux-v6.1/arch/powerpc/boot/dts/ |
| D | wii.dts | 227 * requires refactoring the PIC1, GPIO and OTP nodes
|
| /Linux-v6.1/include/linux/mfd/ |
| D | idt8a340_reg.h | 458 #define OTP 0xcf70 macro
|
| /Linux-v6.1/arch/arm64/boot/dts/nvidia/ |
| D | tegra210-smaug.dts | 1401 * set by OTP) and down properly.
|
| /Linux-v6.1/drivers/regulator/ |
| D | Kconfig | 881 reading the mux info from OTP.
|
12
