Searched refs:GNSS (Results 1 – 10 of 10) sorted by relevance
| /Linux-v6.1/drivers/gnss/ |
| D | Kconfig | 3 # GNSS receiver configuration
6 menuconfig GNSS config
7 tristate "GNSS receiver support"
9 Say Y here if you have a GNSS receiver (e.g. a GPS receiver).
14 if GNSS
20 tristate "Mediatek GNSS receiver support"
24 Say Y here if you have a Mediatek-based GNSS receiver which uses a
33 tristate "SiRFstar GNSS receiver support"
36 Say Y here if you have a SiRFstar-based GNSS receiver which uses a
45 tristate "u-blox GNSS receiver support"
[all …]
|
| /Linux-v6.1/Documentation/ABI/testing/ |
| D | sysfs-timecard | 23 TOD adjustments from the GNSS/TOD module
60 GNSS1 output PPS is from the first GNSS module
61 GNSS2 output PPS is from the second GNSS module
173 Description: (RO) Indicates whether a valid GNSS signal is received,
236 Description: (RW) The incoming GNSS signal is in UTC time, and the NMEA
266 associated with the GNSS devices.
|
| D | sysfs-class-gnss | 6 The GNSS receiver type. The currently identified types reflect
|
| /Linux-v6.1/Documentation/driver-api/ |
| D | ptp.rst | 108 … - Lock to GNSS input, automatic switching between GNSS and user-space PHC control (optional)
|
| /Linux-v6.1/drivers/net/ethernet/intel/ice/ |
| D | ice_ptp.h | 21 GNSS = 0, enumerator
|
| D | ice_ptp.c | 14 { "GNSS", GNSS, PTP_PF_EXTTS, 0, { 0, } },
248 if (pin == UFL2 || pin == GNSS) in ice_verify_pin_e810t()
|
| /Linux-v6.1/Documentation/networking/device_drivers/ethernet/intel/ |
| D | ice.rst | 904 GNSS module
906 Allows user to read messages from the GNSS module and write supported commands.
910 The protocol of write commands is dependent on the GNSS module as the driver
911 writes raw bytes from the TTY to the GNSS i2c. Please refer to the module
|
| /Linux-v6.1/arch/arm64/boot/dts/freescale/ |
| D | imx8mq-librem5-devkit.dts | 956 &uart3 { /* GNSS */
|
| D | imx8mq-librem5.dtsi | 132 regulator-name = "GNSS";
|
| /Linux-v6.1/ |
| D | MAINTAINERS | 8686 GNSS SUBSYSTEM
|
